TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
MK3004GAH (HDD1384)
1.8-INCH HARD DISK DRIVE
USER MANUAL
Rev 02
11/2006
CONTENTS
Introduction..............................................................................1
Setup ........................................................................................2
Using the HDD .........................................................................3
Specifications ..........................................................................4
Drive Connectors.....................................................................6
INTRODUCTION – MK3004GAH (HDD1384) HARD DISK DRIVE
General Features
• 1.8" sized drive
• 2 Platter
• 30 Gigabytes*
• 8mm High
• 15ms Average Seek Time
• ATA (2 - 5) Interface
• Ultra DMA 100
• 512KB Buffer
• Rotational speed of 4,200rpm
• MTTF 300,000 Hours
*Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes.
1
SETUP – MK3004GAH (HDD1384) HARD DISK DRIVE
Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive.
Figure 1. MK3004GAH Side View
Installation Notes
• Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the specified area is 2N. important Note: Disconnect power from your computer system before beginning
installation
2
USING THE HARD DISK DRIVE – MK3004GAH (HDD1384)
HARD DISK DRIVE
Backing up Data Files
To avoid data loss, regularly back up the data files on the hard disk drive.
3
SPECIFICATIONS –MK3004GAH (HDD1384) HARD DISK DRIVE
General
Interface ATA-2/3/4/5
Functionality
Formatted Capacity
Rotational Speed
Avg. Rotational Latency
30.0GB*
4200rpm
7.14/ms
Spin-up Time 3.5sec (typical)
Buffer 512KB
Seek Time
Average
Maximum
Internal Transfer Rate
Host Transfer Rate
15
26
100.9 ~ 193.9 Mbits/sec (max)
100Mbytes/sec
16.6Mbytes/sec
Interleave Factor 1:1
*Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes.
Internal Drive Characteristics
Number of Disks
Number of Data Heads
Track Density (TPI)
Logical Cylinders
Logical Heads
Logical Sectors/track
Bytes per Sector
Logical Blocks (LBA)
2
4
3,039 (77.2k)
16,383
16
63
512
55,595,040
Reliability
Preventative maintenance
Non-recoverable read errors
Electrical
None
1 error per 10 13 bits read
Power Consumption
Seek
Read/Write
Sleep
Energy Consumption Efficiency
Shock
Operating
Non-Operating
4
1.4W typ
1.4W typ
0.08W typ
0.013W/GB avg
1,960m/s 2 (200G)(2msec)
9,800m/s 2 (1000G)(1msec)
Physical
Regulatory
The drive satisfies the following standards:
Underwriters Laboratories (UL) 1950
Canadian Standard Association (CSA) C22.2 No. 950
TUV Rheinland
EMC - EN50081-1
EMC - EN50082-1
BSMI
EN 60 950
EN50081-1: 1992
EN55022: 1994 Class B
EN61000-3-2: 1995
EN61000-3-3: 1995
EN61000-4-2: 1995
EN61000-4-3: 1998
ENV50204: 1995
EN61000-4-4: 1995
EN61000-4-5: 1995
EN61000-4-6: 1996
EN61000-4-11: 1994
3902C799
5
DRIVE CONNECTORS –MK3004GAH (HDD1384) HARD DISK DRIVE
Figure 1. MK3004GAH HDD - INTERFACE CONNECTOR
Interface Connector
Drive Side Connector
Recommended Host Side Connector
MCD-D50 Series by DDK Connectors
MCD-D50 Series by DDK Connectors
6
7
Interface Signals
DRIVE INTERFACE SIGNALS
5
7
1
3
RESET
DD 7
DD 6
DD 5
6
8
2
4
GROUND
DD 8
DD 9
DD 10
9
11
13
DD 4
DD 3
DD 2
10
12
14
DD 11
DD 12
DD 13
15
17
DD 1
DD 0
16
18
DD 14
DD 15
19 GROUND 20 OPEN
23 DIOW/STOP 24 GROUND
25 26 GROUND DIOR/
-DMARDY
HSTROBE
27 IORDY/
-DMARDY/-
DSTROBE
28 CSEL
31 INTRQ 32 IOCS16
41 3.3V (LOGIC) 42 3.3V (MOTOR)
Note: Symbol () in front of signal indicates negative logic.
