Ultra Start 1175 Series remote starter Owner's Guide

Below you will find brief information for remote starter 1175 Series. This manual covers the basics of your purchase, including how to use it for remote starting, stopping, and setting the run time. You'll also find information on how to program your remote transmitters and how to diagnose any problems you might encounter. The manual also includes safety information, such as the importance of installing a carbon monoxide detector and never operating the system in an enclosed area.

PDF Download
Document
Ultra Start 1175 Series Remote Starter Owner's Guide | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Remote Starting
  • Extended Run Time
  • Remote Stop
  • Idle Mode
  • System Service Mode
  • Remote Transmitter Learn
  • Diagnostic Codes
  • Hood Pin Safety Switch
  • Limited Lifetime Warranty
  • Manual Transmission Starter

Frequently asked questions

Press and release the START button on your remote transmitter. The park lights will flash, and the horn will honk once to confirm. The vehicle will then start, the horn will honk again, and the park lights will flash four times before remaining on while the vehicle is running.

While the vehicle is running with the remote starter, press and release the START button. The park lights will flash, and the siren or horn will chirp one time to confirm. The system will reset the run time.

While the vehicle is running with the remote starter, press and hold the START button for three seconds. The remote starter will shut down. The park lights will flash, and the siren or horn will chirp 2 times to confirm shutdown.

Turn the ignition key to the ON position, DO NOT START! Within 4 seconds, press and hold the Program Button (located on the antenna) for 5 seconds or until the siren/ horn (optional) chirps five times.
Preparing document for printing…
0%