How to Configure Your Modem Router Using Setup Wizard

How to Configure Your Modem Router Using Setup Wizard
How to Configure Your Modem Router
Using Setup Wizard
This document will detail how to configure your modem router for Internet and Wireless
connection using the Setup Wizard accessible via a Web Browser.
Please note: running the Setup Wizard is only required when you setting up your modem
router for the first time. If you want to re-run the Setup Wizard it is recommended to reset
the modem router to factory settings under Maintenance > Restore Default Settings.
Step 1.
Open your Internet browser e.g. Internet Explorer, Firefox, Chrome, Safari, etc. and
enter the IP address of your D-Link modem in the address bar: http://192.168.1.1
Step 2.
When prompted type in the Username and Password, enter the validation code
displayed on your page and then click on the “Log In” button.
If you have not changed the password for the modem administration, the factory settings are:
Username: admin
Password: admin
If you cannot recall the password you assigned to your modem you will need to reset the modem
to factory defaults by pressing the reset button for 10 seconds. Please note that this will revert
all the settings in the modem to factory settings and you will have to reconfigure it with your
Internet settings and Wireless security. Make sure you have your Internet account details (given
by your Internet Provider) handy.
D-Link Technical Support – Configuration using Web Browser (Setup Wizard)
Page 2 of 7
Step 3.
After logging in you will be presented with the modem’s configuration pages. The Setup
Wizard will start automatically. If not you can start it under Setup tab.
Click on the Setup Wizard button:
Step 4.
The Setup Wizard will display the steps required to configure your modem router. Click
the Next button:
D-Link Technical Support – Configuration using Web Browser (Setup Wizard)
Page 3 of 7
Step 5.
Change the password that is used to access your modem router. Click the Next button.
Step 6.
Select your Time Zone. Click the Next button to continue:
D-Link Technical Support – Configuration using Web Browser (Setup Wizard)
Page 4 of 7
Step 7.
Enter your Internet Provider details: select Country and your Internet Provider. If your
provider is not listed, select “Other”.
Providers in Australia typically use these settings:
Protocol: PPPoE; Connection Type: LLC; VPI: 8; VCI: 35
Providers in New Zealand typically use these settings:
Protocol: PPPoA; Connection Type: VC-Mux; VPI: 0; VCI: 100
In the Username and Password field please type in your Internet account details as given by
your Internet Service Provider.
Click on the Next button.
D-Link Technical Support – Configuration using Web Browser (Setup Wizard)
Page 5 of 7
Step 8.
In the [Wireless Network Name] field type in the name for your wireless network.
Select Security Mode for your Wireless Network. It is recommended to use “WPAPersonal/WPA2 only”.
In the [WPA2 Pre-Shared Key] type in the password you want to use to access your Wi-Fi. Take a
note of this password as you will need to enter it into all your devices trying to connect to your
Wi-Fi network for the first time.
D-Link Technical Support – Configuration using Web Browser (Setup Wizard)
Page 6 of 7
Step 9.
Your modem router’s Internet and Wireless configuration is now complete. Press on the
Restart button to reboot the modem router with the new settings.
D-Link Technical Support – Configuration using Web Browser (Setup Wizard)
Page 7 of 7
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising