For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
OWNERS MANUAL
MODEL NO.
45-01763
7 CU. FT. FARM/YARD CART
CAUTION:
Read Rules for
Safe Operation
and Instructions
Carefully
•
•
•
•
•
Safety
Assembly
Operation
Maintenance
Parts
PRINTED IN U.S.A.
FORM NO. 48325 (11/01)
www.mymowerparts.com
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
RULES FOR SAFE OPERATION
ASSEMBLY INSTRUCTIONS
Preventing accidents is the responsibility of every
equipment operator. The following general safety
precautions must be fully understood and followed by
every operator.
1. Do not at any time carry passengers in this cart. It
is designed for carrying materials only and not
intended to carry passengers.
2. Be careful on any grade (hill) and stay off of steep
grades.
3. Use caution when loading cart to avoid tipping.
4. Avoid large holes and ditches when transporting
loads.
TOOLS REQUIRED
(1) Screw Driver
(1) Pliers
(1) 7/16" Wrench
When assembling your cart, place the heads of all
screws to the inside and hex nuts with flat washers
to the outside.
1. Lay the front angle assembly down (flat) on floor
and stand the bottom panel in position as shown in
figure 2.
Your Farm/Yard Cart carton contains a hardware
package with parts as shown in the chart below and in
figure 1.
NOTE
Contents of Hardware Pack: (See figure 1)
REF. QTY.
A
B
C
D
E
F
G
H
I
8
4
15
4
27
23
4
4
4
The bottom panel has one galvanized
edge; this is the rear. The front edge
has three holes. See figure 2.
DESCRIPTION
Screws, 1/4-20 x 2" Long
Screws, 1/4-20 x 1-1/4" Long
Screws, 1/4-20 x 1" Long
Tube Cap, 1" x 1" Long
Hex Nuts, 1/4-20 Thread
Flat Washer, 1/4"
Flat Washers, 1-1/2"
Lock Washers, 1/4"
Cotter Pins
2. Line up three holes in bottom panel with holes in
front angle assembly. Start three 1/4" x 1" screws
through bottom panel, then through angle. Secure
screws with 1/4" flat washers and hex nuts. Tighten
securely. See figure 2.
HARDWARE REFERENCE CHART
A
B
D
C
1/4" x 1"
H
1/4" x 1-1/4"
E
G
I
1/4" x 2"
F
FIGURE 2
FIGURE 1
2
www.mymowerparts.com
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
3. Turn the front angle assembly and bottom panel
upside down as shown in figure 3.
7. Stand the cart on its front end with the front angle
assembly on the floor. See figure 5.
4. Lay the two side angles on the bottom panel so
that the two holes for the axle clamps are closer to
the front angle assembly. See figure 3.
8. Temporarily place four large 1-1/2" flat washers
(used on wheel axle) on the inside of front angle
assembly. See figure 5.
5. Secure both axle clamps to the side angles and
the bottom panel using four 1/4" x 1-1/4" screws,
lock washers and hex nuts. Make only finger
tight until axle is assembled. See figure 3.
NOTE
These washers act as shims and are
just for assembly purposes. You will
remove them later to use on axle.
FIGURE 5
FIGURE 3
9. Lay the front panel down onto the front angle
assembly, on top of the four large washers. See
figure 6.
6. Secure both side angle assemblies to the bottom
panel using four 1/4" x 1" screws, flat washers and
hex nuts. Make only finger tight until all four screws
are in place, then tighten securely. See figure 4.
FIGURE 4
FIGURE 6
3
www.mymowerparts.com
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
10. Place one side panel in position against a side
angle and down on top of the front panel. Start one
1/4" x 1" screw through the center hole in side
panel and side angle. Secure with hex nut and flat
washer. See figure 7. Make only finger tight at
this time.
13. Assemble one 1/4" x 1" screw through bottom hole
in side panel and front angle assembly. Secure
with a flat washer and hex nut, making only
finger tight at this time. Repeat for the other side
panel. See figure 8.
14. Tighten all loose nuts and screws securely at
this time.
11. Start one 1/4" x 1" screw through front hole on side
panel and side angle. Start another 1/4" x 1" screw
through top hole on side panel and front angle
assembly. Next, place a support strap over these
two screws and secure it with flat washers and hex
nuts, making only finger tight at this time. See
figure 7.
12. Repeat steps 10 and 11 for the other side panel.
FIGURE 8
FIGURE 7
4
www.mymowerparts.com
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
15. Lay the cart down on the floor so that the sides are
up in a normal position. Remove the front panel by
sliding it up, then remove the four large washers
you used for shims. See figure 9.
17. Leave the cart standing to assemble the handle
tube in the next step.
18. Place tube caps on the handle tube, then place it
over the side panels and line up the four holes.
Assemble four 1/4" x 2" screws through the side
panels and handle. Secure with flat washers and
hex nuts. See figure 11.
FIGURE 9
FIGURE 11
16. Stand cart up on its front end again. Place tube
caps on leg tube and assemble the leg tube as
shown in figure 10, using four 1/4" x 2" screws
through side panels and leg tube. Secure with flat
washers and hex nuts. See figure 10.
19. Lay the cart upside down. Slide the axle through
the axle clamps. See figure 12.
FIGURE 10
FIGURE 12
5
www.mymowerparts.com
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
20. Assemble a cotter pin to the inside hole at one end
of the axle. Place a 1-1/2" flat washer, a wheel and
then another 1-1/2" flat washer onto the axle.
Secure the wheel with a cotter pin assembled to
the outside hole at the end of the axle. Repeat
step for other wheel. See figure 12.
MAINTENANCE
21. Center the wheels and the axle side to side.
Tighten the four nuts on the axle clamps.
2. Periodically retighten all screws, especially after
heavy use. Do not exceed load capacity rating
of 300 lbs.
1. Grease or oil wheel bearings occasionally. Use
automotive wheel bearing type grease or 20 weight
oil.
3. Clean cart thoroughly after each use.
4. Store indoors during severe weather.
5. Apply light coat of varnish to all wood surfaces
annually.
6. Use glossy black enamel spray paint to touch up
scratched or worn painted metal surfaces.
RECOMMENDED TIRE PRESSURE 35-40 PSI
MAXIMUM TIRE PRESSURE 40 PSI
FIGURE 13
22. Turn cart right side up, so that it rests on its
wheels.
23. Place front panel in guides to complete assembly.
24. Your cart is now ready to use.
6
www.mymowerparts.com
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
MODEL 45-01763 7 CU. FT. FARM/YARD CART
REF.
NO.
PART
NO.
QTY.
1
2
3
4
5
6
7
8
9
10
47585
47586
47587
24891
24892
62529
44018
44019
23606
48312
1
2
1
1
1
1
1
1
2
2
11
44021
4
DESCRIPTION
Front Panel
Side Panel
Bottom Panel
Side Angle, L.H.
Side Angle, R.H.
Front Angle
Handle Tube
Leg Tube
Support Strap
Wheel Assembly Complete
w/Bearings (20")
Tube Caps
REF. PART
NO.
NO.
12
13
14
15
16
17
18
19
20
21
22
43010
43949
47584
44259
43088
43178
24890
44016
44020
43177
23917
48325
QTY.
4
4
8
15
23
27
1
4
4
4
2
1
*Purchase Common Hardware Locally.
7
www.mymowerparts.com
DESCRIPTION
Cotter Pin, 1/8" x 1-1/4" Lg.*
Flat Washer 25/32" I.D. x 1-1/2" O.D.
Truss Head Screws 1/4-20 x 2" Lg.*
Truss Head Screws 1/4-20 x 1" Lg.*
Flat Washer, 1/4" I.D.*
Hex Nut, 1/4-20 Thread *
Axle
Bearing, Ball 3/4" I.D.
Truss Head Screws 1/4-20 x 1-1/4" Lg.*
Lock Washer, 1/4" *
Axle Clamp
Owner's Manual
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
AGRI-FAB ® LIMITED WARRANTY
WHO IS COVERED: This Warranty covers only the original retail purchaser of an AGRI-FAB ® product or part. It
is not transferable.
HOW LONG DOES COVERAGE LAST: This Warranty remains in force for 1 year from the date of purchase.
WHAT IS COVERED: Any defect in material or workmanship of your AGRI-FAB ® product or part.
WHAT IS NOT COVERED:
1.
This warranty does not apply to the engine or components parts thereof. Please refer to the applicable
manufacturer’s warranty on these items
2. Transportation charges for the movement of any power equipment unit or attachment are the responsibility of
the purchaser. Transportation charges for any parts submitted for replacement under this warranty must be
paid by the purchaser unless such return is requested by AGRI-FAB ®.
3. This Warranty applies only to products, which have been properly assembled, adjusted, operated, and
maintained in accordance with the instructions furnished. This Warranty does not apply to any product,
which has been subjected to alteration, misuse, abuse, improper assembly or installation, delivery damage,
or to normal wear of the product.
4. Exclusions: Excluded from this Warranty are belts, blades, blade adapters, normal wear, normal adjustments,
standard hardware and normal maintenance.
5. AGRI-FAB ® does not extend any warranty for products sold or exported outside of the United States of
America, its possessions and territories, except those sold through AGRI-FAB’s authorized channels of
export distribution.
WHAT AGRI-FAB ® WILL DO: Repair or replace your AGRI-FAB ® product or part.
HOW TO GET SERVICE: Deliver the AGRI-FAB ® product or part to AGRI-FAB’s local authorized service dealer
or distributor. If you do not know the dealer or distributor in your area, please write to the Customer Service
Department of AGRI-FAB, Inc. at P.O. BOX 903, SULLIVAN, ILLINOIS 61951. The return of a product or part to
AGRI-FAB ® will not be accepted unless prior written permission has been extended by AGRI-FAB ®.
THE DURATION OF ANY IMPLIED WARRANTY OF MERCHANTABILITY IS LIMITED TO THE DURATION OF
THE ABOVE EXPRESS WARRANTY. THE REMEDIES PROVIDED IN THIS LIMITED WARRANTY ARE THE
CUSTOMER’S SOLE AND EXCLUSIVE REMEDIES. EXCEPT FOR THE OBLIGATIONS SPECIFICALLY SET
FORTH IN THIS LIMITED WARRANTY, IN NO EVENT SHALL AGRI-FAB ® BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES, WHETHER BASED ON CONTRACT, TORT, OR ANY OTHER LEGAL THEORY.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of
incidental or consequential damages, so the above limitations may not apply to you.
This Warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
Agri-Fab, Inc., 303 West Raymond St., Sullivan, Illinois 61951 - (217) 728-8388 - www.Agri-Fab.com
REPAIR PARTS
303 West Raymond
Sullivan, IL. 61951
217-728-8388
www.agri-fab.com
www.mymowerparts.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement