GE Profile DPSB513GBCC / DPSB513GBWW Gas Dryer

GE Profile DPSB513GBCC / DPSB513GBWW Gas Dryer
TM
DPSB513GBWW/CC – GE Profile™ Super 7.0 Cu. Ft. Capacity Gas Dryer
Dryer Dimensions (in inches)
23-1/2
28-1/4
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
25-1/2*
27
Exhaust Options:
When viewed from the front of the unit, exhaust 3-way via rear, left
and bottom. Dryer is shipped exhausted to the rear. Alternate exhausting
knockouts are supplied.
Gas: An individual properly-grounded branch circuit, with a threeprong grounding-type receptacle, protected by a 15 or 20 amp circuit
breaker or a time-delay fuse is required.
Gas Dryer Electric Rating: 120V, 60Hz, 6A
8-1/2
36
42
2-1/2
Side View
Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for
LP gas. LP gas supply requires a conversion kit. Check installation
instructions for correct kit and have a qualified gas technician install a
conversion kit. See dryer ducting information for proper installation.
11-1/2
2
3-1/2
Note: Dryer wall outlet must be located within 36" of service cord
entry and accessible when dryer is mounted in position.
Installation Information: For complete information, see installation
instructions packed with your dryer.
Rear View
R
Specification Revised 3/03
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™ or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center® service, 800.626.2000.
TM
DPSB513GBWW/CC – GE Profile™ Super 7.0 Cu. Ft. Capacity Gas Dryer
Dryer Exhausting Information – Use Metal Duct Only
Vertical and Horizontal Ducting
For complete information, see installation instructions packed with your dryer.
Best Performance
Maximum Length of 4"
Dia. Rigid Metal Duct
Exhaust Hood Type
Maximum Length of 4"
Dia. Flexible Metal Duct
Exhaust Hood Type
Number
of
90°
Turns
A
4" Opening
B
2-1/2"
Opening
A
4" Opening
0
1
2
3
4
0
1
2
3
4
0
1
2
3
0
1
2
3
4
150 ft.
140 ft.
130 ft.
120 ft.
110 ft.
90 ft.
60 ft.
45 ft.
35 ft.
25 ft.
90 ft.
60 ft.
45 ft.
35 ft.
60 ft.
52 ft.
44 ft.
32 ft.
28 ft.
127 ft.
117 ft.
107 ft.
97 ft.
87 ft.
60 ft.
45 ft.
35 ft.
25 ft.
15 ft.
60 ft.
45 ft.
35 ft.
25 ft.
48 ft.
40 ft.
32 ft.
24 ft.
16 ft.
75 ft.
65 ft.
55 ft.
45 ft.
35 ft.
55 ft.
40 ft.
30 ft.
20 ft.
15 ft.
55 ft.
40 ft.
30 ft.
20 ft.
30 ft.
22 ft.
14 ft.
—
—
A
A
4
B
Domestic
Dryer Models
2-1/2
7.3 Capacity Electric
and Gas Dryers
7.0 and 6.0
Capacity Models
all Electric Dryers
7.0 and 6.0
Capacity Models
all Gas Dryers
5.7 Capacity Electric
and Gas Dryers
B
2-1/2"
Opening
52 ft.
42 ft.
32 ft.
22 ft.
12 ft.
45 ft.
30 ft.
20 ft.
15 ft.
10 ft.
45 ft.
30 ft.
20 ft.
15 ft.
18 ft.
14 ft.
10 ft.
—
—
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0" either side
3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.
• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of
open area equally distributed. If this closet contains both a washer and a dryer, doors must contain
a minimum of 120 sq. in. of open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.
Minimum Clearances other than Alcove or Closet Installation:
• Minimum clearances to combustible surfaces
0" both sides
3" rear
Specification Revised 3/03
Ducting Materials:
For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct. If
“all rigid metal” duct cannot be used, then “flexible all metal” venting can be used, but it will reduce
the maximum recommended duct length.
Exhaust Length Calculation:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the side
or bottom of dryer, add one turn.
2. The maximum length of 4’ rigid (aluminum or galvanized) duct which can be tolerated is shown
in the table. The maximum length for flexible ducts are less than for rigid duct.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a
90° elbow. A turn over 45° should be treated as a 90° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts of
moisture and lint from being blown into the room. Gas dryers or any dryer located in a closet must
be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed house
floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or moisture
could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen
exhaust, since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc.
The wall cap must also be located at least 12" above the ground or any other obstruction with the
opening pointed Down.
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a
4" opening dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE-CARES.
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™ or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center® service, 800.626.2000.
TM
DPSB513GBWW/CC – GE Profile™ Super 7.0 Cu. Ft. Capacity Gas Dryer
Features and Benefits
TOUCH
ONE
Cycles
Sensor Dry
COTTONS
DRYNESS
LEVEL
ARE
EASY C
PRESS
PERM
DE
WARM
UP
WRINKLE
DELICATES
SPEED
DRY
CUSTOM CUSTOM
2
1
PRESS 3 SEC
SensorDry Plus
EXTEND
TUMBLE
HIGH
MEDIUM
DRY
MIXED
LOADS
LOW
LESS
DRY
TIMED
DRY
OPTIONS
HEAT
SETTING
MORE
DRY
KNITS
SWEATERS
AIR
DRY
ANTIBACTERIAL
START
SIGNAL
30 MIN
DAMP
SIGNAL
MORE
DELAY
1-8 Hrs.
TIMED DRY
EXTENDED TUMBLE
CYCLE STATUS
STOP
LESS
• 7.0 cu. ft. Super Capacity Dryer
EST. TIME REMAINING
EXTRA
LOW
DAMP
TO STORE
CLEAN LINT FILTER
SENSING
• Exclusive Adaptive Logic System™
• Sensor Dry Plus
• One-Touch Electronic Controls
• Multiple Cycles with LED Digital Cycle Countdown
• 5 Heat Selections
• Extended Tumble Wrinkle Care
• Dewrinkle
• Deluxe Dryer Rack
• Dryer Interior Light
• Clean Lint Filter Reminder
• Deluxe Quiet Performance
• End-of-Cycle Signal
• Model DPSB513GBWW – White on white
• Model DPSB513GBCC – Bisque on bisque
Specification Revised 3/03
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement