GE DWXR483GBWW Gas Dryer

GE DWXR483GBWW Gas Dryer
GE Appliances
DWXR483GBWW – GE Extra-Large 6.0 Cu. Ft. Capacity Dryer
Dryer Dimensions (in inches)
23-1/2
25-3/4
*24-1/2" from the edge of the side panel to the front.
25-1/2" from the front edge of endcaps.
25-1/2*
5-1/4
27
36
42
2-1/2
Side View
Exhaust Options:
When viewed from the front of the unit, exhaust 3-way via rear, left and bottom.
Dryer is shipped exhausted to the rear. Alternate exhausting knockouts are supplied.
Gas:
An individual properly-grounded branch circuit, with a three-prong groundingtype receptacle, protected by a 15 or 20 amp circuit breaker or a time-delay fuse
is required.
Gas Dryer Electric Rating:
120V, 60Hz, 6A
11-1/2
2
3-1/2
Rear View
Gas (BTU/HR):
22,000. Factory-equipped for natural gas. Tested for LP gas. LP gas supply requires
a conversion kit. Check installation instructions for correct kit and have a
qualified gas technician install a conversion kit. See dryer ducting information
for proper installation.
Note:
Dryer wall outlet must be located within 36" of service cord entry and accessible
when dryer is mounted in position.
Installation Information:
For complete information, see installation instructions packed with your dryer.
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™ or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center® service, 800.626.2000.
Specification Revised 3/03
GE Appliances
DWXR483GBWW – GE Extra-Large 6.0 Cu. Ft. Capacity Dryer
Dryer Exhausting Information – Use Metal Duct Only
Vertical and Horizontal Ducting
For complete information, see installation instructions packed with your dryer.
Best Performance
Maximum Length of 4"
Dia. Rigid Metal Duct
Exhaust Hood Type
Maximum Length of 4"
Dia. Flexible Metal Duct
Exhaust Hood Type
Number
of
90°
Turns
A
4" Opening
B
2-1/2"
Opening
A
4" Opening
0
1
2
3
4
0
1
2
3
4
0
1
2
3
0
1
2
3
4
150 ft.
140 ft.
130 ft.
120 ft.
110 ft.
90 ft.
60 ft.
45 ft.
35 ft.
25 ft.
90 ft.
60 ft.
45 ft.
35 ft.
60 ft.
52 ft.
44 ft.
32 ft.
28 ft.
127 ft.
117 ft.
107 ft.
97 ft.
87 ft.
60 ft.
45 ft.
35 ft.
25 ft.
15 ft.
60 ft.
45 ft.
35 ft.
25 ft.
48 ft.
40 ft.
32 ft.
24 ft.
16 ft.
75 ft.
65 ft.
55 ft.
45 ft.
35 ft.
55 ft.
40 ft.
30 ft.
20 ft.
15 ft.
55 ft.
40 ft.
30 ft.
20 ft.
30 ft.
22 ft.
14 ft.
—
—
A
A
4
B
Domestic
Dryer Models
2-1/2
7.3 Capacity Electric
and Gas Dryers
7.0 and 6.0
Capacity Models
all Electric Dryers
7.0 and 6.0
Capacity Models
all Gas Dryers
5.7 Capacity Electric
and Gas Dryers
B
2-1/2"
Opening
52 ft.
42 ft.
32 ft.
22 ft.
12 ft.
45 ft.
30 ft.
20 ft.
15 ft.
10 ft.
45 ft.
30 ft.
20 ft.
15 ft.
18 ft.
14 ft.
10 ft.
—
—
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0" either side
3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.
• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of
open area equally distributed. If this closet contains both a washer and a dryer, doors must contain
a minimum of 120 sq. in. of open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.
Minimum Clearances other than Alcove or Closet Installation:
• Minimum clearances to combustible surfaces
0" both sides
3" rear
Specification Revised 3/03
Ducting Materials:
For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct. If “all
rigid metal” duct cannot be used, then “flexible all metal” venting can be used, but it will reduce the
maximum recommended duct length.
Exhaust Length Calculation:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or
bottom of dryer, add one turn.
2. The maximum length of 4" rigid (aluminum or galvanized) duct which can be tolerated is shown in
the table. The maximum length for flexible ducts are less than for rigid duct.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a
90° elbow. A turn over 45° should be treated as a 90° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts of
moisture and lint from being blown into the room. Gas dryers or any dryer located in a closet must be
exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed house
floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or moisture
could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen
exhaust, since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc.
The wall cap must also be located at least 12” above the ground or any other obstruction with the
opening pointed Down.
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a 4"
opening dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE CARES.
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™ or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center® service, 800.626.2000.
GE Appliances
DWXR483GBWW – GE Extra-Large 6.0 Cu. Ft. Capacity Dryer
8 Cl
oth e s
Care Cycle
MORE DRY
START
COTTONS
MED. HEAT
COOL DOWN
WRINKLE
CARE
ON
OFF
EASY CARE
AUTOMATIC
WRINKLE FREE
PERM. PRESS
DELICATES
OPTIMUM DRY
MEDIUM
OFF
LESS DRY
LESS DRY
Extended Cool
4 Heat Settings
EASY CARE
Features and Benefits
s - Super Capacit
y
WRINKLE CARE
SIGNAL
WRINKLEAirCARE
Tumble
FABRIC CARE
START
LOUD
REG. HEAT
COTTONS
AUTOMATIC
MORE DRY
TIMED DRY
80
QUICK FLUFF 10
DELICATES
FLUFF
LOW HEAT
DEWRINKLE 20
DAMP DRY 30
MIN
• 6.0 cu. ft. Extra-Large Capacity Dryer
70
40
50
60
NO HEAT
• Automatic Dry Control
• 4 Heat Selections
• 8 Cycles:
– Cottons with Auto Cotton and Optional Wrinkle Care
– Easy Care Cycle with Auto Easy Care and Optional Wrinkle Care
– Timed Dry (80 Min.) with Damp Dry, Dewrinkle and Quick Fluff (no heat)
• Variable End-of-Cycle Signal
• Dryer Interior Light
• Removable Upfront Lint Filter
• DuraDrum™ Interior
• Quiet-By-Design™ Performance
• Reverse-A-Door
• 100% Front Serviceable
• Model DWXR483EBWW – White on white (Electric)
• Model DWXR483EBCC – Bisque on bisque (Electric)
• Model DWXR483GBWW – White on white (Gas)
Specification Revised 3/03
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement