GE DCXR463EA Dryer

GE DCXR463EA Dryer
GE Appliances
DCXR463EAWW - GE Extra-Large 6.0 Cu. Ft. Capacity Dryer
Dryer Dimensions (in inches)
23-1/2
25-3/4
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
25-1/2*
Exhaust Options:
4-way via rear, right, left and bottom.
Circuit Requirements:
An individual, properly-grounded branch circuit, protected by a 30-amp circuit breaker or
a time-delay fuse, is required.
27
Electric Dryer Rating:
208/240V, 5600W, 24A, 60Hz
208V, 4400W, 22A, 60Hz
5-1/4
36
42
2-1/2
Side View
Note: Dryer wall outlet must be located within 36" of service cord entry and accessible
when dryer is mounted in position.
11-1/2
2
Installation Information: For complete information, see installation instructions
packed with your dryer.
3-1/2
Rear View
For answers to your Monogram,®
GE Profile Performance Series,™
GE Profile™ or GE appliance questions, call
GE Answer Center® service, 800.626.2000.
Specification Revised 9/00
R
Listed by
Underwriters
Laboratories
GE Appliances
DCXR463EAWW - GE Extra-Large 6.0 Cu. Ft. Capacity Dryer
Dryer Exhausting Information—Use Metal Duct Only
Best Performance
A
A
4
B
Domestic
Dryer Models
2-1/2
Super & Extra-Large
6.0 Capacity Models
All Electric Dryers
Super & Extra-Large
6.0 Capacity Models
All Gas Dryers
Extra-Large 5.7
Capacity Electric
and Gas Dryers
Number
of
90°
Turns
0
1
2
3
4
0
1
2
3
0
1
2
3
4
Maximum Length of 4"
Dia. Rigid Metal Duct
Exhaust Hood Type
Maximum Length of 4"
Dia. Flexible Metal Duct
Exhaust Hood Type
Cat. No.
WX8X59
(Preferred)
A
4" Opening
90 ft.
60 ft.
45 ft.
35 ft.
25 ft.
45 ft.
35 ft.
25 ft.
15 ft.
60 ft.
52 ft.
44 ft.
32 ft.
28 ft.
Cat. No.
WX8X59
(Preferred)
A
4" Opening
55 ft.
40 ft.
30 ft.
20 ft.
15 ft.
30 ft.
20 ft.
10 ft.
—
30 ft.
22 ft.
14 ft.
—
—
B
2-1/2"
Opening
60 ft.
45 ft.
35 ft.
25 ft.
15 ft.
30 ft.
20 ft.
10 ft.
—
48 ft.
40 ft.
32 ft.
24 ft.
16 ft.
B
2-1/2"
Opening
45 ft.
30 ft.
20 ft.
15 ft.
10 ft.
15 ft.
10 ft.
—
—
18 ft.
14 ft.
10 ft.
—
—
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0” either side
3” front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.
• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area
equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in.
of open area equally distributed.
• The closet should be vented to the outdoors to prevent gas pocketing in case of a gas leak in the supply line.
• No other fuel-burning appliance shall be installed in the same closet with the dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.
Minimum Clearances other than Alcove or Closet Installation:
•Minimum clearances to combustible surfaces
0” both sides
3” rear
Specification Revised 9/00
For complete information, see installation instructions packed with your dryer.
Ducting Materials:
For best performance, this dryer should be vented with 4” diameter all rigid metal exhaust duct. If “all rigid metal”
duct cannot be used, then “flexible all metal” venting can be used, but it will reduce the maximum recommended
duct length.
Exhaust Length Calculation:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the side
or bottom of dryer, add one turn.
2. The maximum length of 4’ rigid (aluminum or galvanized) duct which can be tolerated is shown
in the table. The maximum length for flexible ducts are less than for rigid duct.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a 90° elbow. A
turn over 45° should be treated as a 90° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts of moisture and
lint from being blown into the room. Gas dryers or any dryer located in a closet must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed
house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard
or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen
exhaust, since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall
cap must also be located at least 12” above the ground or any other obstruction with the opening pointed Down.
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a 4” opening
dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE CARES.
For answers to your Monogram,®
GE Profile Performance Series,™
GE Profile™ or GE appliance questions, call
GE Answer Center® service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
GE Appliances
DCXR463EAWW - GE Extra-Large 6.0 Cu. Ft. Capacity Dryer
MORE DRY
LESS DRY
LESS DRY
COOL
DOWN
OPTIMUM DRY
FABRIC CARE
EASY CARE
AUTOMATIC
WRINKLE FREE
PERM. PRESS
DELICATES
COTTONS
4 HEAT SETTINGS
START
AUTOMATIC
EASY CARE
START
COTTONS
MORE DRY
MED. HEAT
REG. HEAT
80 MIN
TIMED DRY
70
QUICK FLUFF
10
60
DEWRINKLE 20
DELICATES
FLUFF
LOW HEAT
NO HEAT
Extra Large Capacity
Duty / Quiet By Design
/ 6 Cycle / Heavy
Specification Revised 9/00
DAMP DRY 30
40
50
Features and Benefits
• Extra-Large (6.0 cu. ft.) Dryer
• Automatic Dry Control
• 4 Heat Selections
• 6 Cycles:
- Automatic Cottons Cycle
- Easy Care Cycle with Auto Wrinkle Free / Permanent Press
- Timed Dry (80 Min.) with Damp Dry, Quick Dry and De-Wrinkle
• Dryer Interior Light
• Removable Up-Front Lint Filter
• DuraDrum™ Interior
• Quiet-By-Design™
• Reverse-A-Door
• 100% Front Serviceable
• Model DCXR463EAWW - White on white
• Model DCXR463EAAA - Almond on almond
• Model DCXR463GAWW - White on white
• Model DCXR463GAAA - Almond on almond
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement