GE Profile Prodigy DPSR513GA Dryer


Add to my manuals
2 Pages

advertisement

GE Profile Prodigy DPSR513GA Dryer | Manualzz

Owners Manual Supplement for model DPSR513

(replaces pages 6, 7, and 8 of your Owner’s Manual)

About the dryer control panel.

Dryness Sensor Cycle

START

START

FABRIC CARE

5 HEAT SETTINGS

COTTONS

REG. HEAT

EASY CARE

MED. HEAT

WRINKLE CARE

EXTENDED COOL AIR TUMBLE

OFF ON

SIGNAL

ELECTRONIC TONE

OFF ON

WRINKLE CARE

COTTONS Shirts

LESS DRY

OPTIMUM DRY

Jeans/Towels

MORE DRY

TIMED DRY

DEWRINKLE 20

DRYEL 30

QUICK DRY 40 50

60 70

Wrinkle Free Cottons

MORE DRY

Knits

LESS DRY

COOL DOWN

WRINKLE

CARE EASY CARE

PERM. PRESS

DELICATES Woolens/Linens

MORE DRY

Rayon/Silk

LESS DRY

WRINKLE CARE

ULTRA CARE

80

MIN

FLUFF

NO HEAT

ULTRACARE

GENTLE HEAT

DELICATES

LOW HEAT

3 1 2

NOTE:

Drying times will vary according to the type of heat used (Electric, Natural or LP gas), size of load, types of fabrics, wetness of clothes, and condition of exhaust ducts.

1

Fabric Care

COTTONS For regular to heavy cottons.

REG. HEAT

EASY CARE For synthetics, blends, delicates and

MED HEAT items labeled permanent press.

2

Drying Cycles

— Automatic cycles automatically sense fabric dryness. Select MORE DRY for heavier fabrics, LESS DRY for lighter fabrics. Timed cycles run for the selected time.

FLUFF For fluffing items without heat. Use the

NO HEAT TIMED DRY cycle.

DELICATES For delicates, synthetics and items labeled

LOW HEAT tumble dry low.

ULTRA CARE For lingerie and special care fabrics.

GENTLE HEAT

COTTONS For cottons and most towels. For most loads select

AUTOMATIC the OPTIMUM DRY setting.

EASY CARE For synthetic blends and delicates.

PERM PRESS/

DELICATES

ULTRA CARE For special care fabrics such as rayons, woolens and silks.

TIMED DRY Set the Cycle Selector at the desired drying time.

QUICK DRY For one or two items.

DRYEL ® For use with Dryel “dry clean only” fabric care system. Use the MED-HEAT fabric care setting.

See product package for instructions.

DEWRINKLE For removing wrinkles from items that are clean and dry or that are very lightly damp.

3

Start

— Close the dryer door. Select START. Opening the door during operation will stop the dryer. To restart the dryer, close the door and select START to complete the cycle.

Color Logic

Select the correct FABRIC CARE setting. Match the particular color below the words with the same color on the Cycle Dial.

Example: Drying a load of clothing labeled permanent press.

1 Choose the FABRIC CARE setting-—for this load it would be the

EASY CARE MED. HEAT (which is a particular color).

2 Turn the Cycle Dial to the area that has the same color as the

FABRIC CARE setting you have chosen—for this load it would be the EASY CARE PERM PRESS.

Pub. No. 49-90039

JR 12-99

Printed in Canada

About your dryer features.

ARE

AT

WRINKLE CARE

EXTENDED COOL AIR TUMBLE

OFF ON

Wrinkle Care

Use this option to minimize the wrinkles in clothes. It provides approximately 15 minutes of no-heat tumbling after the clothes are dry.

This option can only be used with the

Automatic cycles.If you are using the CYCLE

SIGNAL and you select the WRINKLE CARE option, a signal will sound at the end of the drying time and several times during the WRINKLE CARE cycle.

This will remind you that it is time to remove the clothes.

If WRINKLE CARE is not ON, the dryer will stop once the timer reaches the WRINKLE CARE mark on the cycle dial.

E

LE

OFF

SIGNAL

ELECTRONIC TONE

ON

End of Cycle Signal

This signal will sound just before the end of the cycle to remind you to remove the clothes.

If you selected the WRINKLE CARE option the signal will sound at the end of the drying time and will sound several times during the

WRINKLE CARE cycle. This will remind you that it is time to remove the clothes.

NOTE:

Remove garments promptly at the sound of the signal. Place clothes on hangers so wrinkles won’t set in.

Use the END OF CYCLE SIGNAL especially when drying fabrics like polyester knits and permanent press. These fabrics should be removed so wrinkles won’t set in.

SensorDry

SensorDry

This feature is only activated in the automatic cycles.

SensorDry provides greater drying accuracy than standard machines, resulting in shorter dry times and better clothes care. As the clothes tumble, they touch a moisture sensor.

The sensor will stop the heating cycle as soon as the clothes have reached the selected dryness.

On some models, there is a Dryness Sensor

Cycle indicator light. This light is illuminated during automatic cycles. When the SensorDry feature stops the heating cycle, the light will go out and the cool down period will begin.

Note: The clothes will be hot if they are removed immediately after the indicator light goes out.

Drum Lamp

Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at the household distribution panel by removing the fuse or switching off the circuit breaker. Reach above dryer opening from inside the drum. Remove the bulb and replace with the same size bulb.

Drying Rack

A handy drying rack may be used for drying articles such as stuffed toys, pillows or washable sweaters.

Hook the rack over the lint filter so the rack extends into the dryer drum.

NOTE:

■ The drying rack must be used with the

TIMED CYCLE.

■ Do not use this drying rack when there are other clothes in the dryer.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement