GE DBXR463GDWW Gas Dryer


Add to my manuals

advertisement

GE DBXR463GDWW Gas Dryer | Manualzz

GE Appliances

DBXR463GDCC/WW – GE ® Extra-Large 6.0 Cu. Ft. Capacity Gas Dryer

23-1/2 25-3/4

25-1/2*

5-1/4

*24-1/2" from the edge of the side panel to the front.

25-1/2" from front to edge of endcaps.

36

42

2-1/2

11-1/2

2

27

3-1/2

Exhaust Options:

When viewed from the front of the unit, exhaust 3-way via rear, left and bottom. Dryer is shipped exhausted to the rear. Alternate exhausting knockouts are supplied.

Gas: An individual properly-grounded branch circuit, with a three-prong grounding-type receptacle, protected by a 15 or 20 amp circuit breaker or a time-delay fuse is required.

Gas Dryer Electric Rating: 120V, 60Hz, 6A

Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas. LP gas supply requires a conversion kit. Check installation instructions for correct kit and have a qualified gas technician install a conversion kit.

See dryer ducting information for proper installation.

Note: Dryer wall outlet must be located within 36" of service cord entry and accessible when dryer is mounted in position.

Installation Information: For complete information, see installation instructions packed with your dryer.

Side View

Power Cord Locations

5''

Rear View

Power

Cord Hole

4-1/2''

Back View

Specification Created 6/03

R

Listed by

Underwriters

Laboratories

For answers to your Monogram,

GE ®

® GE Profile ™ appliance questions, visit our website at or

GEAppliances.com or call

GE Answer Center ® service, 800.626.2000.

GE Appliances

DBXR463GDCC/WW – GE ® Extra-Large 6.0 Cu. Ft. Capacity Gas Dryer

Dryer Exhausting Information – Use Metal Duct Only

Vertical and Horizontal Ducting

A

A

Domestic

Dryer Models

B

2-1/2

Best Performance

Maximum Length of 4"

Dia. Rigid Metal Duct

Exhaust Hood Type

Maximum Length of 4"

Dia. Flexible Metal Duct

Exhaust Hood Type

4

7.3 Capacity Electric and Gas Dryers

7.0 and 6.0

Capacity Models all Electric Dryers

7.0 and 6.0

Capacity Models all Gas Dryers

5.7 Capacity Electric and Gas Dryers

Number of

90°

Turns

0

1

2

3

4

2

3

0

1

4

0

1

2

3

2

3

4

0

1

A

4" Opening

150 ft.

140 ft.

130 ft.

120 ft.

110 ft.

90 ft.

60 ft.

45 ft.

35 ft.

25 ft.

90 ft.

60 ft.

45 ft.

35 ft.

60 ft.

52 ft.

44 ft.

32 ft.

28 ft.

B

2-1/2"

Opening

127 ft.

117 ft.

107 ft.

97 ft.

87 ft.

60 ft.

45 ft.

35 ft.

25 ft.

15 ft.

60 ft.

45 ft.

35 ft.

25 ft.

48 ft.

40 ft.

32 ft.

24 ft.

16 ft.

A

4" Opening

75 ft.

65 ft.

55 ft.

45 ft.

35 ft.

55 ft.

40 ft.

30 ft.

20 ft.

15 ft.

55 ft.

40 ft.

30 ft.

20 ft.

30 ft.

22 ft.

14 ft.

B

2-1/2"

Opening

52 ft.

42 ft.

32 ft.

22 ft.

12 ft.

45 ft.

30 ft.

20 ft.

15 ft.

10 ft.

45 ft.

30 ft.

20 ft.

15 ft.

18 ft.

14 ft.

10 ft.

Special Installation Requirements

Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

• The dryer MUST be exhausted to the outside.

• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:

0" either side

3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.

• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors.

• The installation must conform with the local codes, or in the absence of local codes, with the

National Fuel Gas Code, ANSI Z223.

Minimum Clearances other than Alcove or Closet Installation:

• Minimum clearances to combustible surfaces

0" both sides

3" rear

Specification Created 6/03

For complete information, see installation instructions packed with your dryer.

Ducting Materials:

For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct. If

“all rigid metal” duct cannot be used, then “flexible all metal” venting can be used, but it will reduce the maximum recommended duct length.

Exhaust Length Calculation:

1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or bottom of dryer, add one turn.

2. The maximum length of 4" rigid (aluminum or galvanized) duct which can be tolerated is shown in the table. The maximum length for flexible ducts are less than for rigid duct.

A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a

90° elbow. A turn over 45° should be treated as a 90° elbow.

Exhausting the dryer to the outside is strongly recommended to prevent large amounts of moisture and lint from being blown into the room. Gas dryers or any dryer located in a closet must be exhausted to the outside.

Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen exhaust, since the combination of lint and grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc.

The wall cap must also be located at least 12" above the ground or any other obstruction with the opening pointed down.

Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a

4" opening dampered wall cap.

For more information on venting kits and accessories, please call 1-800-GE-CARES.

R

Listed by

Underwriters

Laboratories

For answers to your Monogram, ®

GE Answer Center ®

GE Profile ™

GE ® appliance questions, visit our website at

GEAppliances.com or call service, 800.626.2000.

or

GE Appliances

DBXR463GDCC/WW – GE ® Extra-Large 6.0 Cu. Ft. Capacity Gas Dryer

START

START

FABRIC CA

RE

4 Heat Setti ngs

FLUFF

NO HEAT

DELICATES

LOW HEAT

COTTONS

6 C loth es Ca re Cycles

- Extra Large Capacity

MORE DRY

LESS DRY

OPTIMUM DR Y

LESS DRY

COOL

DOWN

AUTOMATIC

MORE DRY

EASY CAR

E

AUTOMATIC

WRINKLE FREE

PERM. PRESS

DELICATES

QUICK FLUFF 10

DEWRINKLE

20

DAMP DRY

30

40

50

60

70

80 MIN

TIMED DR

Y

Features and Benefits

• Auto Dry – Uses thermostats to monitor air temperature and reduce fabric wear.

• DuraDrum ™ – Offers a smooth, durable finish that’s gentle on clothes.

• Four heat selections – Provide the right temperature for the right drying results.

• Interior Dryer Light – Lets you see everything inside for easy loading and unloading.

• Six dry cycles – Flexible options for drying, dewrinkling and fluffing.

• Quiet-By-Design ™ – Engineered for quiet operation.

• Fixed End-of-Cycle Signal – Alerts you when the cycle is done, saving time between loads.

• Reverse-A-Door Offers added installation flexibility.

• Upfront Lint Filter – Easy to reach and clean.

• Model DBXR463GDWW – White on white

• Model DBXR463GDCC– Bisque on bisque

Specification Created 6/03

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement