OLS Series Light Sources

OLS Series Light Sources
OLS Series Light Sources
Features
•• Rugged, dependable, tools backed with 5-Year Warranty
•• Simple user interface minimizes training requirements
•• Stabilized outputs for accurate loss measurements
•• Wave ID supports testing up to three wavelengths simultaneously
•• Field swappable output adapters provide flexibility
Applications
•• Link loss measurements
•• Certify SM and MM links to industry standards
•• Continuity check and fiber identification for maintenance restoration
With more than 25 years of experience in the optical testing industry and thousands of
units in use around the world, AFL is a trusted supplier of optical light sources. Backed by
5-year product warranties, these are the quality products you can trust.
OLS7 Optical Laser Source
Designed for use in outside plant environments
•• Splash resistant controls
•• Withstands one-meter drop test
•• Controls designed for easy operation with gloves
•• Field swappable output adapters allow access for cleaning optical port and supports
multiple connector styles
•• Efficient design provides long test time from globally available AA batteries. External
power adapter available for extended testing or lab situations.
Output Modes Supported
•• Wave ID (Triple, Dual, or Single) decreases test time while reducing technician errors
•• CW mode provides continuous output (no encoding)
•• Test Tone (2000, 1000, 330, 270 Hz) for use in fiber identification with NOYES power
meters (with fiber end access) or NOYES Optical Fiber Identifier (OFI) products for
non-intrusive, mid-span testing
OLS4 Optical Laser Source
www.AFLglobal.com or (800) 321-5298, (603) 528-7780
1
© 2013, AFL, all rights reserved. OLS0-00-2000 Revision 1A, 2013-11-06
Specifications are subject to change without notice.
OLS Series Light Sources
OLS Series Models and Applications
MODEL
OLS7-FTTx
OLS7-FTTH
OLS7-3
OLS4
OLS2-Dual
OLS1-Dual
Specifications
MM / SM
SM
SM
SM
MM / SM
SM
MM
WAVELENGTHS (nm)
1310, 1490, 1625
1310, 1490, 1550
1310, 1550, 1625
850, 1300 / 1310, 1550
1310, 1550
850, 1300
APPLICATIONS
FTTH Networks
FTTH Networks
Telecom & CATV Networks
Loss Testing of SM/MM networks
SM Networks, LAN/WAN Testing
Ethernet, Token Ring, and FDDI Fiber Links
a
OPTICAL SPECIFICATIONS: OLS7 MODELS
MODEL
OLS7-FTTX (Single Port)
OLS7-FTTH (Single Port)
OLS7-3 (Single Port)
Wavelength (±20 nm)
1310 nm
1490 nm
1625 nm
1310 nm
1490 nm
1550 nm
1310 nm
1550 nm
1625 nm
Spectral Width
5 nm
3 nm
2 nm
5 nm
3 nm
5 nm
5 nm
5 nm
2 nm
Emitter Type
Laser
Safety Class
Class I FDA 21 CFR 1040.10 and 1040.11, IEC 60825-1: 2007-03
Output Power
-5 dBm (typical), 9/125 fiber
Output Stability
±0.05 dB over 1 hour (after 15 minutes warm-up)
±0.1 dB over 8 hours (after 15 minutes warm-up)
Tone Output
270 Hz, 330 Hz, 1 kHz, 2 kHz
OPTICAL SPECIFICATIONS: OLS4, OLS2-DUAL & OLS1-DUAL MODELS
MODEL
OLS4
OLS4
OLS2-DUAL
(MM Optical Port)
(SM Optical Port)
(Single Port)
Wavelength
850 ±30 nm 1300 +30/-20 nm 1310 ±20 nm
1550 ±20 nm
1310 ±20 nm 1550 ±20 nm
Spectral Width
45 nm (typ)
120 nm (typ)
5 nm (max)
5 nm (max)
5 nm (max)
Emitter Type
LED
Laser
Laser
Safety Class
Class I FDA 21 CFR 1040.10 and 1040.11, IEC 60825-1: 2007-03
Output Power
>-20 dBm, 62.5 μm multimode c
0 dBm, 9 μm single-mode
0 dBm, 9 μm single-mode d
Output Stability
±0.1 dB over 8 hours
±0.05 dB over 1 hour (after 15 minutes warm-up)
(after 5 minutes warm-up)
±0.1 dB over 8 hours (after 15 minutes warm-up)
Tone Output
N/A
2 kHz
270 Hz, 330 Hz, 1 kHz, 2 kHz
OLS1-DUAL
(Single Port b)
850 ±30 nm 1300 +30/-20 nm
45 nm (typ)
120 nm (typ)
LED
>-20 dBm, 62.5 μm multimode c
±0.1 dB over 8 hours
(after 5 minutes warm-up)
N/A
GENERAL SPECIFICATIONS: ALL OLS MODELS
Available Adapters
SC FC, ST, LC
Power
2 AA batteries, optional AC adapter
Battery Life
SM port: 72 hours typical (40 hours minimum). MM port: 30 hours typical (20 hours minimum)
Operating Temperature
-10 °C to 50 °C, 90 % RH (non-condensing)
Storage Temperature
-30 °C to 60 °C, 90 % RH (non-condensing)
Size (H x W x D)
14.0 x 8.1 x 3.8 cm (5.5 x 3.2 x 1.5 in)
Weight
0.29 kg (0.65 lb)
Notes:
a. All specifications valid at 25°C unless otherwise specified.
b. May be used to test 50 or 62.5 μm fiber with supplied mandrels.
c. Output power will be approximately 3 dB less if a 50 µm mandrel-wrapped jumper is used instead of a 62.5 µm mandrel-wrapped jumper.
d. Adjustable 2 dB.
www.AFLglobal.com or (800) 321-5298, (603) 528-7780
2
© 2013, AFL, all rights reserved. OLS0-00-2000 Revision 1A, 2013-11-06
Specifications are subject to change without notice.
OLS Series Light Sources
Ordering Information
When ordering, specify connector type at the end of model number (e.g. OLS2-DUAL-SC).
All OLS models include protective rubber boot, 2 AA batteries and carry case. AC adapters are available (ordered separately), see table
below. Test jumpers and connector adapters are required for operation (purchased separately). Test jumpers with a variety of connector
styles and fiber types and adapter caps for most common connectors may be purchased from AFL.
AFL NO.
OUTPUT
PORTS
EMITTER TYPE
AVAILABLE
CONNECTORS
POWER
OLS7-FTTx
1
OLS7-FTTH
1
Laser
FC, SC, ST, LC
(2) AA, AC
Laser
FC, SC, ST, LC
(2) AA, AC
OLS7-3
OLS4
1
Laser
FC, SC, ST, LC
(2) AA, AC
2
LED and Laser
FC, SC, ST, LC
(2) AA, AC
OLS2-DUAL
1
Laser
FC, SC, ST, LC
(2) AA, AC
OLS1-DUAL
1
LED
FC, SC, ST, LC
(2) AA, AC
850
OUTPUT WAVELENGTHS (nm)
1300 1310 1490 1550
1625
WAVE ID
TRANSMIT
OLS AC Adapter and Connector Adapters
DESCRIPTION
FC connector adapter
SC connector adapter
ST connector adapter
LC connector adapter
Universal flip-top dust cap for UCI outputs
100-240 VAC to 9 VDC, AC adapter
AFL NO.
2900-50-0002MR
2900-50-0003MR
2900-50-0004MR
2900-50-0006MR
8800-00-0072PR
4050-00-0119PR
Calibration Plans
In keeping with ISO certification guidelines, AFL recommends 3 years calibration intervals for NOYES OLS Series Sources as guidance for
our customers. It is the responsibility of individual customers to determine actual calibration intervals used align with internal corporate
ISO directives. Additionally, contractors providing services may need to maintain annual calibrations per contractual agreements with
their customers. AFL offers calibration plans for customers preferring annual calibration for their Test and Inspection instruments. Annual
calibrations performed at NOYES calibration facilities ensure your equipment is operating at NOYES specifications. Prepaid Cal plans save
you money by offering two annual calibrations at a discounted price.
MODEL
OLS7-FTTx
OLS7-FTTH
OLS7-3
OLS4
OLS2-DUAL
OLS1-DUAL
AFL NO.
CAL2-00-OLS7-FTTx
CAL2-00-OLS7-FTTH
CAL2-00-OLS7-3
CAL2-00-OLS4
CAL2-00-OLS2-DUAL
CAL2-00-OLS1-DUAL
NOYES International Sales and Service Contact Information
Available at www.AFLglobal.com/NOYES/Contacts
www.AFLglobal.com or (800) 321-5298, (603) 528-7780
3
© 2013, AFL, all rights reserved. OLS0-00-2000 Revision 1A, 2013-11-06
Specifications are subject to change without notice.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement