Timeflow Basin & Wall Mount Bib Taps Installation and Maintenance Guide

Timeflow Basin & Wall Mount Bib Taps Installation and Maintenance Guide
Timeflow Basin & Wall Mount
Bib Taps
Installation and Maintenance Guide
A range of high quality deck and wall mounted time flow taps.
Saves on water usage in comparison to conventional taps by
automatically shutting off the flow of water after 15 seconds.
Specification
Maximum Operating Pressure:
Minimum Operating Pressure:
Maximum Inlet Temperature:
Timed Flow @ 1 Bar:
10 Bar
0.5 Bar
65°C
15 +/- 5 seconds
Installation
Position the chrome cover and rubber indice (red or blue) whichever is
applicable for the hot or cold water supply on the base of the Saracen
timeflow tap.
Insert the threaded inlet through the hole in the basin. Fit the rubber
washer and back nut on to the thread to secure the tap. Do not over
tighten the back nut. The maximum torque should not exceed 25Nm.
Use a swivel connector with a fibre washer (tap connector) to connect
the water supply and make a watertight joint.
Repeat the operation if installing a second tap.
Turn on the water supply to the taps and run the water. Check all
joints for leakages.
1
Aftercare
These taps have a high quality finish and should be treated with care.
An occasional wipe with a mild washing detergent on a damp cloth
followed by a thorough rinsing is all that is required. Do not use an
abrasive or chemical household cleaner as this may cause damage to
the finish.
2
Wolseley UK
Warwickshire, CV31 3HH
For further information please call
01926 705000
or visit www.wolseley.co.uk
ZINS300215_001_07/14
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement