- No category
Installation Instructions 75305 Chrysler Town & Country* Dodge Grand Caravan*
Add to my manuals1 Pages
advertisement
◉
Touch to zoom
Part Numbers: Installation Instructions 75305 44176 Chrysler Town & Country* Dodge Grand Caravan* *Only fits vehicles with Stow ‘n Go Seating Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating or Hitch Shown In Proper Position Equipment Required: Fastener Kit: 75305F Wrenches: 15mm, 18mm Drill Bits: None Hitch type Max Gross Trailer WT (LB) Max Tongue WT (LB) Weight Distributing 4000 (1816 Kg) 400 (182 Kg) Weight Carrying Ball Mount 3500 (1589 Kg) 350 (159 Kg) Wiring Access Location: SUV1, SUV2 Passenger's side Frame rail Tubing Driver's side Frame rail Vehicle Center line M12 fastener removed in Step 2-retain for re-use M12 fastener removed in Step 2-retain for re-use Spring shackle bolts Removed in step 1 Existing weldnuts in vehicle frame Spring shackle bolts Removed in step 1 Blocks oriented long side perpendicular to vehicle Do not remove Center bolt Rear of vehicle 1 Do not remove Center bolt Existing M12 hex bolt assembly Driver’s side Figure 2 Viewed from under vehicle Figure 1 ExistingM10 hex bolt assemblies 1 Qty. (2) 1 Note: Hitch uses all existing fasteners for installation. Block Passenger's side 1. Remove (2) rearmost spring shackle mounting bolts, each side, as shown in Figure 2. Retain bolts for hitch installation. Note: remove only the two outer bolts on each frame rail as shown. It is not necessary to remove center bolts. 2. Remove M12 bolt, just forward of spring shackle, each side, and retain for hitch installation. 3. To raise hitch into position, it will be necessary to pivot one side of hitch as far forward toward axle as possible to manipulate forward mounting tab over leaf spring, then pivot that side into position. Repeat on other side. Note: If spring shackle interferes with installation, use screwdriver to gently pry shackle clear of hitch side bracket. After installation, proper clearance will exist. 4. Install fasteners as shown, re-using existing M10 & M12 fasteners at all attachments. Tighten all M10 CL10.9 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M) Tighten all M12 CL10.9 fasteners with torque wrench to 92 Lb.-Ft. (125 N*M) Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. z 2005, 2006 Cequent Towing Products Sheet 1 of 1 75305N 6-27-06 Rev. C Form: F205 Rev A 5-6-05
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project