Grizzly G0593 Jointer Owner's Manual

Below you will find brief information for Jointer G0593 Spiral Cutterhead and Jointer G0586. The Grizzly Jointer G0593 Spiral Cutterhead is the spiral cutterhead version of the G0586. The spiral cutterhead consists of 36 indexable carbide inserts. Each insert has four cutting edges, which can be easily rotated if the current cutting edge becomes dull or damaged.

PDF Download
Document
Grizzly Jointer G0593 Spiral Cutterhead Instruction Sheet | Manualzz

Advertisement

Advertisement

Advertisement

Key Features

  • Spiral cutterhead
  • Indexable carbide inserts
  • Easy to rotate cutting edges
  • Heavy-duty construction
  • Safety guards
  • Torsion spring
  • Switch components
  • Belt drive
  • Motor mount
  • Dust collection port

Frequently asked questions

What is the difference between the G0593 and G0586 models?

The G0593 is the spiral cutterhead version of the G0586. The key difference is the type of cutterhead, which has indexable carbide inserts in the G0593.

How do I replace or rotate the carbide inserts?

Disconnect the jointer from the power source, clean out the heads of the insert Torx screws, remove the screw, replace or rotate the insert, lubricate the threads of the screw with light machine oil, and torque the screw to 50 inch pounds to tighten the insert.

What is the proper working clearance for the jointer?

Make sure you have adequate working clearance around the jointer to avoid injury. The manual recommends at least 12'' in front, 6'' on the sides, and 18'' behind the jointer.

How do I install the cutterhead guard?

The cutterhead guard is a critical safety feature. It includes a torsion spring that helps it return to position after a cut. The manual provides detailed instructions to install and ensure proper spring pressure.

How do I connect the switch components?

The manual provides instructions to install the switch components, ensuring that the jointer is not connected to the power source until instructed to do so.

What kind of floor load can the jointer handle?

The jointer weighs approximately 149 lbs and requires a floor load that can support over 1,500 lbs.
Preparing document for printing…
0%