I
NSTRUCTION
M
ANUAL
Cylinder Bagless
Vacuum Cleaner
BUSH Helpline: 1800 509 394 Australia
BUSH Helpline: 0800 450 259 New Zealand
2
Introduction
Thank you for purchasing this Bush product which has been designed and manufactured to give you many years of troublefree service.
You may already be familiar with using a similar product, but do please take time to read these instructions - they have been written to ensure you get the very best from your purchase.
Safety is important
!
operate this vacuum cleaner.
Keep this information in a safe place for future reference.
Contents
Introduction......................................................................... 2
Support.............................................................................................. 2
Safety is important ........................................................................ 2
Contents.............................................................................. 3
Specification....................................................................... 5
Model Number.................................................................................. 5
Power Supply ................................................................................... 5
Filtration.............................................................................................. 5
Features............................................................................................... 5
Safety Instructions ............................................................ 6
Power Source ................................................................................... 6
Using the Vacuum Cleaner........................................................... 6
Transporting your vacuum.......................................................... 7
Servicing ............................................................................................ 7
Parts Identification............................................................ 8
Extension Tube................................................................................. 9
Crevice tool /brush......................................................................... 9
Crevice tool storage fixings ....................................................... 9
Floor brush...................................................................................... 10
Using Your Vacuum Cleaner ............................................ 11
Preparing for use........................................................................... 11
Assembly.......................................................................................... 11
Switching on................................................................................... 11
Suction control ............................................................................. 12
Cord rewind.................................................................................... 13
Storage ............................................................................................ 13
Emptying the dust container................................................... 14
Clearing blockages....................................................................... 15
Service and Maintenance ............................................... 16
Dust Container Filter Replacement........................................ 16
Pre motor Filter Replacement.................................................. 16
Cleaning the Exhaust Filter ...................................................... 17
3
4
Troubleshooting............................................................... 18
Thermal cut-out.............................................................................. 18
Disposal............................................................................. 18
Guarantee ......................................................................... 19
Specification
Model Number
• BVC1401
Power Supply
• Power supply 240V AC 50Hz
• 1400W maximum power output
Filtration
• 5 Stage filtration
Features
• 1400 watt cylinder bagless vacuum cleaner
• Aluminum telescopic tube
• Floor brush
• Crevice tool/brush
• Automatic cord rewind
• 2L capacity
5
6
Safety Instructions
This product should never be left unattended when connected to the mains supply.
Power Source
Your vacuum cleaner requires a 240V 50Hz supply. Do not use any other supply.
Using the Vacuum Cleaner
• Do not vacuum wet surfaces, pick up wet objects or use in wet
conditions.
• Do not use the vacuum cleaner to pick-up burning objects as
this is a fire risk!
• Do not pick up hot objects such as coal and ash.
• Do not use the vacuum cleaner to pick-up large objects that are
likely to cause blockage and damage to the vacuum cleaner.
• Do not stand the cleaner on its rear face while cleaning.
• Do not run over the mains cable with your vacuum cleaner.
• For domestic use only. Industrial or commercial use invalidates
the warranty.
• Most new carpets have a running in period in which only light
vacuuming is recommended.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• Do not operate the cleaner without the container and filters
installed.
Transporting your vacuum
• To move your vacuum cleaner from
room to room, unplug the unit and
carry using the carry handle.
• Never pull the vacuum cleaner by
it’s mains power cord when
moving.
Servicing
• With the exception of filters and the dust container, there are no
user-serviceable parts in the vacuum cleaner.
• Contact the BUSH helpline on 1800 509 394 in Australia or
0800 450 259 in New Zealand if you are in any doubt about the
installation, operation or safety of your vacuum cleaner.
• Ensure you replace the filters when necessary.
• Always empty the dust container when indicated on the
vacuum cleaner.
• The plug of the power cord must be removed from the wall
socket before emptying the dust container, cleaning the
appliance or undertaking any maintenance operations.
• If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person
in order to avoid a hazard.
7
Parts Identification
1
2
3
6
7
5
9
4
16
17
15
14
13
12
8
8
10
11
1 Hose handle
2 Suction control
3 Crevice tool storage fixings
4 Crevice tool/brush
5 Aluminum telescopic tube
6 Extension locking catch
7 Floor brush
8 Floor type selector
9 Hose connector release button
10 Dust container
11 Transportation wheel
12 Power On/Off button
13 Floor brush storage catch
14 Carry handle
15 Cable rewind button
16 Dust container release button
17 Hose
Extension Tube
This vacuum cleaner incorporates an adjustable extension tube.
To extend the tube, push the locking catch forward and pull the tube to the desired length. Release the locking catch to lock the tube into position.
Locking catch
Crevice tool/brush
The crevice tool can be used to clean hard to reach places.
Attach it directly to the handle for greater control, alternatively, attach to the extension tube for greater reach.
The crevice tool is fitted with a small brush that rotates forwards and clocks into position for use.
The brush can be removed by rotating the brush back until it clicks into the storage position.
Crevice tool
Brush use
Crevice tool storage fixings
A storage fixings is provided to attach the crevice tool to the hose handle.
Refer to the crevice tool storage picture on page 8.
Attach here
9
Floor brush
Push the extension tube onto the hose handle, then fit the floor brush to the extension tube. Alternatively, the floor brush can be attached directly to the handle if preferred.
Fit the floor brush to the end of the extension tube.
Floor type selector
The selector on the floor brush allows you to choose the most appropriate setting for the type of floor covering.
Height adjustable settings
Floor brush
The brush can be raised or lowered depending on the surface to be cleaned.
10
Brush down Brush up
• The brush down position is intended for use on non-carpeted
floors or short bristled carpets.
• The brush up position is intended for general use on all types of
carpet.
NOTE:
The brush down position can be used on carpets with a longer pile to increase the amount of ‘pick-up’ for ground in dirt, but it also increases the amount of force required to move the brush head over the carpet.
Using Your Vacuum Cleaner
This vacuum cleaner has been designed to operate horizontally. Do not operate in a vertical position as this will block the exhaust and cause overheating.
Preparing for use
Carefully remove your vacuum cleaner from the box. You may wish to store the packaging for future use. This unit is supplied with the dust container fitted. Once assembled, it is ready for use.
Assembly
Push the hose connector into the hose inlet socket until it clicks into place.
To release the hose connector, press the release buttons on top of the connector and pull it out of the hose inlet socket.
Release button
11
12
Switching on
1. Pull the power cable to the desired length. When you are nearing
at the maximum, a yellow marker will be visible on the cable.
A red marker indicates that you have reached the maximum
cable ength.
D
O NOT ATTEMPT TO PULL THE POWER CABLE BEYOND THE RED
MARKER
.
2. Insert the mains plug into a
mains power socket and
switch the socket on.
3. Press the Power On/Off
button to switch the unit On.
Power On/Off button
4. After use, press the Power
On/Off button to switch your
vacuum cleaner Off, then
unplug from the mains
supply.
A
LWAYS UNPLUG YOUR VACUUM CLEANER WHEN NOT IN USE
.
Suction control
A thumb operated suction control is located on the hose handle. This allows you to reduce or increase the amount of suction to suit the vacuuming task.
Maximum suction gives the best results during normal vacuuming, however, reduced suction may be more appropriate if you are vacuuming fabrics or upholstery.
Maximum suction
Reduced suction
Cord rewind
WARNING
T
AKE GREAT CARE WHEN USING THE CORD REWIND BUTTON
,
PARTICULARLY WHEN CHILDREN OR PETS ARE NEARBY
,
AS THE
REWIND ACTION MAY CAUSE THE CORD TO
‘
WHIP
’.
Caution
Always ensure that your vacuum cleaner is unplugged from
the mains supply before using the cord rewind button.
Holding the power cord in one hand, press the carry handle/cord rewind button and carefully feed the cable back into the cleaner.
Cord rewind button
Storage
There is a storage position for the floor brush which can be utilised when storing the vacuum cleaner.
13
14
Emptying the dust container
When the dust container look full or the cleaner loses suction, the dust container will need to be emptied as follows:
1. Unplug the cleaner and open the
dust container by pushing in the
release button.
2. Pull the dust container away from
the cleaner, then hold the container
over a refuse container and remove
the filter.
3. Empty the contents of the dust container, then shake the filter
well taking care not to breathe in the dust. If the filter is blocked
with fine dust, it may be washed in warm soapy water. Rinse
well and allow to dry naturally. DO NOT force dry.
4. Replace the dust container filter, ensuring that it is latched
securely in place. The filter will only fit one way around.
5. Finally, replace the cover - replacement is the opposite of
removal.
Clearing blockages
If the suction still seems to be lower than expected after the dust container bag has been emptied, there may be a blockage in one of the tubes or attachments. Unplug the cleaner and check the following areas for blockages:
c b
• The hose inlet socket (a).
• The joint where the flexible
hose connects to the
attachments (b).
• The inlet to the floor brush (c).
a
If you cannot see the blockage, it may be in one of the knee-joints situated at the end of the plastic hose. To undo these joints, use a flat-bladed screwdriver (or similar tool) to carefully press in the release lugs, then pull the joint apart. Remove any blockage, then push the joint together again until the lugs latch into place.
Release lugs
15
16
Service and Maintenance
Depending on usage you will need to periodically clean the filters.
Refer to the instructions in the following sections.
Caution
The dust container and filters must be fitted before the
vacuum cleaner is used, to avoid damaging the motor.
Dust Container Filter Replacement
The dust container filter should be cleaned regular and replaced every 6 months or when required.
1. Follow the instructions on page 14 and empty the dust
container.
2. Hand-wash the container in cool soapy water.
3. Rinse thoroughly under running water to remove all particles
and soap.
4. Allow to dry naturally.
NOTE: Do not machine wash the dust container and do not attempt to dry using any kind of heated appliance.
5. Refit the container when dry.
Pre-motor Filter Replacement
The pre-motor filter should be cleaned regularly and replaced every six to nine months depending on usage.
1. Remove the dust container as
descrided on page 14.
2. Remove the filter element, take
outside and shake vigorously to
clean.
Pre-motor filter
• Wash the filter in warm soapy water, rinse thoroughly and allow
to dry naturally. DO NOT force dry.
3. Replace the filter and dust container.
• If your cleaner is still not functioning correctly, please contact
the BUSH helpline on 1800 509 394 in Australia or 0800 450
259 in New Zealand.
Cleaning the Exhaust Filter
The exhaust filter should be cleaned regularly and replaced every six to nine months depending on usage.
1. Press the catch on the back of the
filter housing to remove the
exhaust filter cover.
2. Lift out the filter from the back of
the exhaust filter cover.
• Wash the cloth filter in warm
soapy water, rinse thoroughly and
allow to dry naturally. DO NOT
force dry.
3. Replace the filter and refit.
Ensure that the filter housing is locked securely in place before
use.
17
18
Troubleshooting
Thermal cut-out
This vacuum cleaner is fitted with a thermal cut out that protects the cleaner if the motor overheats. If the cleaner stops suddenly of its own accord, follow this procedure:
1 Switch off the vacuum cleaner and unplug from the mains
supply.
2 Check for the source of the overheating problem (blocked hose,
clogged filter etc.).
3 Unblock the hose, empty the dust container and clean the filters
if required.
4 Wait for approximately 30-40 minutes to allow the motor to
cool.
5 After 30-40 minutes, plug in the vacuum cleaner and switch it
on. The vacuum cleaner should now work.
6 If it still does not work, wait another 20 minutes and try again.
If your cleaner is still not functioning correctly, please contact the
BUSH helpline on 1800 509 394 in Australia or 0800 450 259 in
New Zealand.
Disposal
At the end of its useful life, please dispose of this
vacuum cleaner in an environmentally friendly manner.
Guarantee
Please keep your receipt as proof of purchase. This product is warranted for any defect in materials or workmanship for one year after the original date of purchase. This product is for normal domestic and office use only. This warranty does not cover damage from misuse or neglect, accidental damage, vermin infestation, excessive voltages such as lightning or power surges or any alteration that affects the performance or reliability of the product.
If guarantee is required please contact the BUSH helpline on
1800 509 394 in Australia or 0800 450 259 in New Zealand.
Have your receipt of purchase on hand.
This guarantee is subject to the following provisions
• It is only valid within the boundaries of the country of purchase.
• The vacuum cleaner must be correctly assembled and operated
in accordance with the instructions contained in this manual.
• The vacuum cleaner must be used solely for domestic purposes.
• The guarentee will be rendered invalid if the vacuum cleaner is
resold or damaged by inexpert repair.
• The guarantee does not cover accidental damage, misuse,
cabinet parts or consumable items.
• The manufacturer disclaims any liability for incidental or
consequential damages.
This guarantee is in addition to, and does not diminish, your statutory or legal rights.
19
BUSH Helpline: 1800 509 394 Australia
BUSH Helpline: 0800 450 259 New Zealand
PO BOX 6287, SILVERWATER NSW1811 www.bushaustralia.com.au
