Undercounter Dishwasher
Undercounter Dishwasher
PRODUCT MODEL NUMBERS
Drain Air Gap
Air gap
UDT555SAFP
Minimum Clearances
NOTES:
■■ Corner
locations require 2" (5.1 cm) minimum clearance
between the side of the dishwasher door and the wall
or cabinet.
■■ A minimum of 255/8" (65.1 cm) is required in front of the
dishwasher to allow the door to open fully.
■■ Opening should be square, and the floor should be level.
■■
Use 1/2" minimum I.D. drain line fittings.
NOTE: Do not connect drain lines from other devices to the
dishwasher drain hose.
Water Supply Requirements
Countertop
■■ A
hot water line with 20-120 psi (138-862 kPa) water pressure.
(49°C) water at dishwasher.
■■ 3/8" O.D. copper tubing with compression fitting or flexible
stainless steel braided fill line
NOTE: 1/2" minimum plastic tubing is not recommended.
■■ 120°F
Dishwasher
■■ A
90° elbow with 3/8" N.P.T. external pipe threads on one end.
IMPORTANT: Do not solder within 6" (15.2 cm) from water
inlet valve.
255/8"
(65.1 cm)
Product Dimensions
24" (61 cm)*
2" (5.1 cm) min.
clearance for door
opening
321/2" to 341/2"
(82.6 cm to 87.6 cm)
Electrical Requirements
■■ 120
■■
volt, 60 Hz, AC-only, 15 or 20 amp., fused electrical supply
Copper wire only, 2-wire with ground
Recommended:
■■ Time-delay
■■ Separate
fuse or circuit breaker
circuit
165/8"
(42.2 cm)
Drain Requirements
the new drain hose supplied with your dishwasher.
NOTE: If a longer drain hose is required:
21/2"
(6.2 cm)
■■ Use
*To front of door frame
■■ Use
a new drain hose with maximum length of 10 ft (3 m)
that meets all current AHAM/IAPMO test standards.
■■ Use a new drain hose that is resistant to heat and detergent.
■■ Use a new drain hose that fits the 1" (2.5 cm) drain
connector on the dishwasher.
■■ Connect drain hose to waste tee or disposal inlet above
drain trap in house plumbing.
■■ Connect drain hose to house plumbing 20" (50.8 cm)
minimum above the floor.
NOTE: It is recommended that the drain hose either be looped
up and securely fastened to the underside of the counter, or be
connected to an air gap.
SIDE VIEW
235/8"
(59.8 cm)
■■ Use
an air gap if the drain hose is connected to house plumbing lower than 18" (45.7 cm) above the subfloor or floor.
REAR VIEW
Because Whirlpool Corporation policy includes a continuous commitment
to improve our products, we reserve the right to change materials and
specifications without notice.
Dimensions are for planning purposes only. For complete details, see
Installation Instructions packed with product. Specifications subject to
change without notice.
Page 1 of 2
W10703184-D-WH
5/16
Installation Clearances
Cabinet Cutout Dimensions
NOTES:
■■ Cut
323/4" to 341/2"*
(83 cm to 88 cm)
All surfaces must be
free from instrusions
holes in shaded area of cabinet walls or floor for plumbing
and electrical service.
■■ ADA installation, 321/2" (82.5 cm) beneath 34" (86.4 cm) high
countertops may be accomplished by adjusting the toekick
and leveling legs.
24"
(61 cm)
min.
4"
(10.2 cm)
6"
(15.2 cm)
24" (44.8 cm)
maximum
* Underside of countertop to floor
Custom Panel Dimensions and Installation
+
m) )
0 c 0 cm21.26" (54.0 cm)
2
.
.1
(0
8" " (0
0.0 0.40
-φ
12 deep
le
Ho
0.59" (1.5 cm)
22.36" (56.8 cm)
1.18" (3.0 cm)
26.78" (68.0 cm)
19.65" (49.9 cm)
6.79" (172.5 mm)
2.56" (6.5 cm)
Custom panel should be constructed according to diagram below.
10" (25.4 cm)
1.50" (3.8 cm)
9.84" (25.0 cm)
23.39" (59.4 cm)
(Unit: inch/cm )
Install the hook on the custom panel and insert the hook into the slot on the outer door of the dishwasher. After positioning the panel,
attach the panel to the outer door with screws and bolts.
Because Whirlpool Corporation policy includes a continuous commitment
to improve our products, we reserve the right to change materials and
specifications without notice.
Dimensions are for planning purposes only. For complete details, see
Installation Instructions packed with product. Specifications subject to
change without notice.
Page 2 of 2
W10703184-D-WH
5/16
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising