CMK04
CMK04
Please keep this instruction sheet for future reference,
as it contains important information.
Requires four D (LR20) alkaline batteries (not included) for operation.
Adult assembly is required. Tool required: Phillips screwdriver (not included).
fisher-price.com
1
Consumer Information
WARNING
Prevent Entanglement Injury
• Keep mobile out of baby’s reach.
• Remove mobile portion of product from crib or playpen when baby begins to
push up on hands and knees.
• This product may not attach to all crib designs. Do not add additional strings or
straps to attach to a crib or playpen.
• Use ONLY attached to a crib.
• Use as a mobile from birth to 5 months.
• The base portion of this product can be used from birth until 36 months.
• A mobile is intended for visual stimulation and not to be grasped by a child.
Care
• Wipe this toy with a clean, damp cloth. Do not immerse.
Industry Canada (IC) Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of
the device.
Canada, avis d’Industry Canada (IC)
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil
ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
2
Smart Connect ™ App Download Information
• Some features of this product only work with the Fisher-Price® Smart Connect™ app.
• Download the Fisher-Price® Smart Connect™ app to control the crib mobile/soother from your
smart device (not included). This app is available from the App StoreSM or Google Play™.
• The Smart Connect™ app is compatible with most iOS and Android™ devices. Please refer to
the chart on the last page of this instruction sheet for a list of compatible devices. Device
not included.
3
Consumer Information
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
CONSUMER ASSISTANCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.
Apple, iPhone, iPad, iPod touch and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other Countries.
App Store is a service mark of Apple Inc.
Google Play and Android are trademarks of Google Inc.
©2014 Mattel. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, except as noted.
PRINTED IN CHINA
4
CMK04_1100620193_DOM
Battery Installation
1,5V x 4
D (LR20)
For longer life, use
alkaline batteries.
• Loosen the screws in the battery compartment door and remove the door.
• Insert four D (LR20) alkaline batteries.
• Replace the battery compartment door and tighten the screws. Do not over-tighten.
• If this product begins to operate erratically, you may need to reset the electronics. Slide the
power switch off and back on.
• When sounds/lights/projection become faint or stop, it’s time for an adult to change
the batteries.
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from the
product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under adult supervision.
5
Assembled Parts
Canopy
Arm
Crib Adaptor
Mobile Base
Mobile Adaptor
Note: All of the screws used to assemble this toy are attached to the product. Follow these
instructions carefully to fully secure the screws. Tighten and loosen all screws with a Phillips
screwdriver. Do not over-tighten the screws.
6
Assembly
Canopy
Arm
1
• Fit the canopy onto the peg on the end of the arm. Push to “snap” in place.
Mobile Adaptor
2
• Fit the arm into the socket in the mobile adaptor. Push to “snap” in place.
7
Assembly
Mobile Base
3
• Fit the mobile assembly onto the back of the mobile base. Tighten all four screws.
Crib Adaptor
4
• Fit the crib adaptor onto the mobile adaptor. Tighten the two screws.
8
Crib Attachment
IMPORTANT! Always attach all provided fasteners (strings, straps, clamps, etc.) tightly to a crib
or playpen according to the instructions. Check frequently.
B
Crib Rail
A
D
1
C
Attachment Strap
Peg
• Position the toy inside the crib. Make sure the attachment strap is on the outside of the crib A .
• Slide the end of the attachment strap down through the slot on the back of the toy B .
• Pull the end of the attachment strap up and fasten to the peg on the back of the toy C .
Note: This toy should be snug against the crib rail and spindles. Use the strap slot that provides
the tightest fit.
• If you have excess strap, slide the free end of the attachment strap up through the opening near
the top of the attachment strap D .
9
Crib Attachment
2
• Tie the toy’s strings to a crib spindle.
Note: It is better to tie the strings in a knot than a bow, since a bow may be easily untied.
7” (18 cm)
3
• If the distance between the base and the mattress is less than 7 inches (18 cm), lower the
crib mattress.
10
Use
Light Button
Press to turn the check
light ON or OFF.
Hint: The check light times
out after approximately one
minute.
Volume Buttons
Press to adjust the
volume level.
Mobile/Projector Button
Press to turn on the mobile
and projector. Press the
button again to turn on
the mobile only. Press the
button again to turn off
the mobile.
Music/Sound Selection
Buttons
Press to turn on white
noise. Press again to
turn off white noise.
Press to turn on sound
effects. Press again to
turn off sound effects.
Press to turn on music.
Press again to turn off
music.
Hint: Press the music or
sound effect button a third
time to play a different
song or sound effect.
Power Switch
Slide the power switch
or OFF.
11
ON
Convert to Soother
A
C
B
• Remove the mobile from the crib.
• Loosen the screws in the crib adaptor and remove it A .
• Loosen the screws in the mobile assembly and remove it B . Store the mobile in a safe place for
future use.
• Fit the crib adaptor onto the back of the soother and tighten the screws C .
• Attach the soother to the crib. Please refer to the Crib Attachment section for instructions.
12
Pairing Your Device
Before using the Smart Connect™ app for the first time,
you will need to pair your device with the mobile.
Pairing Button
• Open the Smart Connect™ app on your device. Be sure your device is within approximately 6 ft
(1,8 meters) of the mobile to pair.
• Next, slide the mobile power switch ON.
• Then, press the pairing button on the back of the mobile. The mobile will stay in the pairing
mode for approximately 30 seconds.
Hint: If you cannot pair your device with the mobile, try moving the device closer to the mobile.
• The mobile icon will be highlighted in green in the app when the mobile is connected to your
device. This indicates that you can use your device to control the mobile.
13
Smart Connect™ App
Press the switch icon to
turn the Smart Messages
ON or OFF. When Smart
Messages are enabled
you will receive pop-up
notifications on your
device to tell you the
status of your mobile.
Press the mobile icon to
open the mobile controls.
Press the Music on the
Go icon to play mobile
songs from your device.
Press the back icon to
return to the home screen.
Press the play/pause icon
to start or stop music.
Press the forward or
reverse icons to change
the song.
Press the animation icon
to choose a display image
for your device.
Press the playlist icon
to create a custom
playlist from songs on
your device.
14
Smart Connect™ App
Press to connect or
disconnect your device
from the mobile.
View your device status here:
You’re Connecting, You’re
Connected, You’re Not
Connected or Your mobile
is out of range, turned off
or asleep.
Press to choose how long
the mobile will stay on.
Press to turn the check
light ON. Press the icon
again to turn the check
light OFF.
Press to turn the mobile
ON. Press the icon again
to turn the mobile OFF.
Press to turn the mobile
and projector ON. Press
the icon again to turn the
mobile and projector OFF.
Press to choose
how long music/
sounds will play.
Press to turn the music/
sounds ON. Press the icon
again to turn music/sounds
OFF. Press the music or
nature sounds icon a third
time to play a different
song/sound effect.
Press to adjust
volume level.
Hint: Music/sound
effects must be ON
to use this feature.
Press to turn the Sound Sensor
Smart Messages ON. Press the icon
again to turn OFF.
Hints: This feature can only be used
when music/sounds and mobile/
projector are turned OFF. The
sound sensor will display a pop-up
message if a sound is detected in
baby’s room.
Press to customize
mobile name.
Slide to adjust the
sensitivity level of
the sound sensor.
15
This icon displays the
battery life of your
mobile. When the battery
icon turns red or is at
0%, it’s time to replace
the batteries.
Smart Connect ™ App Compatibility
The Fisher-Price® Smart Connect™ app is compatible with the devices listed in the table.
APPLE
ANDROID
• iPhone (6 Plus, 6, 5S, 5C, 5 & 4S)
• iPad (mini with Retina display, mini, Air,
4th & 3rd gen) or newer
• iPod touch (5th gen)
• Google Nexus 5, Nexus 4
• Google Nexus 7 (2013), Nexus 10
• HTC One, One Max
• Motorola Moto G, X
• Samsung Galaxy S3 or newer
• Samsung Galaxy Tab 4, Pro, S or newer,
Galaxy Note 3, Galaxy Note 8, 10.1, Pro
12.2, or newer, Galaxy Mega
• Sony Xperia (SP, Z, ZR, ZL, Z1, Z Ultra
HSPA+)
• Sony Xperia Tablet Z
As technology changes, this app may become compatible with additional devices.
Visit fisher-price.com/SmartConnect for an up to date, complete list of compatible devices.
16
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising