Oransi Finn OVHT9908 air purifier OWNER’S MANUAL

Below you will find brief information for air purifier Finn OVHT9908. The Finn OVHT9908 air purifier features a 3-speed fan, UV-C lamp and a HEPA filter to remove dust, pollen, pet dander, mold spores, bacteria, and viruses from the air. The unit can be set to run continuously or on a timer in 1-hour intervals up to 8 hours.

PDF Download
Document
Oransi Finn OVHT9908 Air Purifier Owner's Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • 3-speed fan
  • UV-C lamp
  • HEPA filter
  • Timer function
  • Ionizer
  • Pre-filter

Frequently asked questions

Use the brush attachment with your vacuum cleaner to clean the filter. Do not use water or any household cleaner to clean the HEPA filter.

The HEPA filter can be used continuously for up to two years. When the HEPA filter turns from white to black, it should be replaced with a new one. If the HEPA filter is still white, it does NOT need to be replaced.

Turn off and unplug the unit, remove the rear cover, remove the HEPA filter, use a screwdriver to remove the two screws and detach the UV lamp cover, grasp the UV lamp and pull it straight out from the lamp socket, take a new UV lamp and insert it into the lamp socket, re-install the UV lamp cover, then install the filter and rear cover.

After cleaning the HEPA filter, RESET the HEPA filter by using a pin or needle to press the HEPA RESET Button, then the icon will stop flickering.

After replacing the UV lamp, reset the UV lamp by pressing the UV Button for a few seconds, the UV icon will stop flickering and the new UV lamp will start to work.
Preparing document for printing…
0%