Belkin Router Setup for Dynamic IP Address

Belkin Router Setup for Dynamic IP Address
Belkin Router Setup for Dynamic IP Address










Unplug the DSL modem.
Take the cable out of the existing computer and plug it into the Modem port on the router.
Take the cable that came with your router and plug it into the computer and one of the
LAN ports (numbered) of the router.
Before plugging the power cord into the router, plug the cord into the wall, then plug the
cord into the router’s power jack.
Verify that your router is connected properly by checking the lights on the front of the
router. The green light labeled “Modem” should be ON and one of the numbered ports
should be have a light that corresponds with the port you used.
Open Internet Explorer, you should now be connected to the Internet.
Log into the router to set up your wireless security. Enter 192.168.2.1 in your Browsers
address line and click go or press Enter.
Leave the password blank and click submit, you will be able to create your own
password.
Once logged into the router, click "Wireless" to set up your security settings.
Select Security Tab to set up your wireless security.
Do not operate your router without implementing wireless security. You may find out more
about wireless network security by clicking here. You may also consult your router
documentation located on your router CD. NOTE: It is very important to use wireless security to
avoid access to your network and someone hijacking your Internet connection. If someone uses
your connection, you are responsible for their actions.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising