Cortelco 123 External Ringer Features • • • • • Loud Ringer Volume Visual Indication of Ringing Hi/Lo Ringer Volume Switch Desk/Wall Mountable Loudness: 85 dBSPL Low 96 dBSPL High measured 18 inches from device Installation 1. Connect the line cord from the telephone jack to the LINE JACK (2) of the 123 Ringer. 2. Using the supplied short line cord, connect the TEL JACK (1) of the 123 Ringer to the telephone. Note that it is not necessary to connect a telephone to use the 123 Ringer. 3. Adjust the volume to Hi or Lo using the volume switch (3). Customer Information 1. This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On bottom of this equipment is a label that contains, among other information,a product identifier of US:6AHMO38BR-123. If requested, this number must be provided to the telephone company. 2. If this equipment, Cortelco 123 External Ringer, causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. 3. The telephone company may make changes in this facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modification to maintain uninterrupted service. 4. If you experience trouble with this equipment, you disconnect it from the network until the problem has been corrected or until you are sure that the equipment is not malfunctioning. 5. Please follow instructions for repairing if any (e.g. battery replacement section); otherwise do not alternate or repair any parts of device except specified. 6. Connection to party line service is subject to state tariffs. Contact the state public utility commission public service commission or corporation commission for information. 7. If the telephone company requests information on what equipment is connected to their lines, inform them of: a) The telephone number that this unit is connected to, b) The ringer equivalence number (REN) 3.8B c) The USOC jack required, RJ11C, and d) The FCC Registration Number US: 6AHMO38BR-123 Items (b) and (d) are indicated on the label. The REN is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0). If too many devices are attached, they may not ring properly. FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and the receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project