advertisement
WWW.PHIHONG.COM
80W Power over Ethernet Midspan
High Power Single Port Injector
Features
Fully Compliant Detection, Disconnect and Voltage Control per IEEE802.3af
Diagnostic LEDs
Gigabit Compatible
1 Year Warranty
Applications
Satellite Receiver
Wireless Network Access Points
LCD Displays
Safety Approvals
cUL/UL
CE
C-Tick
IRAM
Mechanical Characteristics
Length: 203mm (8in)
Width: 108mm (4.25in)
Output Specifications
Single Source 4-Pair Powering
Wide Operating Temperature Range
Full Protection OCP, OVP, OTP
Broken Wire Detection
Security Cameras
Kiosks
Computer Workstations
CCC
SAA
Korea (PHC)
Height: 63mm (2.5in)
Weight: 1.93Kg (4.5lbs)
Model
DC Output
Voltage Min.
Load
Max. Line
Regulation
Load
POE80U-560(G) +56V 0A 0.72A 54-57V DC
Note: Output measured over data and spare pairs for combined 1.43A output.
Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information.
Revision 3/2/2015
POE80U Characteristics
INPUT:
AC Input Voltage Range
85 to 264VAC
AC Input Voltage Rating
100 to 240VAC
Input Frequency
47 to 63Hz
AC Input Current
2.0A (RMS) maximum for 90VAC
1.2A (RMS) maximum for 240VAC
AC Inrush Current
50A (RMS) maximum for nominal input
OUTPUT:
Total Output Power
80W
DC Offset
No data degradation with DC imbalance 18mA per min.
Ripple and Regulation (P-P)
100mV maximum
Efficiency
75% (typical) at maximum load, and 120VAC 60Hz
Hold-up Time
10mS min. 120VAC and maximum load
Transient O/P Votlage Protection
60V maximum at switch on/off at any point on the
AC line phase
ENVIRONMENTAL:
Temperature
Operation -40 to 55C
Non-operation -50 to +85C
Humidity 5 to 90%
EMC
FCC Part 15 Class B, EN55022 Class B
WWW.PHIHONG.COM
Isolation Test
Primary to Secondary: 4242VDC for 1 minute,
10mA
Primary to Field Ground: 2121VDC for 1 minute
Output to Field Ground: 2121VDC
Immunity
ESD: EN61000-4-2 Level 3
RS: EN61000-4-3 Level 2
EFT: EN61000-4-4 Level 2
Surge: EN61000-4-5 Level 3
CS: EN61000-4-6 Level 2
Voltage Dips: EN61000-4-11
Harmonic: EN61000-3-2
Insulation Resistance
Primary to secondary: >10M OHM 500VDC
Primary to Field Ground: >10M OHM 500VDC
IEEE802.3af/at Interoperability
UNH Interoperability report available upon request
FEATURE:
Detection
12.5K ohm detection resistor value required to turn on full power (4-pairs)
Over Voltage/Current, Short Circuit
Protection
Outputs equipped with short circuit protection dn overload protection as per 802.3af specifications except max average pair current is 0.72A, Peak
1.4A per pair. The output can be shorted permanently without damage.
Indicators
Green LED 1: DC Power “ON”
Red LED: Fault detected
Green LED 2: Power detected “CONNECT” at
80W
Input Connector
IEC320 inlet 3 pin
Output Connection
Pins 3,6, 4,5(+) Pins 1,2, 7,8 (-)
Warranty
1 Year
Dimension Diagram Unit: mm WWW.PHIHONG.COM
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project