Tauris CMW 624 flat panel wall mount Instruction manual

CMW - 624
Professional Installer Highly Recommended - The bracket manufacturer will not warrant any faulty installations, and damage to panels or any other fixtures / fittings as a result of incorrect installation.
STEP 1 Attach bracket to the wall.
STEP 2 Attach plastic covers to arm bracket.
IMPORTANT: PRE-DRILL HOLES
Make sure bracket is secured to stud,
or anchors are used for brick or concrete.
2
Find stud and select position
for arm bracket (1) on the wall.
4
Once the arm bracket (1)
is firmly attached to the
wall, attach the plastic
covers (2) to the base of
the arm bracket to
conceal bolt holes.
Level bracket and mark holes
with a pencil then drill pilot
holes.
Using a screwdriver fix arm
bracket to the wall with
screws (4).
If fixing to brick or
concrete use plastic
anchors (5).
1
1
4
STEP 3 Attach face plate to back of the TV.
STEP 4 Hook TV onto arm bracket.
1
3
7
9
8
Once the face plate (3) is
securely fastened to the
back of the TV, hook the
TV onto the arm bracket (1)
and secure into place with
both screw caps (7) and
washers (8,9).
Locate screw fixtures in the back of your TV and attach
face plate (3) using the screws provided.
The screw size required will vary on each TV so we
have provided you with a range to choose from
(M3, M5, M6, M8).
3
PROFILE VIEW
STEP 5 Adjusting tilt.
3
You can easily adjust the tilt of
the TV by simply loosening the
screw caps on either side of the
arm bracket (1)
1
Secure screw caps (7) tightly
for a fixed position or leave
slightly loosened for an
adjustable platform.
7
ADJUST
TILT HERE
7
www.tauris.com.au
DISTRIBUTED BY RVM AUSTRALIA t: (08) 9417 9944 e: [email protected]
Mar 2012
CMW - 624
4.
5.
6.
7.
8.
9.
PARTS DRAWN TO SCALE 1:1
M5
M3
M8
M6
x4
Spring
Washer
Spring
Washer
Spring
Washer
x4
x4
x4
NOTE: Use spring washers when securing bolts. This will reduce the risk of bolts coming loose.
ADDITIONAL TOOLS REQUIRED
A phillips head
screwdriver will be
required wherever you
see this icon.
A drill will be required to drill
pilot holes for the wall bracket.
Masonry Wall - 7mm bit
Studded Wall - 4mm bit
PARTS LIST
No.
Part
1
2
3
4
5
Arm Bracket
Plastic Cover
Face Plate
Wall Screw
Masonry Anchors
Qty No.
1
1
2
3
3
6
7
8
9
Part
Spacer L20
Screw Cap
Washer ø6 ø18
Spring Washer
Qty
4
2
2
2
www.tauris.com.au
DISTRIBUTED BY RVM AUSTRALIA t: (08) 9417 9944 e: [email protected]
Mar 2012
">