In The Box
WF720
In The Box
1.
2.
3.
4.
5.
Getting to Know Your Device
WF720 Wireless Home Phone Base Station
Phone Cable
Back-up Battery
Power Adapter
Quick Start Guide
Power
Voicemail
Battery Charge Signal Strength
Green: New message Green: High
Green: On
No Color: Off waiting (Blinking)
Yellow: Medium
No Color: No message Red: Low
waiting
Battery Cover
Green: Strong
Yellow: Weak
Red: No Service
Power Button
Service Port*
Antenna Port
On/Off
Telephone Ports
Power Port
1
2
Before You Begin
Install the SIM Card and the Battery
Your device works exclusively with your wireless service
providers’ cellular network and DOES NOT use your home’s
phone wall jacks.
Your device should be located:
 Where you have a strong cellular signal from a cell tower,
typically near a window or outside wall.
 Near an electrical wall outlet.
1.
2.
3.
4.
3
Remove the cover from the battery compartment.
Insert the SIM card in the SIM card slot.
Insert the battery connection cable into the battery port.
Place the battery in the battery slot and replace the battery
cover.
1
2
3
4
4
Connect the Device to a Phone
Turn on Your Device
1. Unplug your phone from your home’s phone wall jack.
1. Plug the power adapter into an electrical wall outlet.
2. Insert the small end of the power adapter into the Power
port on the back of your device.
3. Press and hold the power button about 8 seconds until the
signal strength light comes on.
2. Plug your phone into the “Phone 1” port on the WF720,
using your existing phone cable or included phone cable.
NOTE: Put the device at least 2.5 meters away from the connected phone, TV sets, radio and other electronic devices to
avoid electromagnetic interference.
DECT (Digital Enhanced Cordless Telecommunications)
Phone: To avoid electromagnetic interference between DECT
phone and the device, be sure the distance between DECT
phone and the device is 0.5 meter at least.
5
6
Check the Wireless Signal
Make a Call
1. Raise antenna to an upright position.
2. Confirm signal strength light is green for optimal performance.
Make a call from your connected home phone.
NOTE: If you have a cordless phone, keep it plugged into a
power outlet.
7
8
PIN Lock
Useful Tips
Refer to the following table to check your SIM card status, and
perform the corresponding action.

SIM Status
Light Indicator
Action
PIN Locked
Signal indictor: No
colour;
Battery Indicator:
Green blinking
Enter PIN code and
then the “ #” Key.
PUK locked
Signal indictor: No
colour;
Battery Indicator:
Yellow blinking
Enter PUK code, the
“*” Key, New PIN, the
“*” Key again, New
PIN again, and then
the “#” Key.
SIM card
permanently
locked
Signal indictor: No
colour;
Battery Indicator:
Red blinking
Contact your service
provider.
Dial “1” to access your voicemail. To access or set-up your
voice mail, simply press and hold the “1” key, or press *98.
 The “Phone 2” port can be used to connect an additional
phone, or cordless base station. All telephones connected
to the wireless home phone base station will use the same
telephone number.
For more information, please refer to the detailed User Guide
online at www.rogers.com/userguide.com or www.fido.ca
NOTE: When you enter wrong PIN code for 3 times, the SIM
card will be PUK locked; When you enter wrong PUK code for
10 times, the SIM card will be permanently locked.
9
10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement