Document

Document
1
2
ATTACH THE ADF TRAY EXTENSION
3
Attach the cover
b
Make sure you are using the
correct side of the poster.
Q1636-90196
*Q1636-90196*
*Q1636-90196*
a
Slide the automatic document feeder (ADF)
tray extension into the top of the unit.
Match the gray tabs with the black slots.
See your box for exact contents and
system requirements. Windows users:
See other side.
3
a
Insert the two tabs of the cover into the
top slots on the unit.
b
Tilt the cover down and press firmly.
Make sure the tabs lock into place and
the cover is even with the unit.
a
b
c
4
Step 3 continued
Remove output tray and load paper
5
Connect the USB cable
6
Connect the power cord and phone cord
Use blank white paper to
prepare for print alignment.
To wall jack
1
2
Turn on your HP OfficeJet
To phone
3
1
d
g
7
If you have an iMac, your USB port is on the side. Do not connect the HP OfficeJet to a
USB port on a keyboard or non-powered USB hub. See reference guide for more details.
Insert the print cartridges
c
2
Black label (56)
hp officejet 6100 series all-in-one
Macintosh setup poster
Make sure to remove any packing
material from inside the unit.
a
e
b
g
f
d
c
a
8
Lift the print carriage door up until it
catches. Wait for the print carriage
to move to the center. Lift the blue
and gray latches.
b
Remove the bright pink tape from
the print cartridge. Do not touch the
gold-colored contacts or retape the
cartridges.
d
Color label (57)
Hold the black print cartridge with the label on top as shown.
Slide the cartridge into the right (gray latch) side of the print
carriage.
Hold the color print cartridge with the label on top as shown.
Slide the cartridge into the left (blue latch) side of the print
carriage.
e
Pull the end of the gray latch toward you, press
down until it stops, and then release. Make sure
the latch catches below the bottom tabs.Repeat
with blue latch.
9
Install the software
f
Make sure both latches are
locked into position. Close the
door.
g
Press Enter to begin alignment. After
a page prints, alignment is complete.
Discard or recycle this page.
Try your new HP OfficeJet
Note: See the reference
guide for adjusting the
display viewing angle.
a
Turn your Macintosh on and
wait for your Macintosh to
finish starting up. Insert the
HP OfficeJet software CD.
b
Double-click the HP AllIn-One Installer icon on
your desktop.
c
Follow the onscreen instructions.
You may have to restart your
Macintosh during setup. Be sure to
complete the setup assistant.
Whats next?
Take the product tour
Use the Director
Click the reference guide for
other ways to get started with
your HP OfficeJet.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement