Printek Mt3-II Series Mobile Thermal Printer Quick Setup Instructions
Printek Mt3-II Series Mobile Thermal Printer is a versatile and portable printing solution designed for various applications. With its compact size and wireless connectivity options (Bluetooth and Wi-Fi), it offers mobile printing convenience. The printer supports IrDA and RS-232C interfaces for flexible data transfer. It features a user-friendly control panel for easy operation and can perform self-tests to ensure proper functioning.
PDF
Download
Document
Advertisement
Advertisement
Printek Mt3-II Series Quick Setup Instructions Important: You must charge the battery for 24 hours prior to the first use. PAPER ROLL Maximum battery capacity is reached after completing a minimum of (3) P/N #91254 (Case of 35 rolls) normal usage charge and discharge cycles. Always use Genuine Printek Paper to ensure optimal performance. To load paper, pull on the Paper Door Handle to open the Paper Door. Drop in paper roll as shown in diagram. Close Paper Door. To load battery, slide Battery Door Release forward, and then open the Battery Door. Insert the Battery as described on the label inside the battery compartment. Close the Battery Door, and then slide the Battery Door Release back to the locked position. 6. To unload battery, slide the Battery Door Release forward, and open the Battery Door. At this point the battery can be removed. О 7. To perform the self test, press and hold the PAPER FEED button, and then press the ON button. 8. Note: For additional detailed information, please refer to the Operator's Manual. A copy of this manual can be downloaded by visiting www.printek.com a ке Na PAPER DOOR HANDLE MAG CARD READER (OPTIONAL) IrDA WINDOW POWER ON INDICATOR (GREEN for Serial/IrDA) (BLUE for Bluetooth/WiFi) POWER ADAPTER INPUT BATTERY CHARGING INDICATOR (AMBER) PAPER FEED BUTTON ERROR INDICATOR (RED) MCR READY INDICATOR (GREEN) ON/OFF BUTTON BATTERY — P/N 91304 PRINTEK— P/N #5998 Rev A Printek Mt3-II Series Quick Setup Instructions Default Wi-Fi Configuration: IP Address: 192.168.150.150 Subnet Mask: 255.255.255.0 Gateway Address: 0.0.0.0 DHCP: Disabled Wi-Fi Type: Ad-Hoc Add-Hoc Channel: 3 WEP Level: 0 (Disabled) SSID: Printek Print Port: 8023 Switch Settings Switch Position(s) | Function SW1 IrDA Interface OFF Disabled ON Enabled SW2 RS-232C Interface OFF Enabled ON Disabled SW3 Bluetooth/Wi-Fi Interface OFF Disabled ON Enabled SW4 SWS Baud Rate OFF OFF 38,400 OFF ON 19,200 ON OFF 9,600 ON ON 2,400 SW6 SW7 Parity OFF X No Parity ON OFF Even Parity ON ON Odd Parity SW8 Reserved PRINTEK— Innovative Business Printing Solutions Ph: (800) 368-4636 Fax: (269) 925-8539 Web: www.printek.com E-mail: [email protected] Align the battery terminals with the printer terminals as shown cont. The configuration settings below are for Bluetooth and WiFi. The configuration settings above are for Serial. SW4, SW5, Sw6, SW7 must be set to match the host settings. The configuration settings above are for IrDA. SERIAL INTERFACE ">

Public link updated
The public link to your chat has been updated.
Advertisement