INSTALLATION INSTRUCTIONS
USB ADAPTER KIT i-MiEV
PART NUMBER: MZ360382EX
TOOLS REQURED
(10)
Phillips stubby screwdriver Phillips stubby screwdriver (Long) Socket wrench
Trim remover Tape Shop rags Isopropyl alcohol or Degreaser
MZ360382EX
1 2 3
PRECAUTIONS
Be sure to apply the parking brake securely.
Remove the ignition key from the key cylinder.
Disconnecting the (–) cable from the battery causes the radio and audio presets, the clock, etc. to lose their memory. Record the contents of the memory before disconnecting the battery negative cable so that you can reprogram the radio presets after completing the installation.
- 1 -
2011.09 JI261386
Before installation
Be sure to disconnect the negative terminal cable from the battery.
When installation or removing parts
Loosen or tighten bolts and nuts using tools
Use a Phillips screw- driver that fits the that match their sizes. recess in the head of the screw being loos- ened or tightened.
To remove plastic parts, use a trim remover.
Wiring
When disconnecting connectors, first unlock them, then separate the connectors by pulling on themselves, not on cables.
When connecting con- nectors, push them against each other until the lock clicks.
Do not pull on wiring harnesses strongly.
Do not let harnesses be pinched between parts.
Route the harness away from hot compo- nents such as the engine and radiator.
Protect the harness from sharp edges by covering the edges with tape or other suitable materials.
Apply sealant to grom- mets at portions where the harness run through.
Do not fasten the har- ess to brake pipes or high pressure air condi- tioner pipes.
Clamping harness
Fasten the additional harness to an existing vehicle harness using tape or tie wraps.
Bind up extra length of the harness using a tie wrap.
If one tie wrap is too short, use two con- nected together.
After installation
Check the product and wiring for installed con- dition before connect- ing the cable to the battery.
Check the installed product for function.
Also check lamps, horn, wipers, etc. for proper operation.
- 2 -
A-01
A-03
A-05
A-04
To protect
A-06
A-07
To protect
A-08
- 3 -
B-01
B-02 a b
2 c d
B-03 b a
2
B-04 c d
- 4 -
B-05
Isopropyl alcohol or Degreaser
2
3
C-01
1
C-02
2 d
1
C-03
A-08
A-07
A-06
A-05
A-04
C-05
A-03
A-02
C-04
2
Reinstallation
Reinstall the battery ground terminal.
Reprogram the radio and audio memories and adjust the clock.
For the reprogramming procedure, refer to the owner’s manual.
- 5 - a