advertisement
CCTV | LTC 0385 Series DinionXF Monochrome Cameras
LTC 0385 Series DinionXF Monochrome
Cameras
▶ 15-bit DSP technology
▶ XF-dynamic
▶ Bilinx communication
▶ Default shutter
▶ Lens wizard
▶ Auto black
▶ Video motion detection
The LTC 0385 Series of High Performance 1/3-inch Digital
CCD Monochrome Cameras create the best possible image, even under the most difficult light and scene conditions.
Based on unique 15-bit digital video processing technology and employing XF-Dynamic, these cameras provide excellent sensitivity with extended dynamic range. By employing the best 1/3-inch CCD available, advanced front end processing, combined with the outstanding Dinion
DSP, the cameras achieve an astonishing sensitivity, providing better images in low light situations and sharper daytime images.
All Dinion cameras are supplied ready to operate. Simply attach and focus the lens, and connect power to provide optimal pictures under virtually all scene conditions. No tools are required for back focus and power connection. For extra challenging situations where fine tuning or special settings are required, the camera parameters can be individually set using the control buttons on the side of the camera and On-screen Display (OSD). Also, to aid installation, the camera automatically detects the lens type, and using the Lens Wizard ensures accurate (back) focusing for perfectly sharp pictures at all times
Functions
XF-Dynamic
Extended dynamic range is brought to a new level on the
LTC 0385 Series Camera by XF-Dynamic technology. XF-
Dynamic automatically processes the highly accurate 15-bit digital signal to optimally capture the detail in both the highlight and lowlight areas of the scene simultaneously, to maximize the information visible in the picture.
Bilinx Technology
The LTC 0385 series cameras incorporate Bilinx. Bilinx is a bidirectional communication capability embedded in the video signal of all Bosch Dinion cameras. With Bilinx technicians can check status, change camera settings and even update firmware from virtually anywhere along the video cable. Bilinx reduces service and installation time, provides for more accurate set-up and adjustment, and improves overall performance. In addition, Bilinx uses the standard video cable to transmit alarm and status messages, providing superior performance without additional installation steps.
www.boschsecurity.com
2 | LTC 0385 Series DinionXF Monochrome Cameras
Video Motion Detection
The built-in video motion detector allows you to select up to four fully programmable areas with individual thresholds.
The global scene change detector minimizes false alarms caused by sudden lighting condition changes, such as switching on or off the indoor or security lighting. When motion is detected alarms may be displayed in the video signal, the output relay can be closed in addition to alarm message transmission on Bilinx.
Auto Black
The automatic black level feature, enhances contrast by removing veiling glare from the picture or when contrast is reduced by fog or mist.
Default Shutter
When viewing moving objects a fast shutter speed is required. When using a fast shutter speed the lens opening or gain control needs to be increased to maintain the video signal. The camera sensitivity is limited by the fast shutter speed. The default shutter setting of the LTC 0385 offers the best of all worlds, fast shutter speed as long as there is sufficient light, however as the light level falls, when other adjustments have been exhausted, the shutter reverts to the standard setting maintaining the cameras excellent sensitivity.
Back Light Compensation (BLC)
Offering a fully programmable BLC area of interest, and a variable BLC level, the camera can be easily set up for even the most challenging entrance applications.
Lens Wizard
The LTC 0385 series automatically detects the type of lens installed. The Lens Wizard will focus the lens at the maximum lens opening, to ensure that focus is maintained throughout the entire 24-hour day/night cycle. No special tools or filters are required.
Programmable Modes
The camera supports three independent operating modes.
The 3 modes are preprogrammed for typical applications, but are fully programmable for individual situations.
Switching between modes is easy via Bilinx or the external alarm input.
SensUp
By increasing the integration time on the CCD up to 10 times, the effective sensitivity is dramatically enhanced, especially useful where there is no artificial lighting and you rely on the moon, stars and scattered radiation.
Certifications and Approvals
Electromagnetic Compatibility
Emission
Immunity
EN55022 class B, FCC class B part 15
EN50130-4 Alarm Systems, Part 4
Vibration Camera with 500 gr (1.1 lbs) lens according to
IEC60068-2-27
Safety
EN60065 (/10 and /50 models)
UL6500, cUL CAN/CSA E60065-00 (/20 and /60 models)
Installation/Configuration Notes
Dimensions in mm (inches)
Parts Included
Quantity Components
1 LTC 0385 Series Dinion XF Monochrome Camera
1 Spare male 4–pin lens connector
Lens not included
Technical Specifications
Electrical
Model No.
Voltage Range
LTC 0385/10 12 – 28 VAC 11 –
39 VDC
LTC 0385/20 12 – 28 VAC 11 –
39 VDC
LTC 0385/50 85 – 265 VAC
LTC 0385/60 85 – 265 VAC
Power Consumption
Imager
45 – 65 Hz
45 – 65 Hz
System
CCIR
EIA
45 – 65 Hz
45 – 65 Hz
CCIR
EIA
4 W
Interline transfer CCD, 1/3-inch image format
LTC 0385 Series DinionXF Monochrome Cameras | 3
Active Pixels
CCIR Models:
EIA Models:
752 H x 582 V
768 H x 492 V
Sensitivity
Sensitivity (Full video) 1)
Sensitivity 50 IRE 1)
Minimum Illumination 1)
Minimum Illumination with
Sens UP
Horizontal Resolution
Signal-to-Noise-Ratio
Video Output
Synchronization
Electronic Shutter
Sensitivity Up
Auto Black
Range
Noise Reduction
Contour
BLC
Gain
VMD
Alarm Output
Alarm Input(TTL)
Alarm Output Relay
0.23 lux (0.023 fc)
0.046 lux (0.0046 fc)
0.031 lux (0.0031 fc)
0.0031 lux (0.00031 fc)
570 TVL
> 50 dB
1 Vpp, 75 ohm
Internal, line lock or genlock selectable
Auto (1/60 (1/50) to 1/500000), fixed, flickerless, default
Off, automatic continuous up to 10x
On, off selectable
32x dynamic range enhancement
Auto, off selectable
Sharpness enhancement level selectable
Off, area and level selectable
Auto (maximum level selectable to 28 dB) or fixed level selectable
4 area, sensitivity selectable
VMD or Bilinx
Profile switching, +5 V nominal, +40 VDC max.
max. 30 VAC or +40 VDC, max. 0,5 A continuous, 10 VA
External Synchronal Input 75 ohm or high impedance selectable
Cable Compensation Up to 1000 m (3000 ft) coax without external amplifiers (automatic set-up in combination with coaxial communication)
Camera ID
Lens Types
Remote Control
16 character editable string, position selectable
Manual, DC- and Video-Iris auto-detect with override DC-iris drive: max 50 mA continuous
Video-iris: 11.5 ± 0.5 VDC, max 50 mA continuous
Bi-directional coaxial communication
1) F/1.2, 89% reflection, SenseUp off
Mechanical
Dimensions (H x W x L)
Weight
Tripod Mount
Lens Mount
Controls
59 x 67 x 122 mm (2.28 x 2.6 x 4.8 inch) without lens
450 g (0.99 lbs) without lens
Bottom (isolated) and top 1/4-inch 20 UNC
C and CS
OSD with softkey operation
Environmental
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
-20°C to +50°C (-4°F to +122°F)
-25°C to +70°C (-13°F to +158°F)
20% to 93% RH up to 98% RH
Ordering Information
LTC 0385/10 DinionXF Monochrome
Camera
1/3-inch B/W high performance CCIR, DSP,
570 TVL, 12-28 VAC/11-39 VDC, 50 Hz
LTC 0385/20 DinionXF Monochrome
Camera
1/3-inch B/W high performance EIA, DSP, 570
TVL, 12-28 VAC/11-39 VDC, 60 Hz
LTC 0385/50 DinionXF Monochrome
Camera
1/3-inch B/W high performance CCIR, DSP,
570 TVL, 85-265 VAC, 50 Hz
LTC 0385/60 DinionXF Monochrome
Camera
1/3-inch B/W high performance EIA, DSP, 570
TVL, 85-265 VAC, 60 Hz
Accessories
LTC 3364/21 Varifocal Lens IR corrected
1/3-inch, 2.8 – 6 mm, DC-iris, CS-mount
F1.4-200, 4-pin
LTC 3364/31 Varifocal Lens
1/3-inch, 3.5 – 8 mm, DC-iris, CS-mount F/
1.4-200, 4-pin
LTC 3364/40 Varifocal Lens
1/3-inch, 2.8 – 12 mm, DC-iris, CS-mount
F1.4-360, 4-pin
LTC 3364/60 Varifocal Lens
1/3-inch, 3.5 – 8 mm, DC-iris, CS-mount
F1.4-360, 4-pin
LTC 3374/20 Varifocal Lens
1/3-inch, 5 – 50 mm, DC-iris, CS-mount
F1.4-185, 4-pin
LTC 3384/21 Zoom Lens
1/3-inch, 6 – 60 mm, DC-iris, CS-mount
F1.4-360, 4-pin
TC120PS Power Supply Unit
110-120 VAC/15 VDC, 50/60 Hz, 300 mA
TC220PS Power Supply Unit
230 VAC/12 VDC, 50 Hz, 10 VA
TC220PSX‑24 Power Supply Unit
230 VAC/20 VAC, 50 Hz, 20 VA
TC1334 Power Supply Unit
120 VAC/24 VAC, 60 Hz, 30 VA
LTC0385/10
LTC0385/20
LTC0385/50
LTC0385/60
LTC3364/21
LTC3364/31
LTC3364/40
LTC3364/60
LTC3374/20
LTC3384/21
TC120PS
TC220PS
TC220PSX-24
TC1334
www.boschsecurity.com
4 | LTC 0385 Series DinionXF Monochrome Cameras
Ordering Information
Software Options
VP-CFGSFT Bilinx Configuration Tool configuration software with USB adapter
VP‑CFGSFT Configuration Software for cameras using Bilinx, includes VP-USB
Adaptor
VP-CFGSFT
VP-CFGSFT
Americas:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: +1 800 289 0096
Fax: +1 585 223 9180 [email protected]
www.boschsecurity.us
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: +31 40 2577 330 [email protected]
www.boschsecurity.com
© Bosch Security Systems Inc. 009 | Data subject to change without notice
T880753291 | Cur: en-US, V10, 2 Dec 2009
Asia-Pacific: Represented by
Robert Bosch (SEA) Pte Ltd, Security Systems
11 Bishan Street 21
Singapore 573943
Phone: +65 6571 2600
Fax: +65 6571 2698 [email protected]
www.boschsecurity.com
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project