Millermatic® 135 with Auto-Set

Millermatic® 135 with Auto-Set
Millermatic 135 with Auto-Set™
All-in-one wire welding package welds 24 gauge - 3/16 in (0.8 - 4.8 mm) mild
steel. The simplest Millermatic to set-up and start welding.
Mild Steel Welding
Flux Cored (FCAW)
Not to scale.
Min. — 24 ga (.8 mm)
Max. — 3/16 in (4.8 mm)
and protects internal
components from damage.
Trigger reset permits quick
reset at torch rather than unit.
New! Auto-Set™ is a breakthrough control
that automatically sets your welder to the
proper parameters. Auto-Set offers all-inone MIG, minus the guesswork! Simply set
the wire diameter, set the material
thickness, and start welding!
Manual Mode has the flexibility to manually
set weld parameters for broader
NEW! Smooth-Start™ patent-pending
technology provides a smooth, spatter-free
start. —The best starting machine in the
small MIG category. No more pop-gun
starts or spatter to clean up.
Durable cast aluminum feedhead
incorporates dual groove quick-change
drive roll and spring-loaded tension arm
with calibrated tension knob, all designed to
make setup easier and faster.
Thermal Overload Protection shuts down
the unit and activates over- temperature
light if airflow is blocked or duty cycle is
exceeded. Automatically resets when fault
is corrected and unit cools.
"Tip Saver" short circuit protection shuts down
output when tip is shorted to the work. Extends
contact tip life
Standard Built-in solid-state
contactor circuit makes wire
electrically "cold" until trigger
is pulled. Makes unit safer,
and is easier to position torch
to work before starting to
Easy access to output
studs provides convenient
polarity changeover when
switching from solid or flux
cored wires.
Self-resetting motor
protection circuit eliminates
the need to find and replace
Uses 4 or 8 in (102 or 203
mm) spools and can be set
up to weld with wire sizes
.024 - .030 in (0.6 - 0.8 mm)
mild/stainless steel and .030 .035 (0.8 - 0.9 mm) flux cored.
Note: Auto-Set is calibrated
for .024 and .030 mild steel
wire and C25 shielding gas
(75% Argon, 25% CO2). Use
manual mode for broader
applications with mild steel, or
to weld stainless steel or flux
Light Industrial
Light Fabrication
Maintenance and
Farm and Ranch
Auto Body
Input Power
Requires 1-Phase
115 V, 20 Amps
Rated Output
90A at 18 VDC, 20%
duty cycle
Welding Amperage
30 - 140 Amps
Wire Speed
15 - 390 IPM (1.0 12.7 m/min)
Net Weight
60lb (27.3kg)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF