ElEgancE 2100 DryEr

Elegance 2100 Dryer
Model 5560KU
Elegance 2100 Dryer
This powerful 2100W hairdryer with beautiful high gloss finish really
delivers on top performance and style. The high torque motor gives
2x the air pressure for a powerful airflow and fast drying results. The
ionic and ceramic technology leaves hair with a smooth, shiny, frizzfree finish.
• 2100W
• High torque motor for 2x the air pressure
• Ionic technology for condition and shine
• Heat-balancing ceramic technology
• 3 heat / 2 speed settings plus cool shot
• Hinged rear filter for easy cleaning
• Ultra slim concentrator nozzle
• No tangle swivel cord
• 3 year guarantee
• This appliance should only be used as described within
this instruction booklet. Please retain for reference.
WARNING! Polythene bags over a product or package
may be dangerous. To avoid danger of suffocation, keep
this wrapper away from babies and children. This bag is
not a toy.
• AL
WAYS keep out of reach of children (during and after
use and whilst cooling).
his appliance should not be used, cleaned or
maintained by children.
lways take extra care if used on children or near
• Do not use on very young children.
K Only: This appliance must not be used in the
bathroom. If using the appliance in a bathroom, unplug
after use as the proximity of water can be dangerous
even if the appliance is switched off. For additional
protection the installation of a residual current device
(RCD) with a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
WARNING! Do not use this appliance near water
contained in basins, bathtubs or other vessels.
o not use this appliance in the bathroom.
o not immerse the appliance into water or other
ever look directly into the barrel of the hairdryer when it
is switched on.
lways inspect the appliance before use for noticeable
signs of damage. Do not use if damaged or if the
appliance has been dropped. In the event of damage
contact the Conair Customer Care Line (refer to ‘UK
After Sales Service’ section for further information). No
repairs should be attempted by the consumer.
• Do not use the appliance if the lead is damaged. In
the event of damage contact the Conair Customer
Care Line (refer to ‘UK After Sales Service’ section for
further information). No repairs should be attempted
by the consumer.
• Do not leave the appliance unattended when switched on
or plugged in.
• This unit is equipped with a safety thermostat. In the
event of overheating the appliance will either stop
automatically or run hot and cold intermittently. Should
this happen, switch the dryer to the ‘off’ position,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear filter is clear of hair and other debris.
Plug in and switch on. If the appliance continues to
overheat discontinue use immediately, switch off and
unplug, and contact the Conair Customer Care Line
(refer to ‘UK After Sales Service’ section for further
information). No repairs should be attempted by the
• Take care that the air vents do not become blocked
when in use. Ensure the rear filter is clear of hair and
other debris before use.
• Do not place the appliance on any heat sensitive
surface whilst in operation.
• Take care to avoid the hot surface of the appliance
coming into direct contact with the skin, in particular
the ears, eyes, face and neck.
• This appliance should not be used by adults whose
reduced physical, sensory or mental capabilities, or
whose lack of experience and knowledge, might cause
a hazard, unless they have been correctly instructed to
understand the safe use and hazards involved and are
adequately supervised.
• Allow appliance to cool before storing away.
• After use do not coil the lead around the appliance as
this may cause damage to the lead. Instead coil the
lead loosely by the side of the appliance.
• This appliance complies with the requirements of
Directives 2004/108/EC (Electromagnetic Compatibility)
and 2006/95/EC (Electrical Safety of Domestic
Ionic Technology
Many aspects of modern living, including air conditioning, contact
with man-made fibres and air pollution contribute to a build-up of
static electricity in the hair. Even brushing and towel drying the hair can
increase these levels, causing the surface of the cuticle to become
rough. Consequently, hair may have a dull appearance. Also high
levels of static charge cause hair to become ‘fly-away’ and difficult to
style. The ion generator produces a stream of negative ions which act
to neutralise the static charge, smoothing the scales on the cuticle for
shiny, smooth and manageable hair.
• Towel dry and detangle hair.
• Plug the appliance into a suitable mains socket.
• Select the required heat and speed settings.
• After use, switch off and unplug the appliance.
• Allow to cool before storing away.
IMPORTANT! Always keep the rear of the appliance away from the hair
during use to prevent it being drawn in through the rear air filter.
Heat Settings
There are 3 heat and 2 speed settings plus the cool shot. Use the high
heat and high speed settings for initial drying and use the low heat and
speed settings for styling and scrunch drying as the hair begins to dry.
Cool Shot Button
Use the cool shot button on warm hair to rapidly cool the hair and set
the style in place for a long lasting effect.
Ultra Slim Concentrator Nozzle
Use the ultra slim concentrator nozzle to direct the airflow along the
hair section to make styling easier. When using the concentrator nozzle
use a low heat and speed setting.
Body and Volume
To help create extra body and volume in the hair, lean forward so the
head is upside down when drying. Direct the airflow towards the roots
for maximum lift. When hair is dry brush back into required style.
To create a smooth straight look, first divide the hair into sections.
Attach the ultra slim concentrator nozzle, then using a brush hold hair
taut and roll ends slightly under as you dry.
Making Waves
To create tousled natural-looking waves position head upside down.
Using the dryer without the nozzle grasp hair at the roots and scrunch
between fingertips whilst drying. When dry move the hair back into
required position for a casual, natural look.
To keep your hairdryer in the best possible condition, please follow the
steps below:
o not wrap the lead around the hairdryer, instead coil the lead
loosely by the side of the dryer.
• Always unplug after use.
• Do not use the hairdryer at a stretch from the power point.
Cleaning The Filter
• Ensure the appliance is switched off, unplugged and cool.
• Holding the handle of the appliance firmly press the button on the top
of the rear filter, this will enable the rear filter to open.
• Using a soft brush, clean any hair and other debris from the filter.
• Replace the rear filter by pushing back into position.
• To clean the outside of the hairdryer, wipe with a damp cloth. Make
sure that no water enters the hairdryer and the hairdryer is completely
dry before use.
This BaByliss appliance is guaranteed for consumer use for 3 years.
This guarantee covers defects under normal use from date of
purchase and ceases to be valid in the event of alteration or repair by
unauthorised persons. If the appliance does not perform satisfactorily
due to defects in materials or manufacture, it will be repaired or
replaced through Conair UK After Sales Service. The Conair Group
Ltd reserves the right to amend terms and specifications without prior
This guarantee in no way affects your statutory rights.
For further advice on using the appliance or should you need to return
your product, please contact the Conair Customer Care Line on
0370 5 133191 (09:00 to 17:00 Monday to Friday) or email your enquiry to
The return address is:
Customer Care Centre
Conair Logistics
Unit 4 Revolution Park
Buckshaw Avenue
Buckshaw Village
Please enclose your returns number, name and address details, together
with a copy of proof of purchase and details of the fault.
symbol on the product or on its packaging indicates that this
product may not be treated as household waste. Instead it should
be handed to an appropriate collection point for the recycling of
Electrical and Electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this
product. For more detailed information about the recycling of this
product, please contact your local council office or your household
waste disposal service.
The wires in the mains lead are coloured in accordance with the
following code:
As the colours of the wire in the mains lead of this appliance may not
correspond with the colour marking identifying the terminals on your
plug, proceed as follows:
• The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N.
• The wire which is coloured BROWN must be connected to the
terminal which is marked with the letter L.
• Neither the BLUE nor BROWN wires should be connected to the
terminal which is marked with the letter E or the
This appliance is supplied fitted with a BS1363 mains plug and a
BS1362 13A fuse. If this plug is removed from the appliance please
ensure it is disposed of safely as a disconnected plug is dangerous if
reconnected to the mains. If any other type of plug is used, a 13A fuse
must be fitted.
Download PDF