HDMI 1.3 Receiver over Single CAT5

HDMI 1.3 Receiver over Single CAT5
HDMI 1.3 Receiver over Signal
CAT5/CAT6
Model #: HDMI-C5-3-R
© 2010 Avenview Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations or warranties with
respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any
time without notice. No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in
Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products
including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.
Reproduction of this manual, or parts thereof, in any form, without the express written permission of Avenview Inc. is strictly prohibited.
www.avenview.com
1
Table of Contents
Section 1: Getting Started ...................................................................................................................... 3
1.1
Important Safeguards ............................................................................................................ 3
1.2
Safety Instructions ................................................................................................................. 3
1.3
Regulatory Notices Federal Communications Commission (FCC) ......................................... 4
1.4
Introduction ........................................................................................................................... 4
1.5
Package Contents................................................................................................................... 5
1.6
Before Installation.................................................................................................................. 5
1.7
Panel Description ................................................................................................................... 6
1.8
Installation ............................................................................................................................. 8
1.9
EDID Learning ......................................................................................................................... 8
1.10
General Troubleshooting ....................................................................................................... 9
Section 2: Specifications......................................................................................................................... 9
www.avenview.com
2
Section 1: Getting Started
1.1
Important Safeguards
Please read all of these instructions carefully before you use the device. Save this manual for future
reference.
What the warranty does not cover


Any product, on which the serial number has been defaced, modified or removed.
Damage, deterioration or malfunction resulting from:
 Accident, misuse, neglect, fire, water, lightning, or other acts of nature, unauthorized
product modification, or failure to follow instructions supplied with the product.
 Repair or attempted repair by anyone not authorized by us.
 Any damage of the product due to shipment.
 Removal or installation of the product.
 Causes external to the product, such as electric power fluctuation or failure.
 Use of supplies or parts not meeting our specifications.
 Normal wear and tear.
 Any other causes which does not relate to a product defect.

Removal, installation, and set-up service charges.
1.2
Safety Instructions
The HDMI-C5-3-R, HDMI 1.3 Receiver over Signal CAT5 has been tested for conformance to safety regulations
and requirements, and has been certified for international use. However, like all electronic equipments, the
HDMI-C5-3-R should be used with care. Read the following safety instructions to protect yourself from
possible injury and to minimize the risk of damage to the unit.




Do not dismantle the housing or modify the module.
Dismantling the housing or modifying the module may result in electrical shock or burn.
Refer all servicing to qualified service personnel.
Do not attempt to service this product yourself as opening or removing housing may expose you to
dangerous voltage or other hazards


Keep the module away from liquids.
Spillage into the housing may result in fire, electrical shock, or equipment damage. If an object or liquid
falls or spills on to the housing, unplug the module immediately.
Have the module checked by a qualified service engineer before using it again.
Do not use liquid or aerosol cleaners to clean this unit. Always unplug the power to the device before
cleaning.


www.avenview.com
3
1.3
Regulatory Notices Federal Communications Commission (FCC)
This equipment has been tested and found to comply with Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
Any changes or modifications made to this equipment may void the user’s authority to operate this
equipment.
1.4
Introduction
The Avenview HDMI-C5-3-R HDMI 1.3 Receiver over Single CAT5 Extender boosts up your video/audio
transmission distance up to 60m (200ft) in HDTV 1080i format, 40m (130ft) in HDTV 1080p format, and 20m
(65ft) in HDTV 1080p with 36 bit color depth. With only one cost effective LAN cable, users can easily extend
HDTV sources from DVD players, Blu-ray Disc player, PS3, PC, and any other HDMI sources compliant with
TMDS to distant display monitors including HDMI/DVI enabled TV sets or LCD PC monitors. With the
state-of-the-art Silicon Image chipsets equipped, deep color video, DTS-HD or Dolby TrueHD audio, and HDCP
supports and compatibility are all further insured. This flexibility makes HDCP compliant DVD players or PS3
transmit utmost high quality video and audio with a greater distance at the minimal cost, when integrating
several components apart.
The Receiver (HDMI-C5-3-R) equalizes the sent TMDS multimedia data from Transmitter (HDMI-C5-3-S /
HDMI-C5XD-S / HDMI-C5XD-SR). The transmission distance between the sending and receiving units can be up
to 60m (200ft) under HD (720p/1080i) or 40m (130ft) under Full HD (1080p). With an 8-level equalization
control knob on the receiving unit, users can adjust the equalization strength to the received TMDS signals
accordingly, and therefore optimize the transmission distance between source and destination.
-
Silicon Image chipset embedded for best compatibility and reliability HDMI video input supports up to
1080p resolution
HDMI 1.3c Compliant
HDCP 1.1 compliant
Extend the transmission length up to 60m (200ft) from the HDMI sources under HD resolution (1080i
or 720p at 8 bit color depth)
Extend the transmission length up to 40m (130ft) from the HDMI sources under Full HD resolution
(1080p at 8 bit color depth)
Extend the transmission length up to 20m (65ft) from the HDMI sources under Full HD resolution
(1080p at 12 bit color depth)
Minimize the cable skew by adjustable 8-level equalization control
Pure unaltered uncompressed 7.1ch digital HDMI over LAN cable transmission
DTS-HD and Dolby True HD high bit rate audio support
Allows cascading
Perfectly integrated with other HDMI-C5-3 Series products
www.avenview.com
4
1.5
Package Contents
Before you start the installation of the converter, please check the package contents.
-
HDMI-C5-3-R
Power Adapter (+5VDC, 4A)
x1
x1
-
User’s Manual
x1
1.6




Before Installation
Put the product in an even and stable location. If the product falls down or drops, it may cause an
injury or malfunction.
Don’t place the product in too high temperature (over 50°C), too low temperature (under 0°C) or high
humidity.
Use the DC power adapter with correct specifications. If inappropriate power supply is used then it
may cause a fire.
Do not twist or pull by force ends of the optical cable. It can cause malfunction.
www.avenview.com
5
1.7
Panel Description
FRONT PANEL (Transmitter, HDMI-C5-3-S)
Mode
1.
HDMI-IN
Rotary Switch
0
1
2
3
4
5
6
7
2.
HDMI Input
DIP SWITCH
HDMI Mode with Surround Sound Audio Output
HDMI mode with Stereo Audio Output
DVI Mode
Reserved
Reserved
Reserved
Use Default EDID
Learn EDID From the Display
Note for EDID (Extended Display Identification Data) learning
1. Please connect the display which you want to read EDID with a HDMI cable to the transmitter’s
HDMI-IN and turn Mode to 7 so the TX can learn the EDID information from the connected HDTV.
The LED on the RJ45-OUT of TX will dim and light again in a few seconds, which indicates the EDID
learning process is completed.
2. Turn Mode clockwise from Mode 7 to Mode 0 or Mode 1 for desirable audio setting and enjoy the
experience. DO NOT let the rotary arrow pass by Mode 6 which will erase the EDID just learned and
restore the default EDID.
www.avenview.com
6
REAR PANEL (Transmitter, HDMI-C5-3-S)
+5V DC
RJ45-OUT
1.
5V 4A DC Power Connector
2.
RJ45 Out
2.
HDMI Out
FRONT PANEL (Receiver, HDMI-C5-3-R)
EQ
1.
HDMI-OUT
Rotary Switch
EQ: Adjust the 8-level equalization control knob to the received HDMI signals.
0 – 7 = Strongest – Weakest.
It is recommended to switch from 7 to 0 to find the optimal visual experience.
REAR PANEL (Receiver, HDMI-C5-3-R)
+5V DC
RJ45-IN
1.
5V 4A DC Power Connector
2.
www.avenview.com
RJ45 In
7
1.8
Installation
To setup Avenview HDMI-C5-3-R with HDMI-C5-3-S follow these steps for connecting to a device:
1.
Connect your HDMI/DVI source (such as a Blu-ray Disc player) to Transmitter (HDMI-C5-3-S).
2.
Connect your HDMI/DVI display (such as a LCD TV) to the receiving unit HDMI-C5-3-R.
3.
Connect your CAT-5/5e/6 LAN cable between the transmitting and receiving units.
4.
Make sure CAT-5/5e/6 LAN cable is tightly connected and not loose.
5.
Plug in 5V DC power cord to the power jack of the receiving unit HDMI-C5-3-R.
6.
Plug in 5V DC power cord to the power jack of the transmitting unit HDMI-C5-3-S.
If a flickering or a blinking image is seen, try to adjust the rotational switch to improve the cable
skew. 0 stands for the strongest EQ while 7 stands for the weakest. Try adjusting the EQ from 7 to 0
1.9
EDID Learning
To learn EDID from the monitor/TV following these steps
1.
2.
3.
4.
5.
Turn on HDMI-C5-3-S.
Turn the Mode of HDMI-C5-3-S counterclockwise from 0 (for surround sound) or 1 (for stereo) to 7.
Use a HDMI cable to connect HDMI-C5-3-S & the display (better not connect to video source). The
LED on the RJ-45 of HDMI-C5-3-S will dim and light again, which indicates the EDID learning process is
finished.
Turn the Mode of HDMI-C5-3-S clockwise from 7 to 0 (for surround sound) or 1 (for stereo).
Connect HDMI-C5-3-S and the video source through a HDMI cable and enjoy the experience.
The most important thing is don’t let the rotary arrow pass through 6 which will erase the EDID just
learned and restore to default EDID.
www.avenview.com
8
1.10 General Troubleshooting
Problem
Possible Solution
No Image





Screen Defects Appear
Check if connection to the source and the display are correct.
Ensure that display device supports 480p, 720p and 1080p
resolution
This product supports up to 1080p (1920x1200) resolution.
Check the DVI and HDMI connection
If outputting from a PC. Check the maximum resolution range
of the graphics card.
Section 2: Specifications
Item
Units
Unit Description
HDMI Compliance
HDCP Compliance
HDMI-C5-3-S
HDMI 1.3 Transmitter
Input
Output
HDMI Connector
RJ45 Connector
Rotary Switch
Dimensions
Power Supply
Power Consumption
HDMI-C5-3-R
HDMI 1.3 Receiver
HDMI 1.3c
Yes
Video Bandwidth
Supported Resolutions
Resolution and Distance
(8-bit)
Audio Support
Equalization
Input TMDS Signal
Input DDC Signal
ESD Protection
Description
-
Single Link 340 MHz (10.2Gbps)
480i / 480p / 720p / 1080i / 1080p60
Full HD: (1080p) ~40meter (130feet) (CAT5e) / 50meter (165feet) (CAT6)
HD: (720p/1080i)-50meter (165feet) (CAT5e) / 60meter (200feet) (CAT6)
Surround Sound (up to 7.1 Ch) or Stereo Digital Audio
8 Level Digital Control
1.2 Volts (peak-to-peak)
5 Volts (peak-to-peak, TTL)
Human body model — ±15kV (air-gap discharge) & ±8kV (contact discharge)
Core chipset — ±8kV
1 x HDMI
1 x RJ45
1 x RJ45
1 x HDMI
Type A (19 pin female)
WE/SS 8P8C with 2 LED indicators
Mode
EQ
3.3” X 2.4” x 1” (L x W x H)
5V 4A DC
1 Watt (max)
Environmental
Operating Temperature
Storage Tempearture
Relative Humidity
32˚ ~ 104˚F (0˚ to 40˚C)
-4˚ ~ 140˚F (-20˚ ~ 60˚C)
20~90% RH (no condensation)
www.avenview.com
9
Disclaimer
While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the
operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of
Avenview concerning such products or this documentation, for any interruption of service, loss or interruption of business, loss of
anticipatory profits, or for punitive, incidental or consequential damages in connection with the furnishing, performance, or use of the
Avenview hardware, software, or other products and documentation provided herein.
Avenview Inc. reserves the right to make changes without further notice to a product or system described herein to improve reliability,
function or design. With respect to Avenview products which this document relates, Avenview disclaims all express or implied warranties
regarding such products, including but not limited to, the implied warranties of merchantability, fitness for a particular purpose, and
non-infringement.
www.avenview.com
10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement