LEM-1DL - Hyper Advance

Access Sentry Door Entry Control System
LEM-1DL
1-call master, with door release button
INSTALLATION & OPERATION MANUAL
LEM-1DL ACCESS SENTRY is a convenient 2-station entry control system and can most suitably be used in small offices,
retailers / mall's back doors, etc.
PRECAUTIONS
Prohibited
Do not dismantle unit
Keep unit away from water
Be sure to follow the instructions
WARNING (Negligence could result in death or serious injury.)
1. Do not dismantle or alter the unit. Fire or electric shock could result.
2.Do not connect any non-specified power source to the +, - terminals. Also, do not install two power supplies in
parallel to a single input. Fire or damage to the unit could result.
3.Keep the unit away from water or any other liquid. Fire or damage to the unit could result.
4.When existing chime wires are used, it is possible that they contain AC voltage. Electric shock or unit damage
could result. Ask a qualified technician.
5.Do not use power supply with a voltage other than specified. Fire or electric shock could result.
6.For power supply, use Aiphone power supply model specified to use with system. If non-specified product is
used, fire or malfunction could result.
CAUTION (Negligence could result in injury or damage to property.)
1. Before turning on the power, make sure wires are not crossed or shorted. Fire or electric shock could result.
2.When mounting the unit on wall, install the unit in a convenient location, but not where it could be jarred or
bumped. Injury could result.
3. Do not install or make any wire terminations while power supply is plugged in. It can cause electrical shock or
damage to the unit.
4. Do not install the unit in any of the following locations. Fire, electric shock, or unit trouble could result.
* Places under direct sunlight, or near heating equipment, boiler that varies in temperature.
* Places subject to dust, oil, chemicals, hydrogen sulfide (hot spring).
* Places subject to moisture and humidity extremes, such as bathrooms, cellars, greenhouses, etc.
* Places where the temperature is quite low, such as inside refrigerated area or in front of an air conditioner.
* Places subject to steam or smoke (near heating or cooking surfaces).
* Where noise generating devices such as dimmer switches or inverter electrical appliances are closeby.
* Locations subject to extremely powerful electric fields.
5.Do not install the unit in a location subject to frequent vibration or impact. It may fall or tip over, resulting in
damage to the unit or personal injury.
GENERAL PRECAUTIONS
1. Keep the unit more than 1 m (3.3') away from Radio or TV sets.
2. In areas where broadcasting station antennas are closeby, the intercom system may be affected by radio
frequency interference.
3. The unit will not work during power failure.
4. All units, except for door stations, are designed for indoor use only. Do not use at outdoor locations.
5. Using a mobile phone or professional-use radio equipment such as walkie-talkie close to the system may cause a
malfunction.
–1–
1
System Components
Master station
1-call master with
DOOR RELEASE
button
2
Sub station
LE-D
Surface mount
door station
LE-DA Flush mount
door station
Door release
Power supply
EL-12S
AC 12V, 125mA
PT-1210N
AC transformer
(North America only)
Or use an equivalent
AC transformer
AC 12V, 10VA.
LE-A
1-call sub
station
PS-1225UL
PS-1225S
PS-1225
PS-1215DIN
Names & Features
■ Package contents
Speaker / Microphone
• LEM-1DL
• Packet of screws
• INSTALLATION &
OPERATION MANUAL
CALL
OFF
Operation Plate
TALK
TALK
VOICE VOL.
LEM-1DL
Door Release (
TALK button
) button
Voice Volume Control
VOICE VOL.
Low
OFF button
(standby)
High
FEATURES:
* Convenient door entry control system with DOOR RELEASE button
* AC transformer (PT-1210N) supplies power for both communication and door strike
* Desk-top or wall-mountable master
■Call tone adjustment
3-position volume switch, located under Operation Plate.
Adjusts call tone volume (Low - Medium - High).
3-pos.
call tone vol. switch
(under Operation Plate)
–2–
CALL
LEM-1DL
3
Mounting
Back wiring
LE subs
LEM-1DL
LE-D
Single-gang box
Connector
83.5mm,
3-5/16"
Single-gang box
LE-D Unit
Wall
83.5mm,
(3-5/16")
Front Case
Chassis
Operation
Plate
Screw (2)
Push either side
LE-DA
Lift and pull off
Loosen
Main Unit
2-gang box
Stainless
Cover
For surface wall cable run, pass through
opening on top or bottom of back case.
4
+
–
1
E
EL
EL
R
83.5mm,
(3-5/16")
Screw (2)
Screw (2)
Wiring
+
–
1
E
EL, EL
}
for AC or DC power supply
for calling & communication
for communication (common)
for door release & its power supply
Normally open dry contact closure
When EL-12S door release is used;
LE-DA
The actual terminal locations are
different from the ones shown in
the diagram below.
LEM-1DL
1
E
–
DOOR RELEASE
EL-12S
(AC 12V, 125mA)
NP
NP
1
E
+
–
EL
EL
NP: Non-polarized
NP
PT-1210N
AC Transformer
PT-1210N
When door release of OTHER manufacturer is used;
LE-DA
LEM-1DL
1
E
–
DOOR RELEASE
(Max. AC 30V, 1A
Max. DC 30V, 1A)
NP
1
E
+
–
EL
EL
NP
PT-1210N
AC Transformer
PT-1210N
Use a suitable power source
locally available.
–3–
Run separately each cable to
Door station and Door Release.
5
Operations
At master station
At door
Momentary call
tone sounds.
1
PUSH
2
3
4
TALK
DOOR RELEASE
OFF
1.Push call button on door station to call master station (tone remains while call button is held down).
2.Push and hold "TALK" button to reply, then release to listen.
3.Push "
" to activate door release.
4.Push OFF button to end conversation.
If you don't push the OFF button after the call, master station will not receive a call tone when called by the door station.
6
Specifications
Power Source: C 12 ~ 16V or DC 12 ~ 24V. Use one PT-1210N AC transformer (North America only)
A
or PS-1225UL, PS-1225S, PS-1225, PS-1225DIN
Consumption:
Max. 4W (AC 16V). Max. 200mA (DC 24V)
Calling: Electronic continuous tone (from door to master)
Electronic continuous tone or voice (from master to door)
Communication: Push-to-talk, release-to-listen at master (w/ speech volume control)
Output:100mW
Wiring: 2 wires (non-polarized) plus 2 wires for door release
Contact capacity for door release: Max. AC 30V, 1A. or Max. DC 30V, 1A
(feet Ø)
(mm Ø)
Wiring distance: AWG
24
22
20
18
16
Diameter 0.5 0.65 0.8
1.0
1.2
Distance 390' 650' 980' 1,570' 2,360' Distance 120m 200m 300m 480m 720m
Dimensions & weight: 7"H x 5-1/2"W x 2-1/4"D. 180H x 143W x 55D(mm). 0.75 lbs. (340g)(approx.)
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and
service for a period of one year after delivery to the ultimate user and will repair free of charge or replace at no
charge, should it become defective upon which examination shall disclose to be defective and under warranty.
Aiphone reserves unto itself the sole right to make the final decision whether there is a defect in materials
and/or workmanship; and whether or not the product is within the warranty. This warranty shall not apply to any
Aiphone product which has been subject to misuse, neglect, accident, power surge, or to use in violation of
instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This
warranty does not cover batteries or damage caused by batteries used in connection with the unit. This
warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing
by Aiphone. This warranty is limited to the standard specifications listed in the operation manual. This warranty
does not cover any supplementary function of a third party product that is added by users or suppliers. Please
note that any damage or other issues caused by failure of function or interconnection with Aiphone products is
also not covered by this warranty. Aiphone will not be responsible for any costs incurred involving on site
service calls. Aiphone will not provide compensation for any loss or damage incurred by the breakdown or
malfunction of its products during use, or for any consequent inconvenience or losses that may result.
The object area of
is the EU.
AIPHONE CO., LTD., NAGOYA, JAPAN
Issue Date: Apr. 2016
83597 D P0416 AZ
–4–
http://www.aiphone.net/