Satin·Hair 7 - To country selection

Satin·Hair 7
th ic k
no rm
al
fin e
CU 750
D Effective
Date9 21Jul2010 GMT - Printed
05Apr2
99571431_CU750_China.indd
18.05.2010 11:36:37
Uhr
1
2
4
5
3
th ick
no rm
al
fin e
6
7
A
thick
normal
fine
8
B
E
C
D
thick
thick
thick
normal
fine
normal
fine
normal
fine
F
G
2
D Effective
Date2 21Jul2010 GMT - Printed
05Apr2
99571431_CU750_China.indd
18.05.2010 11:36:31
Uhr
3
D Effective
Date3 21Jul2010 GMT - Printed
05Apr2
99571431_CU750_China.indd
18.05.2010 11:36:33
Uhr
4
D Effective
Date4 21Jul2010 GMT - Printed
05Apr2
99571431_CU750_China.indd
18.05.2010 11:36:33
Uhr
5
D Effective
Date5 21Jul2010 GMT - Printed
05Apr2
99571431_CU750_China.indd
18.05.2010 11:36:34
Uhr
6
D Effective
Date6 21Jul2010 GMT - Printed
05Apr2
99571431_CU750_China.indd
18.05.2010 11:36:34
Uhr
English
Our products are engineered to meet the highest standards
of quality, functionality and design. We hope you thoroughly
enjoy your new Braun appliance.
Please read these use instructions carefully before use and
keep them for future reference.
Important
• Plug your appliance into an alternating current (쓒) outlet
only and make sure that your household voltage
corresponds to the voltage printed on the appliance.
This appliance must never be used near water (e.g. a
•
filled wash basin, bathtub or shower). Do not allow
the appliance to get wet. Always unplug it after use.
• For additional protection, it is advisable to install a residual
current device (RCD) with a rated residual operating
current not exceeding 30 mA in the electrical circuit of
your bathroom. Ask your installer for advice.
• This appliance is not intended for use by children or
persons with reduced physical, sensory or mental
capabilities, unless they are given supervision by a person
responsible for their safety. In general, we recommend that
you keep the appliance out of reach of children. Children
should be supervised to ensure that they do not play with
the appliance.
• Be careful to avoid that the hot surfaces of the appliance
get into direct contact with the skin, in particular of the
ears, face or neck.
• When hot, do not place on surfaces that are not heatresistant.
• Do not wrap the mains cord around the appliance.
Regularly check the mains cord for wear of damage. If the
cord is damaged, stop using the appliance.
• If the complete display flashes, this indicates an internal
error of the appliance. In this case, take the appliance to a
Braun Service Centre for checking. Unqualified repair work
can lead to extreme hazards for the user.
• The appliance should be used on dry hair only.
Description
1
2
3
4
5
6
7
8
Cool tip
Tong with clamp
Ionic nozzle
Tong opener
LC Display
Hair type selector
On/off button
Swivel cord (2 m length)
Colour Saver Technology
Colour Saver Technology with satin ions maintains the
precious health of colored hair as it protects your hair from
dry out and damage and prevents moisture loss of coloured
hair by up to 50% while styling. As satin ions are released
onto your hair a slight crackling noise can be heard.
For beautiful bouncy curls and waves that look more healthy
and radiantly vibrant for longer.
* compared to usage of an appliance without Colour Saver
Technology
Microprocessor supported styling
Thanks to its sophisticated microprocessor and its LC
control display the Braun Satin Hair Colour Styler intuitively
guides you to the accurate temperature for fine, normal or
thick coloured hair.
Personalized settings: Using the hair type selectors [6] you
can adjust the temperature for fine, normal and thick hair.
7
D Effective
Date7 21Jul2010 GMT - Printed
05Apr2
99571431_CU750_China.indd
18.05.2010 11:36:35
Uhr
For medium and thick hair type, you have the choice
between a low and high setting.
Getting started
• Connect the appliance to an electrical outlet and push the
on/off button [7] for 1 second to turn it on.
• During heat-up, the display shows three flashing segments
(Fig. A).
• After approximately 45 seconds, the default temperature
for normal hair is reached and you can start using the
appliance.
• Using the hair type selectors [6], choose your preferred
setting. When changing the setting the segments will flash.
The segments will shine permanently when the selected
setting is reached.
Styling
Preparing for use
• Make sure your hair is completely dry before using the
appliance.
• Comb your hair with a wide-toothed comb to remove
tangles.
• Section your hair off. Starting at the hair tips, clamp a
section of hair (strand of 3-4 cm max.) with the tong.
Creating curls and waves
• Gently wind the strand up to the roots. Allow the strand
to remain curled up for a couple of seconds before
unwinding it. For best results, slightly press the tong
opener [4] in order to smoothly release the strand. For
better handling, you may hold the cool tip [1] with your
other hand.
• You can even straighten a strand that already has been
curled by clamping the strand at the roots again and then
letting the appliance glide slowly and carefully along the
strand towards the hair tips.
• For safety reasons, the appliance will automatically turn off
after approximately 30 minutes.
• Simply press the on/off button [7] again in case you may
want to continue using the appliance.
After use
• After each use, switch off the appliance by pushing the
on/off button [7] for one second.
• Keep in mind that the heating barrel is still hot. Do not
touch it to avoid any risk of burns. After 20 minutes
cooling time, you will be able to touch the heating barrel
without any risk.
• During use and cooling down, the appliance always has to
be placed on a heat-resistant surface.
Cleaning
• Always unplug before cleaning. Never immerse the
appliance in water.
• Clean the appliance with a damp cloth and use a soft
cloth to dry.
Subject to change without notice.
Please do not dispose of the product in the household
waste at the end of its useful life. Disposal can take
place at a Braun Service Centre or at appropriate
collection points provided in your country.
99571431/V-10
China/GB
8
D Effective
Date8 21Jul2010 GMT - Printed
05Apr2
99571431_CU750_China.indd
18.05.2010 11:36:36
Uhr