USB 3.0 2.5`` SATA Hard Drive Enclosure

USB 3.0 2.5`` SATA Hard Drive Enclosure
USB 3.0 2.5’’ SATA Hard Drive
Enclosure
User Manual
Ver. 1.00
All brand names and trademarks are properties of their
respective owners.
Features & Specifications

Supports USB 3.0 SuperSpeed and USB 2.0

Maximum transfer rate of 5 Gbps with USB 3.0 and 480Mbps
with USB 2.0; actual speed depends on the hard drive
performance

Supports SATA 2.5’’ hard drives

Supports Plug and Play

No software or drivers required

LED to indicate drive power and activity
System Requirements

Windows® XP/Vista/7 (32/64 bit)

Available USB port
Package Contents

1 x USB 3.0 2.5’’ SATA Hard Drive Enclosure

1 x User Manual

1 x USB 3.0 Cable
Note: Contents may vary depending on country/market.
MN6000000032 Page 2 Hardware Installation
1. Chassis Assembly
Disassemble the front panel from the housing by removing one screw
from each side of the housing with a screwdriver, then remove the front
panel
(See Figure A-C)
Figure A
Figure B
Figure C
MN6000000032 Page 3 2. Hard Drive Installation
Connect the hard drive, install it and fasten the screws
(See Figure D-G)
Figure D
Figure E
Figure F
Figure G
MN6000000032 Page 4 Driver Installation
No driver installation is required for Windows operating systems, as
this enclosure is natively supported, so the drivers are already installed.
MN6000000032 Page 5 
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising