GFDL110EH - Products
GFDL110EH
GE Appliances 7.0 Cu. Ft. Capacity
Electric Dryer With 200-Ft. Long Venting
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
27
ELECTRIC DRYER RATING
120V/240V
5600W, 24A, 60Hz
120V/208V
4400W, 22A, 60Hz
32-3/16
EXHAUST OPTIONS: 3-way via rear, right and bottom.
CIRCUIT REQUIREMENTS: An individual, properly
grounded branch circuit, protected by a 30-amp circuit breaker
or a time-delay fuse, is required.
39-3/8
NOTE: Dryer wall outlet must be located within 36" of service
cord entry and accessible when dryer is mounted in position.
INSTALLATION INFORMATION: For complete information,
see installation instructions packed with your dryer.
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
4-3/8
4-1/2
Specification Revised 1/16
GFDL110EH
GE Appliances 7.0 Cu. Ft. Capacity
Electric Dryer With 200-Ft. Long Venting
SPECIAL INSTALLATION REQUIREMENTS:
STACKED DIMENSIONS
(IN INCHES)
STACKED INSTALLATION:
24
3-1/4
49-5/8
1/2
rackets for stacking dryer over washer are not included with the dryer.
B
GEFLSTACK or part no. WE25X10018.
ALCOVE OR CLOSET INSTALLATION:
If your dryer is approved for installation in an alcove or closet, it will be
stated on a label on the dryer back.
The dryer MUST be exhausted to the outside.
inimum clearances between dryer cabinet and adjacent walls or other
M
surfaces are: 0" either side, 3" front and rear.
79-5/8
Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
loset doors must be louvered or otherwise ventilated and must contain a
C
minimum of 60 sq. in. of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of
open area equally distributed.
o other fuel-burning appliance shall be installed in the same closet with
N
a gas dryer.
2-1/2
3-1/2
1-3/4 Gas Pipe Electrical
12
Connection Connection
BATHROOM OR BEDROOM INSTALLATION:
The dryer MUST be exhausted to the outdoors.
he installation must conform with the local codes, or in the absence of
T
local codes, with the National Electric Code and National Fuel Gas Code,
ANSI Z223 for gas dryers.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INSTALLATIONS:
Minimum clearances to combustible surfaces 0" both sides, 3" rear.
FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.
PEDESTAL DIMENSIONS (IN INCHES)
SBSD137HWW - WHITE
This optional 13" pedestal
raises the door opening and
height of the washer or dryer.
Feet on 13" pedestal allow
it to adjust to 13-3/8" height.
27
13
28-3/4
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Listed by
Underwriters
Laboratories
Specification Revised 1/16
GFDL110EH
GE Appliances 7.0 Cu. Ft. Capacity
Electric Dryer With 200-Ft. Long Venting
SPECIAL INSTALLATION REQUIREMENTS
For complete information, see installation instructions packed with your dryer.
DUCTING MATERIALS: For best performance, this dryer should be vented with 4" diameter
all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible metal
(semi-rigid) ducting can be used (Kit WX08X10077). In special installations, it may be necessary
to connect the dryer to the house vent using a flexible metal (foil-type) duct. A UL-listed flexible
metal (foil-type) duct may be used ONLY in installations where rigid metal or flexible metal (semirigid) ducting cannot be used AND where a 4" diameter can be maintained throughout the entire
length of the transition duct. Please see installation instruction packed with your dryer for complete
instructions when using flexible metal (foil type) ducting.
EXHAUST LENGTH CALCULATION:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the
side or bottom of dryer, add one turn.
2. The maximum length of 4' rigid (aluminum or galvanized) duct which can be tolerated is
shown in the table.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be
treated as a 90° elbow.
A turn over 45° should be treated as a 90° elbow.
Dryers must be exhausted to the outside.
CAUTION: For personal safety do not terminate exhaust into a chimney, under any enclosed house
floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or moisture
could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen exhaust,
since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc.
The wall cap must also be located at least 12" above the ground or any other obstruction with the
opening pointed down.
FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
DRYER EXHAUSTING INFORMATION—USE METAL
DUCT ONLY VERTICAL AND HORIZONTAL DUCTING
BEST PERFORMANCE
Maximum length
of 4" dia rigid
A 4
metal duct
B
Exhaust hood type
A
Number
A
B
4
2-1/2
of 90°
4"
2-1/2"
B
Domestic dryer models
turns
opening opening
0
200 ft.
175 ft.
1
185 ft.
165 ft.
2-1/2
2
175 ft.
155 ft.
3
165 ft.
145 ft.
GE Front Load Long Vent 7.0
4
155 ft.
135 ft.
cu. ft. capacity electric dryer
(GFDL)
5
145 ft.
125 ft.
0
150 ft.
125 ft.
1
135 ft.
115 ft.
2
125 ft.
105 ft.
3
115 ft.
95 ft.
Long Vent 6.0 - 8.0 cu. ft.
4
105 ft.
85 ft.
capacity electric & gas dryers
(GTDL and GTV)
5
95 ft.
75 ft.
0
120 ft.
90 ft.
1
100 ft.
75 ft.
2
85 ft.
65 ft.
3
70 ft.
55 ft.
Long Vent 7.0 cu. ft. capacity
4
60 ft.
45 ft.
electric & gas (GTD42, GTD45,
GTD65, GTX42 and GTX60)
5
55 ft.
35 ft.
0
90 ft.
60 ft.
All 6.0 - 8.3 cu. ft. capacity
1
60 ft.
45 ft.
models electric and gas dryers
2
45 ft.
35 ft.
(GFDS, GFDR, GFDN, GTDS,
3
35 ft.
25 ft.
GTDN, GHDN, GHDS, GTDP,
GLDP, GTD, HTDP, HTDX)
4
25 ft.
15 ft.
0
90 ft.
60 ft.
1
60 ft.
45 ft.
2
45 ft.
35 ft.
DCVH480
3
35 ft.
25 ft.
0
46 ft.
37 ft.
1
37 ft.
30 ft.
2
30 ft.
22 ft.
All 3.6 cu. ft. (DSKS, DSKP)
electric dryers
3
23 ft.
15 ft.
0
56 ft.
42 ft.
1
48 ft.
34 ft.
2
40 ft.
26 ft.
Laundry Center GUD27
3
32 ft.
18 ft.
0
43 ft.
36 ft.
1
33 ft.
26 ft.
2
24 ft.
16 ft.
Laundry Center GUD24
A
Listed by
Underwriters
Laboratories
Specification Revised 1/16
GFDL110EH
GE Appliances 7.0 Cu. Ft. Capacity
Electric Dryer With 200-Ft. Long Venting
FEATURES AND BENEFITS
Dura Drum provides long-lasting dependability
HE SensorDry™ with dual thermistors continually monitors moisture and
temperature to prevent clothing wear and tear due to over-drying and
inconsistent heat
Speed Dry quickly dries items and small loads for families on the go
e Dry option – energy saving option reduces dry temperatures on select
cycles without sacrificing performance
4 heat settings – provide the right temperature for the right drying needs
6 dry cycles – additional cycles for your clothes-drying needs
200 ft. long-venting capability – Provides flexible installation
Model GFDL110EHWW – White
GFDN110ED_GDWW
Specification Revised 1/16
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement