HZB-12-230V Manual - Improvements Catalog

HZB-12-230V Manual - Improvements Catalog
Thanks for shopping with Improvements!
Personal Ice Maker
Item #504767
It is important that you read these instructions before using your portable ice maker and we
strongly recommend that you keep them in a safe place for future reference.
To order, call
1-800-642-2112
West Chester, OH 45069
Personal Ice Maker #504767
Made in China
0715
If you have questions regarding this product, call
1-800-642-2112 Mon.-Fri. 9:00-5:00 EST (Ohio)
and ask for our product specialists, or e-mail:
[email protected]
See many more products on the Internet!
www.ImprovementsCatalog.com
Current instructions at www.improvementscatalog.com 1-800-642-2112
Page 1 of 7
TABLE OF CONTENTS
TECHNICAL PARAMETERS……………………………………………………………. ….2
PREPARING YOUR ICE MAKER FOR USE
IMPORTANT SAFETY TIPS…………………………………………………………………..……3
GETTING TO KNOW THE ICE MAKER…
…………………………………………………….4
POSITION OF CONTROL PANEL & FUNCTION….………………………………………….…….5
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER………………….………………………………….…………..6
CONNECTING YOUR ICE MAKER……………….……….………………………….…………..6
CLEANING AND MAINTAINING YOUR ICE MAKER….…………………………….…………….6
USING YOUR ICE MAKER……………….……..…………………………….……………..7
TROUBLESHOOTING…………………………….………………………………….……………7
TECHNICAL PARAMETERS
Model
Protection Type
Climate Type
Power
#504767 BLK,RED,WTH,SLV
I
SN/N/ST
110-120V/60Hz
#504767 SST
I
SN/N/ST
110-120V/60Hz
Ice Making Current
1.5A
1.5A
Ice Harvest Current
2.0A
2.0A
Refrigerant
R134a/64g
Net Weight
8.1Kg
8.2kg
Vesicant
C5H10
C5H10
Enclosure
Plastic
Stainless
Personal Ice Maker #504767
R134a/64g
Current instructions at www.improvementscatalog.com 1-800-642-2112
Page 2 of 7
PREPARING YOUR ICE MAKER FOR USE
IMPORTANT SAFETY NOTES
Your safety and the safety of others are very important.
When using electrical appliances, basic safety precautions should be followed to reduce
the risk of fire, electric shock, and injury to persons or property. Read all instructions before
using any appliance.
• Do not operate this or any other appliance with a damaged cord or plug.
• Connect to properly polarized and grounded outlets only. No large appliances should be
plugged into the same outlet. Be sure that the plug is fully inserted into the outlet.
• Do not run the power cord under carpeting or other heat insulators. Do not cover the cord.
Keep cord away from traffic areas, and do not submerge in water.
• We do not recommend the use of an extension cord, as it may overheat and become a
risk of fire. If you must use an extension cord, use No.14 AWG minimum size and rated no
less than 1875 watts.
• Unplug the ice maker before cleaning or making any repairs or servicing.
• Exercise caution and use reasonable supervision when appliance is used near children.
• Do not use your ice-maker outdoors. Place the ice-maker away from direct sunlight and
make sure that there is at least 4 inches of space between the back of your unit and wall.
Keep at least 4 inches of space on each side of your unit.
• Only use water to make ice-cubes. Do not use any other liquid in this unit.
• Do not clean your ice maker with flammable fluids. The fumes can create a fire hazard or
explosion.
• Do not tip the unit over.
• If the ice maker has been brought in from outside in cold temperatures, wait up to 2 hours
for the unit to warm up to room temperature before plugging it in.
DANGER: This appliance must be grounded.
IMPORTANT: To avoid a hazard due to instability of the appliance, it must be placed on a
flat, horizontal surface.
Personal Ice Maker #504767
Current instructions at www.improvementscatalog.com 1-800-642-2112
Page 3 of 7
GETTING TO KNOW THE ICE MAKER
Parts:
1.
2.
3.
4.
5.
6.
Ice Scoop.
Ice Full Sensor
Ice Basket
Top Cover with transparent window
Air Outlet
Water Drain Cap: for draining water from the reservoir.
▲
7. MAXIMUM WATER LEVEL:
Remove the ice basket to see the water level mark.
4
1
2
3
5
6
7
Personal Ice Maker #504767
Current instructions at www.improvementscatalog.com 1-800-642-2112
Page 4 of 7
Position of control panel & function
Control Panel: Easy to use, visible functions touch display setting.
A. Selected ice size displaying: Small and Large.
B. Power indicator
C. Ice-Full indicator
D. Water shortage indicator
E. Button to turn the unit on/off.
F. Button to select ice cube size.
Personal Ice Maker #504767
Current instructions at www.improvementscatalog.com 1-800-642-2112
Page 5 of 7
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging. Check if ice basket and ice scoop inside. If any
parts are missing, please contact our customer service.
2. Remove the tapes for fixing ice shovel, ice basket & ice scoop. Clean the tank & ice basket.
3. Put the ice maker on a level & flat counter top without direct sunlight and other sources of
heat (i.e.: stove, furnace, radiator). Maker sure that there is at least 4 inches gap between
the back & LH/RH sides with the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging the ice maker into an outlet.
5. The appliance must be positioned so that the plug is accessible.
CONNECTING YOUR ICE MAKER
DANGER
* Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under
any circumstances, cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 110-120volt, 60Hz electrical outlet with three-prong
ground.
CLEANING AND MAINTAINING YOUR ICE MAKER
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Then use the water to rinse the inside parts, and drain out the water by unplugging the drain
cap on front bottom side.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and
warm water.
5. Dry the interior and exterior with a clean soft cloth.
6. When the machine is not to be used for a long time, drain water completely & dry the
interior.
Personal Ice Maker #504767
Current instructions at www.improvementscatalog.com 1-800-642-2112
Page 6 of 7
USING YOUR ICE MAKER
1. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the maximum level mark. Place the ice basket back into the ice maker and
close the lid.
2. Plug in the unit and the power indicator light will blink.
3. Press “Power” button on the control panel to begin the ice making cycle.
4. Select the ice cube size by pressing the “Select” button. If the room temperature is lower than 60℉, it
is recommended to select small ice cube in order to avoid ice sticking together.
5. The ice making cycle lasts approx. 6 to 13 minutes, depending on selection of ice cube size and the
o
room temperature. The recommended room temperature is 50 to 105
o
6. If water pump can’t inject water, the ice maker will stop automatically, and the “Add Water” indicator
will be on. Press “Power” button, fill water up to the max. water level mark and press “Power” button
again to turn on the unit again. Allow the refrigerant liquid inside the compressor at least 3 minutes to
settle before restarting.
7. The ice maker stops when the ice basket is full and the “Ice” indicator will be on. Warning: Direct
sunlight or sunlight reflection may cause infrared sensor malfunction. If the unit doesn’t stop
even ice cubes obstruct sensor, move the unit where no sunlight.
8. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
If unit is used for more than 1 week, drain all the water and dry the tank.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
“Add Water” indicator
is on.
Lack of Water.
“Ice” indicator is on.
Ice is full in basket.
Ice cubes stick
together.
Ice making cycle is
normal but no ice
formed.
Personal Ice Maker #504767
The ice making cycle is too
long.
SOLUTION
Stop the ice maker, fill water, and press
“Power” button again to restart the unit.
Remove ice from ice basket. Continuous
press “Select” button 5 seconds, the
unit could make ice 10 cycles even
“Ice” indicator is on.
Stop the ice maker, and restart it when the
ice blocks melt. Select the small size ice
cube selection.
Replace the water. Temperature of water
recommended at 15o to 90o F
The room temperature should be 50o F
-105o, water temperature should be 15o
-90o
Water temperature in inner
tank is too low.
Room temperature or water
temperature in inner tank is
too high.
Refrigerant in cooling
Verify by a qualified technician.
system leaks.
Pipe in the cooling system is
Verify by a qualified technician.
blocked.
Current instructions at www.improvementscatalog.com 1-800-642-2112
Page 7 of 7
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement