User Guide

dEmeson"
&J Bluetooth
Wireless Stereo Speaker
EBT950
[se
Wireless Stereo Speaker
[ni
Bluetooth User Guide
Speaker
Co
3.5mm Micro USB
Auxiliary Cord Charging
Cable
Location of controls
gEeneson
=
DOY —WQ г nn @—
pl вы ul ; | x
| | e [ | |
Tri Fi
12 3 4 5 67 8 9
Front Back
1. [1 ] button: Next track
2. [ »>] ] button: Previous track
3. Microphone
4. [ "% 1 button:
Quickpress = Play / Pause / Answer Call / End Call
Press & Hold= Power ON/OFF
5. LED indicator light volume
6.[ = ] button: Decrease volume
7.[ + 1button: Increase volume
8. Micro USB Charging Port
9. AUX IN Jack
1. Connect the small end of the USB charging cord into the
Micro USB charging port on the back of the speaker.
2. Connect the other end of the USB cable to your
computers USB port.
3.The LED indicator light turns RED when charging.
4.The LED indicator light turns OFF when finishing charging.
— =
Micro Speaker
USB Charging
Cable
— >
Pairing the speaker with a Bluetooth
enabled device
1. Keep your Bluetooth Speaker and Bluetooth enabled
device within 3 feet of each other during the pairing
process.
2. Turn on the Bluetooth Speaker by pressing the [74]
button for 3 seconds. If no other devices are paired yet,
then the LED indicator light will start to flash BLUE every
second, which means the Bluetooth Speaker is already in
PAIRING mode.
within 3 feet
NOTE: If you have already paired a Bluetooth enabled
device and it is powered on, the speaker will connect to that
device automatically and will not go into pairing mode.
3. Set your mobile phone or other Bluetooth enabled device
to search for Bluetooth devices.
Bluetooth: Enabled
Paired Devices:
*Empty *
Searching for devices
IE und |
4. When the device finds the Bluetooth Speaker, confirm by
selecting EBT950 from the list.
Bluetooth: Enabled
Paired Devices:
EBT950
EBT950
Select Device:
5. Select Pair"to connect the Bluetooth Speaker to your
Bluetooth enabled device.
Bluetooth: Enabled
Paired Devices:
EBT950
“EBT950" would like to pair
with your phone. Would you
like to allow it to pair?
cancel И В
Bluetooth: Enabled
Paired Devices:
EBT950
| Q Enter numeric passkey
for EBT950:
0000
Enter passcode “0000” if prompted by the device.
6. Your Bluetooth enabled device will confirm that the pairing
was completed, and prompt you to accept the connection.
Please respond YES to connect the Bluetooth Speaker to
your Bluetooth enabled device. If the connection is made,
the LED indicator light will blink slowly. After a successful
registration, the LED indicator light will stop flashing.
Bluetooth: Enabled
Paired Devices:
EBT950
Accept connection request
from EBT950?
| ves 1/ В
M Don't ask this again
7. When attempting to reconnect the Bluetooth Speaker to
your Bluetooth enabled device, you may see the message
below, and your Bluetooth device will prompt you to accept
the connection request to the EBT950 speaker, and an
option not to ask this again. Please accept the connection,
and if you select “Don't ask this again’, your Bluetooth device
will automatically accept future connection requests from your
Bluetooth Speaker.
Bluetooth: Enabled
Paired Devices:
EBT950
63 Confirm connection to
EBT950?
Lyes )/ QUE
NOTE: If an audio cable is connected to the AUX IN jack of
the Bluetooth Speaker, a connection via Bluetooth is not
possible. Due to the variety of device manufacturers,
models and software versions, a full functionality is not
guaranteed.
(D
Powering ON/OFF
To turn ON, press and hold the [ 7% ] button for 3
seconds. The LED indicator light will flash BLUE.
To turn OFF, press and hold the [ 7% ] button for 3
seconds. The LED indicator light will blink twice quickly
and then turn off.
NOTE: If there are no paired devices in range, when the
speaker is turned on, it will go into pairing mode automatically.
Answering / Ending a call
* То answer a call, quickpress the [7%] button.
-Toenda call, quickpress the [*% ] button.
Adjusting the volume
Press & hold the [ +] or [ — ] button to adjust the volume
to the desired level.
NOTE: You may also adjust the volume from your phone's
volume control.
To make a call
Dial the number and press the send button on your mobile
phone, the call is automatically transfered to the speaker.
Rejecting Calls
To reject an incoming call, longpress the [ 74] button for 3
seconds.
Playing Music
To enjoy wireless music on your Bluetooth Speaker, make
sure you are connected to a Bluetooth enabled device.
Once connected you can press PLAY on your Bluetooth
device or you can press the [74] button on the EBT950
Bluetooth Speaker. Once playback has begun, you can
control the music from the control buttons of the Bluetooth
speaker (with devices that have the AVRCP Bluetooth
profile).
Adjusting the volume
+ Quickpress the [ + Jor[ — ] button to adjust the
volume to the desired level.
(D
Play/Pause
Press the [ "%] button to pause the music. To resume music
playback, press the [ "4 ] button again.
Skipping Songs
(With devices that have Bluetooth profile)
Press and hold the [ »» ] button to go to the next song.
Press and hold the [ l<« ] button to go to the previous song.
led» I/O + —
1 2 3 4 5
1. [ << ] button: Next track
2.[ »M ] button: Previous track
3.[ % ] button:
Quickpress = Play / Pause / Answer Call / End Call
Press & Hold= Power ON/OFF
4.[ + ] button: Decrease volume
5.[ — ] button: Increase volume
Answering / Ending Calls
If the Bluetooth Device you are using to play music is a
mobile phone and you receive a phone call, the music will
be interrupted.
—
. If you accept the call, the conversation will be replayed
by the Bluetooth Speaker. You can speak into the
microphone of the Bluetooth Speaker during the
conversation. After you have ended the call, the devices
will remain connected and playback will continue.
2. If you reject the call, playback will continue.
Using as a Wired Speaker
The EBT950 can be used as a wired speaker by using the
included 3.5mm Auxiliary Cord.
1. Plug one end of the Auxiliary Cord into the AUX IN jack on
the back of the speaker.
2. Plug the other end of the Auxiliary Cord into the
headphone jack of any media device that has a 3.5mm
headphone jack (this is standard headphone-out-jack).
3. Use your media device's music conrols to control the
music. When using the Auxiliary Cord, the speaker's
buttons will not function.
*The Emerson Bluetooth Speaker is compatible with any
brand of Bluetooth-enabled phone or music device that
supports Advanced Audio Distribution Profile (A2DP)
and Audio Video Remote Control Profile (AVRCP).
In order for Bluetooth devices to communicate with one
another properly, they must utilize the same Bluetooth
profile. To determine the profiles supported by your
device (mobile phone, gaming console, computer or mp3
player), please refer to the device's user guide.
Certain Bluetooth features including those listed may not
be supported by all compatible Bluetooth-enabled
devices, and/or the functionality of such features may be
limited in certain devices.
Troubleshooting tips
«The battery may be exhausted. Try charging the battery.
©
+ The volume level of the external audio source may be too
low. Try increasing the volume of the external audio source.
+The volume level of the Bluetooth Speaker may be too low.
Try increasing the volume of the Bluetooth Speaker.
©
+ If the Bluetooth Speaker is turned OFF, then turn it ON.
+ The Bluetooth Speaker may not be paired to the Bluetooth
Device. Try checking whether the connection exists. If
necessary, try pairing the Bluetooth Device to the
Bluetooth Speaker again.
+ The audio cable may be connected. If so, remove the cable.
*The volume level of the Bluetooth Device may be too low.
Try increasing the volume of the external audio source.
‚The volume level of the Bluetooth Speaker may be too low.
Try increasing the volume of the Bluetooth Speaker.
©
*+ Make sure your Bluetooth device supports A2DP profile.
Turn up the volume on your Bluetooth device.
©
+ Make sure the Bluetooth Speaker is turned ON before
beginning the pairing process.
+ Keep your Bluetooth Speaker and Bluetooth enabled
device within 3 feet of each other during the pairing
process.
« Press and hold the [”% ] button for approximately 3
seconds. The LED indicator light will start to flash BLUE,
which means the Bluetooth Speaker is set to PAIRING
mode.
« Check that YOUR device's Bluetooth feature is turned ON.
« Try repeating the pairing process, see “Pairing the Speaker
with a Bluetooth enabled device".
Safety information
Check local laws regarding use of a mobile handset and wireless
headset while driving. If you use the Bluetooth Headset
driving, ensure your attention and focus remains on your driving.
Observe all signs in the designated areas where some electronic
devices or RF radio products are required to be switched off.
These could include airplanes, hospitals, blasting areas, and
potentially explosive atmospheres.
CAUTION: Although this device enables drivers to
conduct handsfree conversations, it is still dangerous
to drive and use a mobile phone at the same time.
Always keep your full attention on your driving.
Product maintenance
Power off this product when not in use.
DO NOT expose this product to water or other liquids.
DO NOT use abrasive cleaning solvents to dean the Bluetooth Speaker.
If you will not use the Bluetooth Speaker for long periods, be sure
store it ina dry place, free from extreme temperature humidity and dust.
E) FCC and telephone company information
FCC Part 15
This equipment has been tested and found to comply with the
requirements for a Class B digital device under Part 15 of the
Federal Communications Commission (FCC) rules. These
requirements are intended to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
Do not attempt to repair or modify this equipment.
Warning: Changes or modifications to this equipment not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
©) Industry Canada
Operation is subject to the following two conditions: (1) This
device may not cause interference and (2) This device must
accept any interference, including interference that may
cause undesired operation of the device.
The term “IC:" before the certification/registration number
only signifies that registration was performed based on a
Declaration of Conformity indicating that Industry Canada
technical specifications were met. It does not imply that
Industry Canada approved the equipment.
Limited Warranty
In the unlikely event that this product is defective, or does
not perform properly, you may within ninety (90) days from
your original date of purchase return it to the authorized
service center for repair or exchange.
TO OBTAIN WARRANTY SERVICE:
Provide proof of the date of purchase within the package
(Dated bill of sale).
Prepay all shippingcosts to the authorized
and remember to insure your return.
Include a return shipping address (no P.O. Boxes),
a telephone contact number, and the defective unit within
the package.
Describe the defectorreason you are returning
Your product will be repaired or replaced, at our option, for the same
or similar model of equal value if examination by the service center
determines this product is defective. Products received damaged
as a result of shipping will require you to file a claim with the carrier.
a \
The shipping address of the authorized service center is:
ES Southern Telecom Inc.
Customer Service - 2nd Floor
14-C 53rd Street
Brooklyn, NY 11232
e J
4
Should you have any questions or problems concerning this
product, please contact our customer service department at:
1-877-768-8483 (Toll Free)
Monday - Thursday: 9AM - 6PM (EST)
Friday: 9AM - 3PM (EST)
or
via e-mail at
[M] [email protected]
N À
Warranty service not provided
This warranty does not cover damage resulting from accident,
misuse, abuse, improper installation or operation, lack of reasonable
care, and unauthorized modification. This warranty is voided in
the event any unauthorized person opens, alters or repairs this
product. All products being returned to the authorized service
center for repair must be suitably packaged.
Limitation of Warranty:
THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY
APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE
HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION
GIVEN BY SOUTHERN TELECOM INC. IT'S AGENTS, OR EMPLOYEES
SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE
SCOPE OF THIS WARRANTY.
* REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY
IS THE EXCLUSIVE REMEDY OF THE CONSUMER. SOUTHERN
TELECOM INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS
OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER
OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED
BY THE LAWS OF THE STATE OF NEW YORK. EXCEPT TO THE
EXTENT PROHIBITED BYAPPLICABLE LAW, ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE
ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY
PERIOD SET FORTH ABOVE.
Some states do not allow the exclusion nor limitation of incidental
or consequential damages, or limitations on how long an implied
warranty lasts so the above limitations or exclusions may notapply
to you. This warranty gives you specific legal rights, and you also may
have other rights that vary from state to state.
Emerson”
www.emersonphones.com
Manufactured by Southern Telecom Inc. Brooklyn, NY 11232
© 2013 Southern Telecom Inc. All rights reserved.
Emerson and the G-Clef logo are registered trademarks of
Emerson Radio Corp. Parsippany, New Jersey USA.
The Bluetooth® word mark and logos are owned by the Bluetooth
SIG, Inc.