ARTEC AVENUE DC POWERED Street Band Amplifier User manual

Below you will find brief information for AVENUE DC POWERED. This amplifier is designed for musicians who need a portable and powerful solution for street performances. It features a built-in 8-inch speaker and a 1-inch horn, providing clear and powerful sound reproduction. The AVENUE DC POWERED amplifier also includes a 3-band equalizer, reverb effects, and a dual preamp control for shaping your sound. This amplifier can be powered by a 15V DC power supply or by ten AA batteries. It includes a headphone jack for silent practice. The DRIVE control allows you to add overdrive effects to your sound, while the REVERB control adds depth and space.

PDF

Document

DC POWERED
STREET BAND
AMPLIFIER
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
IMPORTANT SAFETY INSTRUCTIONS
- DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS.
- ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES
AND COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE
APPARATUS.
- ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR SAFE
OPERATION AND TO AVOID INJURY.
- WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK OR FIRE, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
- SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL.
- OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH
SOUND PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND
EAR PROTECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME.
INPUT GAIN
CONTROL
LEVEL of DRIVE EFFECT
- 0~1 position : bypass
- 2~10 position : drive level
* for GT channel only
CONTROL PANEL
TWO WAY FOOT SWITCH
- tip : drive on/off
- ring : reverb on/off
* drive and reverb controls
must be set to desired sound
CD / MP3 INPUT
RCA-JACK
MIC channel
BALANCED
XLR INPUT
(for MIC or
ACOUSTIC
GUITAR)
MIC channel
BALANCED
INPUT
REC OUT /
PHONE JACK
GT channe l INPUT
- for high impedance
passive instruments
DUAL PREAMP CONTROL
- 12 o’clock : minimum gain
- turn to clockwise : heavy drive
- turn to counterclockwise : tweed drive
Reverb time and level control
* for MIC and GT channel
3 BAND EQUALIZER
DC POWER INLET
* DC15V1A
regulated or
SMPS only
MASTER VOLUME
POWER
SWITCH
POWER
INDICATOR
BLOCK DIAGRAM
GAIN
BASS MIDDLE TREBLE
CD / MP3 IN
REC OUT
/ PHONE
MASTER
VOLUME
POWER
AMP***
SPEAKER
LEVEL GAIN
GAIN
TIME
BASS MIDDLE TREBLE
DRIVE
MIXER
LEVEL
REVERB
FOOT SW
SETTING GUIDE
Gain setting
Drive setting
Reverb setting
Humbucker or
active pickup
Heavy Metal
Reverb
Single pickup
Blues O.D
Room reverb
General
microphone
Rock
Distortion
Hall reverb
Preamp equipped
Acoustic guitar
Crunch
Distortion
SPECIFICATION
8 inch speaker
1 inch horn (not actual speaker)
Bass reflex hole
DIMENSION : 275 x 360 x 250 (mm)
SPEAKER : 8 inch LF
OUTPUT : 20 watts music power
DC POWER : Max 1A @ 15V
POWER CONSUMPTION : 15W(DC) max
FREQUENCY RANGE : 60Hz ~ 8kHz
BATTERY LIFETIME : avg 8~10 hours (Alkaline)
EQ (Both ch)
Bass frequency : 180Hz peak
Bass gain : -10dB ~ +10dB
Middle frequency : 900Hz
Middle gain : -10dB ~ +10dB
Treble frequency : 2KHz peak
Treble gain : -10dB ~ +10dB
A PRODUCT OF ARTECSOUND CO., LTD. KOREA
Battery Holder
use ten AA size
alkaline or rechargeable
MIC CH
LOW-Z BALANCE XLR
Max input level : +10dBV
Max gain : 60dB
LOW-Z (10kohm)
BAL / UNBAL INPUT
Max input level : +10dBV
Max gain : 60dB
GT CH
HI-Z (500kohm)
UNBALANCE INPUT
Max input level : +8dBV
Max gain : 70dB
(for passive instrument)
MADE IN CHINA
">

Hello! I am an AI chatbot specifically trained to assist you with the Artec AVENUE DC POWERED User manual. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts

Assistant typing

Assistant is out of keyboard. Please, try again later.

Key features

8-inch speaker
1-inch horn
3-band equalizer
Reverb effects
Dual preamp control
DC power supply or battery powered
Headphone jack
DRIVE control
REVERB control

Frequently asked questions

The amplifier can be powered by a 15V DC power supply or by ten AA batteries.

The frequency range of the amplifier is 60Hz ~ 8kHz.

This amplifier features a built-in 8-inch speaker and a 1-inch horn, a 3-band equalizer, reverb effects, a dual preamp control, a headphone jack, a DRIVE control, and a REVERB control.