SP Controls Application Note ASK Proxima C180 Revision B I. Driver Features 1. Command Format This device is controlled through RS-232. 2. RS-232 Commands Power On Power Off Volume (Absolute) Source: VIDEO Source: S-VIDEO Source: Computer 1 Source: Computer 2 Menu Adj Up Adj Down Select Mute On Mute Off 3. Other Driver Features Default Power Status Feedback: Projector Restart Lockout Timer (Default): Black On Black Off RS-232 Polling 125 Seconds II. RS-232 Control Wiring For IR wiring, see product manual for the SP Controls device. Wire RS-232 control to a female DB9 as follows: TX to 2 RX to 3 SP Controls Device GND to 5 Control Cable Connect female DB9 to projector port labeled Serial Control. Serial Adapters (for NRC only): None III. Projector Configuration Set Auto Source to OFF– Using the ASK Proxima menus navigate to the Sources menu, which is found inside the Settings menu, and UNCHECK the AUTO SOURCE option. Set Auto Power to OFF - Using the ASK Proxima menus navigate to the System menu, which is found inside the Settings menu, and UNCHECK the AUTO POWER option. Set Power Save to OFF - Using the ASK Proxima menus navigate to the System menu, which is found inside the Settings menu, and UNCHECK the POWER SAVE option. © 2004-9 SP Controls Inc. SP Controls reserves the right to modify specifications without notice at any time.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project