User manual | Honda GX 120, GX 140, GX 160, GX 200, GX 240, GX 270, GX 340, GX 390, GXV 140, GXV 160, GXV 270, GXV 340, GXV 390 Engine Check sheet

Carburetor Check Sheet
GX120/140/160/200/240/270/340/390
GXV140/160/270/340/390
Priority check Points :
• Unstable idle speed
• Poor performance at low speed
1
2
4
8
9
10
FUEL
• Engine speed will not increase
• Poor performance at high speed
• Unstable engine speed
COMBUSTION
ESSENTIALS
8
COMPRESSION
IGNITION
Before inspecting the fuel system, perform the minimum
inspection for compression and ignition system.
1
Pilot screw
clogged.
Remove foreign material/dirt.
Replace pilot screw.
6
2
Pilot jet
clogged.
Remove foreign material/dirt.
1
3
Use needle B (
0.3) to clean
Pilot jet air
path clogged.
Remove foreign material/dirt.
4
5
Main jet
clogged.
Main nozzle
clogged.
Use needle A (
0.5) to clean
Set correct idle speed.
7
Float doesn’t
move properly.
Remove foreign material
around float pin.
5
9
Use needle B (
0.3) to clean
3
Pilot jet air
path clogged.
Remove foreign material/dirt.
4
Main jet
clogged.
Remove foreign material/dirt.
Use needle A (
7
4
11
12
8
Fuel flow
0.5) to clean
Main nozzle
clogged.
Remove foreign material/dirt.
Main nozzle air
path clogged.
Remove foreign material/dirt.
Mixture
Pilot screw and limiter cap replacement
LIMITER CAP
Drain gasoline from float chamber
by running the engine until it stops
or by loosening the drain screw
while engine is stopped.
When the cap is removed, the pilot screw breaks
at the neck. To remove the remaining screw, fit an
appropriate rubber tube over the remaining stub
and unscrew.
• Overflow
• Gasoline leak
PILOT SCREW
Aplly LOCTITE 638
Water inside float chamber.
Take off float chamber and
clean or replace.
Using of Carburetor Cleaning Kit (Kit No.07JPZ-0010001)
www.honda-engines-eu.com
Needle A ( 0.5)
(Main jet)
Needle B ( 0.3)
(Pilot jet)
9
Float valve worn
or coated with
foreign material/
dirt.
Remove foreign material/dirt.
10
Valve seat
coated with
foreign material/
dirt.
Remove foreign material/dirt.
Take care not to damage
the seat surface.
Install a new pilot screw and set it to the
specified position. (Refer to shop manual.) Then
install the limiter cap with LOCTITE 638.
Carburetor cleaning kit for removing foreign material/dirt.
Float chamber
check
Remove foreign material/dirt.
5
Pilot screw brakes at narrow point.
12
Pilot jet
clogged.
Remove foreign material/dirt.
6
(More than 3 months).
2
Remove foreign material/dirt.
Throttle stop
screw position
incorrect.
11
Remove foreign material/dirt.
Replace pilot screw.
10
Air flow
For extended
storage of
the engine
Pilot screw
clogged.
2
3
• Engine will not start
• Difficult starting
• Engine starts but stops quickly
1
Pump nozzle
(Air blow for jets and air paths)
Screw driver
(Main jet assemble
/disassemble)