READ AND SAVE THESE INSTRUCTIONS.
RULES FOR SAFE OPERATION
1. WARNING! To reduce the risk of fire or
electric shock, do not use this blower with
any solid‑state speed control device.
8. Disconnect blower before
removing grills for cleaning.
9. Be sure blower is on a stable surface
2. This appliance has a polarized plug
when operating to avoid overturning.
(one blade is wider than the other).
10.DO NOT use blower in window.
To reduce the risk of electric shock, this
Rain may create electrical hazard.
plug is intended to fit into a polarized outlet
only one way. If the plug does not fit fully
11.Maintain labels and nameplates on the blower.
in the outlet, reverse the plug. If it still
If unreadable or missing, contact
does not fit, contact a qualified electrician.
Harbor Freight Tools for a replacement.
Do not change the plug in any way.
Do not attempt to defeat this safety feature. 12.Use only in dry areas.
Do not use in bathrooms, laundry area,
3. Do not leave blower running
near sinks or other sources of water.
while unattended.
13.This blower is not a toy.
4. Do not operate any blower with a
Keep it out of reach of children.
damaged cord or plug. Discard blower
or return to an authorized service
14.WARNING: Handling cord on this blower
facility for examination and/or repair.
will expose you to lead, a chemical known
to the State of California to cause cancer,
5. Do not run cord under carpeting.
and birth defects or other reproductive harm.
Do not cover cord with throw rugs,
Wash hands after handling.
runners, or similar coverings. Arrange
(California Health & Safety Code
cord away from traffic area and
§ 25249.5, et seq.)
where it will not be tripped over.
15.The warnings, precautions, and instructions
6. Never insert fingers, pencils, or any other
discussed in this instruction manual cannot
object through Front or Rear Blade Guards.
cover all conditions and situations that may
occur. It must be understood by operator
7. Disconnect blower when moving it
that common sense and caution are factors
from one location to another.
which cannot be built into this blower,
but must be supplied by operator.
Page 2
For technical questions, please call 1-800-444-3353.
Item 69721
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
Specifications
Electrical Rating
120V~ / 60Hz / 1.5A
Maximum Air Flow
300 CFM
220633
Item 69721
For technical questions, please call 1-800-444-3353.
Page 3
Operation
Read the ENTIRE RULES FOR SAFE OPERATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this blower.
1. Make sure the blower’s Speed Control
is in the ″OFF″ position.
Reset
Button
2. Plug the Power Cord into a
GFCI-protected outlet.
3. Position the blower as desired.
It can rest on different Pads to
direct the airflow at different angles.
It must rest on a level, firm base.
4. Leave adequate space around the blower
for unimpeded air flow. Air flows in at the
sides of the blower. Do not allow dirt or
debris to be drawn into the blower.
5. Rotate the Speed Control to the desired speed
setting. To turn the blower OFF, rotate the
blower’s Speed Control to the ″OFF″ position.
Note: If blower suddenly stops operating,
the Overload Protection may have tripped.
Make sure that the blower is dry, that the
vents are not obstructed, and that the blower
has cooled completely before pressing the
Reset Button and continuing to use the blower.
6. Additional powered devices can be plugged
into the 120V~ outlets on the sides of the
blower. Do not exceed 13A combined
current draw across the two outlets.
Speed Control
Figure A: Controls - top view
Handle
Air
Outlet
120V~
Outlet
Air
Inlet
7. To prevent accidents, turn off the blower
and unplug it after use. Clean, then store
the blower indoors out of children’s reach.
Pads
Figure B: Additional Components
Page 4
For technical questions, please call 1-800-444-3353.
Item 69721
User Servicing Instructions
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION OR ELECTRIC SHOCK:
Turn the Power Switch of the blower off, unplug the blower from its
electrical outlet, and allow the blower to cool completely before performing
any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM blower FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the blower. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
2. Clean outside housing regularly.
Use damp cloth during cleaning and
dry before use. Do not open housing
for cleaning or any other reason.
3.
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
WARNING! If the supply cord of this
blower is damaged, it must be replaced
only by a qualified service technician.
If blower suddenly stops operating
The Overload Protection may have tripped.
Before pressing the Reset Button and continuing to use the blower, make sure:
• that the blower is dry,
• that the vents are not obstructed, and
• that the blower has cooled completely.
Item 69721
For technical questions, please call 1-800-444-3353.
Page 5
Parts List and Diagram
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE
BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS,
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Parts List
Part
1
2
3
4
5
6
7
8
9
10
Description
Motor
Capacitor
Mounting Ring
Fan Wheel
Right Housing
Left Housing
Corner Pad
Slight Corner Pad
Straight Pad
Power Receptacle
Qty
Record Serial Number Here:
Note: If blower has no serial number,
record month and year of purchase instead.
Page 6
1
1
1
1
1
1
2
4
4
2
Part
11
12
13
14
15
16
17
18
Description
Speed Control Knob
Power Switch
Strain Relief
Handle
Overload Protection
/ Reset Button
Nut
Grill
Power Cord
Qty
1
1
1
1
1
1
1
1
Note: Some parts are listed and shown
for illustration purposes only, and are not
available individually as replacement parts.
For technical questions, please call 1-800-444-3353.
Item 69721
13
11
14
6
Assembly Diagram
10
9
8
7
15
12
5
17
16
10
18
4
3
2
1
Item 69721
For technical questions, please call 1-800-444-3353.
Page 7
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality
and durability standards, and warrants to the original purchaser that this product is free from
defects in materials and workmanship for the period of 90 days from the date of purchase. This
warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence or
accidents, repairs or alterations outside our facilities, criminal activity, improper installation,
normal wear and tear, or to lack of maintenance. We shall in no event be liable for death,
injuries to persons or property, or for incidental, contingent, special or consequential damages
arising from the use of our product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation of exclusion may not apply to
you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with
transportation charges prepaid. Proof of purchase date and an explanation of the complaint
must accompany the merchandise. If our inspection verifies the defect, we will either repair or
replace the product at our election or we may elect to refund the purchase price if we cannot
readily and quickly provide you with a replacement. We will return repaired products at our
expense, but if we determine there is no defect, or that the defect resulted from causes not
within the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state.
3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353
">
