Eyeball Adapter Connection Kit Installation Instructions

Eyeball Adapter Connection Kit Installation Instructions
Eyeball Adapter Connection Kit
Installation Instructions
This kit (part #9-100-8005) includes two eyeball
adapter connectors and four wall fitting plugs (two
standard and two large). One of the eyeball adapter
connectors includes a pressure relief valve. The other
is used to connect your Polaris 360.
1. If the pool has only one return line, the eyeball
adapter connector that connects the Polaris 360
will be installed in that line. The eyeball adapter
connector with the pressure relief valve and the
wall fitting plugs can be discarded. The eyeball
adapter connector that connects the Polaris 360
comes assembled with a wall fitting adapter, a wall
fitting washer and a connector head
to connect the Polaris 360.
Wall Fitting Adapter
3. The eyeball adapter connector that connects the
Polaris 360 will be installed in the return line that
is nearest the center point of the pool’s longest
wall. If this is the return line already chosen for the
eyeball adapter connector with the pressure relief
valve, or if two return lines are an equal distance
from the center point of the pool, select the return
line that is nearer to the pool equipment.
Wall Fitting Adapter
Wall Fitting Washer
Connector Head
(With Pressure
Relief Valve)
TL-808 Rev C
2. If the pool has more than one return line,
the eyeball adapter connector with the pressure
relief valve will be installed in the return line
that is farthest from the pool equipment. This
eyeball adapter connector comes assembled with
a wall fitting adapter, a wall fitting washer and a
connector head with a pressure relief valve.
Wall Fitting Washer
Connector Head
(To Connect the
Polaris 360)
Installation of the Eyeball Adapter
Connectors
1. Turn off the pool pump.
1. Turn off the pool pump.
2. Unscrew the retainer ring and remove and set
aside the eyeball.
2. Unscrew the retainer ring and remove and set
aside the eyeball.
Wall Fitting
with Eyeball Seat
Wall Fitting
with Eyeball Seat
Wall Fitting Plug
Retainer Ring
Wall Fitting Adapter
Retainer Ring
Connector
Head
Eyeball
Eyeball
3. Unscrew the wall fitting adapter from the
connector head and set aside the wall fitting
washer. Fit the wall fitting adapter through the
retainer ring and screw on the connector head. If
the wall fitting adapter falls through the retainer
ring, add the wall fitting washer between the
adapter and the retainer ring.
4. Screw the eyeball retainer ring back onto the
eyeball seat.
3. Fit the appropriately-sized wall fitting plug into the
retainer ring.
4. Screw the retainer ring back onto the
eyeball seat.
5. Turn on the pool pump and check the pressure
again. If the pressure is more than 5 pounds
higher than it was before you installed the wall
fitting plugs, please contact your Polaris dealer for
special instructions.
Installation of the Wall Fitting Plugs
If there are additional return lines in the pool after the
two eyeball adapter connectors have been installed,
the wall fitting plugs should be installed in these lines.
Large Size
Standard Size
Wall Fitting Plugs (2 of each included)
Please note: Before installing any wall fitting plugs,
note the pressure reading on the pool pump’s pressure
gauge.
Zodiac Pool Systems, Inc.
2620 Commerce Way, Vista, CA 92081
1.800.822.7933 | www.polarispool.com
© 2015 Zodiac Pool Systems, Inc. All rights reserved. Polaris® and the Polaris 3-wheeled
cleaner design are registered trademarks of Zodiac Pool Systems, Inc.
All other trademarks referenced herein are the property of their respective owners.
TL-808 Rev C
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement