Sonofresco Coffee Roaster Ignition Unit Replacement Instructions

Sonofresco Coffee Roaster Ignition Unit Replacement Instructions
Sonofresco Coffee Roaster
Ignition Unit Replacement Instructions
(Ram Module)
Read and understand these instructions before attempting the gas valve replacement.
•
DISCONNECT APPLIANCE FROM ELECTRICAL POWER SOURCE BEFORE
PERFORMING ANY WORK.
•
DISCONNECT APLLIANCE FROM GAS SUPPLY BEFORE PERFORMING ANY
WORK.
Suggested Tools:
•
•
•
•
#2 Phillips screwdriver (Phillips bit mounted in a drill works best)
1/8” Allen hex wrench
5/32” Allen hex wrench (hex bit mounted in a drill works best)
5/8” box end wrench
Phillips Bit
5/32 Allen Hex Bit
Drill
Allen Hex Wrench
1/8” 5/32”
#2 Phillips Screwdriver
Ignition Unit (Ram)
1
4046070-IR
Remove Outer Casing
Disconnect power to the roaster.
Disconnect gas supply to the roaster.
•
Remove six (6) brass screws from
chrome top plate using Phillips
screwdriver.
•
Remove twelve (12) screws from ushape (6 per side) using Phillips screwdriver.
Remove two (2) screws to disconnect the control board.
The control board will not be removed from wiring harness.
Remove lift handle using a 1/8” Allen
hex wrench.
2
4046070-IR
•
•
Use a flat regular screwdriver to remove
the harness connector.
Turn ignition unit 90 deg counter
clockwise.
•
Remove two screws to free ignition
unit from the roaster.
Unplug spark cable from ignition
unit.
Pull unit straight out of roaster.
•
Replacement of the ignition unit is in the opposite order as removed.
•
Care should be taken to ensure that wiring harness is installed to ignition unit correctly.
•
Please call customer service if you need assistance 866-271-7666
3
4046070-IR
•
Install the u-shape by inserting the panel
into the lower extrusion starting on the
left side of the unit.
•
•
Reinstall twelve (12) screws to secure
u-shape using Phillips screwdriver. Do
Not Over tighten screws.
•
Ensure that top plate gasket is in
place and properly centered the
around brass bushings.
Reinstall top extrusion on to top
Top plate
•
Install two (2) screws to secure
control board to u-shape.
4
Gradually insert u-shape into bottom extrusion all the way around to
the right hand side.
Ensure that the u-shape is properly
seated.
Top Extru-
•
Install six (6) brass screws to secure chrome
top plate using Phillips screwdriver.
•
Install lift handle using a 1/8” Allen hex
wrench.. Ensure that fastener is seated to
hole in shaft.
4046070-IR
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement