JCM Gold CR-3800 - TerryTheTillman Home Page.

JCM Gold CR-3800 - TerryTheTillman Home Page.
MicroTech Confidential
GST Conversion Instructions
Conversion Instructions:
JCM Gold CR-3800
Make &
Model of Till:
JCM Gold CR-3800
JCM Gold
CR-3800
& CR-3815
Before you begin programming, you need to find the button on the keyboard that shifts the
GST on and off of a department. This key will be used to program the new GST rate. It may
be labeled as any one of the following:
"GST Shift", "Tax Shift 1", "Tax Shift 2"
You will also need to use the "Subtotal" key.
If you found both of these buttons, skip to the rate programming section below.
If you can not locate a "GST Shift" button on the keyboard, you will have to program one onto the
keyboard. You will need a service key for the mode lock. Choose one of the following buttons to
program the GST Shift overtop of, so that you can reprogram the original key back when you are done
programming the GST rate. The corresponding numbers listed below are used to program that key.
8= No Sale, 6= Ccustomer#, 17=Cheque, 20 = Refund, 25= R/A, 22= Void, 24 = Tax 2 Shift which is
your GST Shift Button. Note also if needed 23 = Tax 1 Shift
To program your GST Shift (Tax 2 shift) button, Insert the Service key in the mode lock and turn it one
click past "P" to the "SP" position. Enter the following key sequence: Press the double zero key, then
the "@/FOR" key, then 24 on the numeric keypad, then press a button on the keyboard you have
chosen for the "GST Shift" button, then press the "@/FOR" button to finish.
Skip to Rate Programming at this point and then program the old key back with the following key
sequence when your done programming the new GST rate.
To program the original key back in the position you placed the GST Shift key, follow the same
programming (Mode key to "SP", Press the double zero key, then the "@/FOR" key, then the old key
number from the list above, enter it on the numeric keypad, then press a button on the keyboard you
have chosen for the "GST Shift" button, then press the "@/FOR" button to finish.
Rate
Programming
Insert the "P" key in the mode lock and turn it to the programming position marked "P".
Enter the following key sequence:
1506000 "GST Shift" "Subtotal"
Turn the mode lock back to the Registration position and test your work.
A quick test now may save grief later.
If you have add-on taxes and advertise tax included prices, you will have to change any preprogrammed prices also.
TEST Your Work:
Mode key in the "Reg" position.
Press 1000
Press a Dept button with GST or both taxes allocated to it.
If GST only, total with taxes should be $10.60
If P&G, total with taxes should be $11.30
If all buttons are preset items, you should enter several sale items so that the total is $10.00
or more and finalise the sale before voiding so that you have a receipt to check the GST
calculation with a calculator.
MicroTech Confidential
Page 1
JCM Gold CR-3800
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement