GDS3710 package with 1 wiegand cable for wiegand Input/Output

GDS3710 package with 1 wiegand cable for wiegand Input/Output
GDS3710 Wiegand Connection & Wiring Diagrams ---- Wiegand Input
GDS3710 package with 1 wiegand cable for wiegand Input/Output connection.
The following diagram show how to connect the Wiegand output device.
Power for Wiegand
Device
V+
V‐
Power for GDS
GDS3710 (wiegand input)
IF board connector
J2
12V
GND
12V
GND
Wiegand output Device
Card reader GND
WG_D1_OUT
WG_D0_OUT
LED
WG_D1_IN
WG_D0_IN
BEEP
5V(Optional)
VCC
GND
LED
D1 output
D0 output
BEEPER
J4
Note:
Please make sure connect the GND of wiegand device and GDS wiegand port;
For wiegand input mode, LED and Beep need Wiegand device support the interface and function, these two pins will not affect the wiegand bus when not connected.
GDS3710 Wiegand Connection & Wiring Diagrams ---- Wiegand Input
Power for GDS & Wiegand
GDS3710 (wiegand input)
IF board connector
J2
12V
GND
12V
GND
Wiegand output Device
Card reader GND
WG_D1_OUT
WG_D0_OUT
LED
WG_D1_IN
WG_D0_IN
BEEP
5V(Optional)
VCC
GND
LED
D1 output
D0 output
BEEPER
J4
Note:
1. Please make sure connect the GND of wiegand device and GDS wiegand port;
2. GDS3710 with +5V(max 500mA) power supply as option for +5V wiegand device;
GDS3710 Wiegand Connection & Wiring Diagrams ---- Wiegand Output
The following diagram show how to set GDS as Wiegand output device.
Power for Wiegand
Device
Wiegand input Device
Door controller/Security System
V+
V‐
POWER SUPPLY
GDS3710 (wiegand output)
IF board connector
J2
12V
GND
12V
GND
VCC
GND
D1 input
D0 input
GND
WG_D1_OUT
WG_D0_OUT
LED
WG_D1_IN
WG_D0_IN
BEEP
5V(Optional)
J4
Note: For wiegand output mode, only three pins need connect WG_D0_OUT, WG_D1_OUT and GND.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising