Ducati Monster 696-1100
DUCATI MONSTER 696/1100
* The drawing is purely indicative
Original screw
A
SHOCK ABSORBER AB2 MOUNTING INSTRUCTION
Washer
B
Original screw
A
Original
exhaust
screws
D
Remote pipe
E
Original
exhaust
bracket
G
Reservoir bracket
C
Bracket screw and nut
F
Shock reservoir
H
Mounting instructions:
1. Remove the original shock absorber from the bike.
2. Remove the right exhaust silencer from the bike.
3. Remove the original seat, and remove all screws that secure the fuel tank.
4. Unscrew the 2 original exhaust screws “D”.
5. Install the Mupo shock absorber on the bike by passing the remote pipe “E” above the original exhaust
bracket “G” (see the picture).
6. Remove the original screw “A”, and fix the reservoir bracket “C” using the same original screw “A” plus
the washer “B” supplied.
7. Place the reservoir bracket “C” as shown in the picture and insert inside the shock reservoir “H”.
8. Fix the shock reservoir “H” using the bracket screw and nut “F”.
9. Tighten the 2 original exhaust screws “D”.
10. Tighten all the fuel tank screws and reassemble the original seat.
11. Reassemble the right exhaust silencer.
All of the operations of installation and dismounting, must be carried
out strictly by a specialised workshop.
Mupo cannot be held responsible for damage to products or persons
caused by incorrect installation or product tampering.
To install Mupo products, please follow the manufacturers
workshop manual instructions.
Before attempting to fit or remove any parts, protect the
motorcycle from possible damage.
MADE IN ITALY
Mupo Srl via dell’Artigianato 34, 40023 Castel Guelfo – Bologna (Italy) Tel. +390542671860 Fax. +390542671858 www.mupo.it – info@mupo.it
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising