ARTEX C406-1 Series - Aircraft Spruce Europe

ARTEX C406-1 Series - Aircraft Spruce Europe
ARTEX C406-1 Series
Single Output 406 MHz Emergency Locator Transmitter
(Type AF ELT) Cospas/Sarsat Approved,
FAA TSO C126 Approved, JTSO-2C126 Approved
The Artex C406-1 is a single output ELT; unlike previous models of Artex 406 MHz ELT’s. All 3 emergency frequencies
(121.5/243.0 and 406 MHz) utilize the same RF output, which requires only 1 coax cable to connect to the new series of
Artex single input antennas. The ELT automatically activates during a crash and transmits the standard swept tone on
121.5 and 243.0 MHz. Every 50 seconds for 520 milliseconds (long message protocol) the 406.025 MHz transmitter turns
on and transmits an encoded digital message to the Cospas/Sarsat satellite system. The ELT can be programmed with
the aircraft's 24-bit address as well as latitude/longitude information from the aircraft navigation system when used with
the Artex ELT/NAV Interface (P/N 453-6500). Also available is the Artex C406-1HM, which is equipped with a 6 axis "G"
Switch for helicopter installations. The mounting hardware for the C406-1 Series is compatible with all previous
versions of Artex 406 MHz ELT's.
SPECIFICATIONS:
Operating Frequencies:
406.025 MHz ± 2 kHz Biphase L (16K0G1D)
121.5 & 243.0 MHz ± 0.005% (A3X)
Output Power:
406 MHz: 5 W ± 2 dB (520 ms / 50 sec)
for 24 hours @ -20° C
121.5/243.0 MHz: 100 mW min (+20 dBm
for 50 hours @ -20° C)
Output connector:
BNC Female
Activation:
Automatic by 4.5 ft/sec G-Switch or Manual
Battery:
5 year Lithium (LiMnO2, solid cathode)
Temperature
Operating:
-20° C to +55° C
Storage:
-55° C to +85° C
Self Test:
G-Switch enabled
406 MHz Power
Antenna/Coax Connection
Position Data Present
Low Battery
Remote Control:
ON/OFF/RESET
Antenna:
Rod (110-338) (<450 KTS)
Whip (110-343) (<300 KTS)
Blade (110-340) (<600 KTS)
Mounting Hardware:
Mounting Tray P/N 452-5050
Protective Top Cover P/N 452-3052
End Cap P/N 452-5052
Other Parts:
Coax cable
Buzzer (to alert ground crews of accidental activation)
Weights:
ELT Transmitter: 3 LB 5.8 oz Max (1.53 Kg)
Mounting Tray: 7 oz (200 g)
Protective Top Cover: 6.7 oz (190 g)
End Cap: 3.8 oz (108 g)
Total Weight: 2.02 Kg
Measurements:
ELT Transmitter with Mounting Hardware Installed:
11.74" (298mm) L x 3.90" (99mm) H x 3.82"( 97mm)
W
Part Numbers:
C406-1: 453-5002 (Transmitter Only)
C406-1HM: 453-5003 (Transmitter Only)
Artex reserves the right to alter or modify any of the above specifications
C406-1 System
ELT OUTLINE DRAWING
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising