GS3060 PCB Replacement Guide
GS3060 PCB Replacement Guide
These instructions must be used in conjunction with the GS3060 Installation Manual;
Observe all the specified safety precautions during the board replacement.
NOTE: The GS3060 PCB must be replaced by service persons only.
Completely power down the GS3060 by removing power to the +12V input terminal and disconnect the battery leads (red and black wires).
2. Disconnect the telecommunications network wiring and any connection to the
other terminals.
3. Carefully disconnect the GSM antenna from the GSM radio module on the
GS3060. To remove the cable from the radio module, insert a small, flat head
screwdriver between the cable and the radio module then gently pry the plug
NOTE: Any other method for removal of the antenna may cause permanent damage to the on-board connector.
The GS3060 PCB is secured by 4 plastic standoffs located at the four corners of
the board. Carefully squeeze the top of each standoff so that you can release the
PCB from the standoff, needle nose pliers are recommended.
If you break the standoff you will have to remove the cabinet from the wall to
remove the broken standoff. Extra standoffs are provided with the replacement
Once the old PCB is removed from the cabinet, carefully remove the SIM card
from the PCB. Slide the SIM card holder to the left, in the direction labeled
"OPEN" on the SIM card holder.
Insert the SIM card into the replacement PCB. The notch on the SIM card should
face towards the LEDs. Once the card is properly seated in the connector, press
down and slide it into the "LOCK" position as indicated on the SIM card holder.
Reconnect all the wiring to the terminals, except power (i.e., do not attach the
battery or apply power to the +12V terminal).
Perform a hardware default to force the unit to get the latest configuration:
Make sure the unit is still powered down.
Place a wire (i.e., short) between the PGM1 and Input 1 (i.e., Z1) terminals on the GS3060.
• Connect the battery first then apply power to the +12V input terminal.
This performs a hardware default and requests the configuration from
Connect 24.
• Wait at least 10 seconds before removing the wire between PGM1 and
Input 1.
NOTE: A Hardware default must be performed when the SIM card is being
The red and yellow LEDs will flash indicating the unit is establishing a connection to
get its programming from the network, this may take several minutes. Please refer to
the GS3060 Installation Manual if the red LED starts to flash on its own.
© 2010 Digital Security Controls
Printed in Canada
2 9 0 0 7 4 5 1 R0 0 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF