BPS 24V Power Converter for ResMed AirSense/AirCurve 10 Series

BPS 24V Power Converter for ResMed AirSense/AirCurve 10 Series
BPS 24V Power Converter for ResMed AirSense/AirCurve 10 Series Devices
INTRODUCTION
ResMed AirSense/AirCurve 10 Series devices operate from 24V direct
current and the CPAP Battery operates from 12V direct current; therefore,
the use of a power converter or power inverter is required in order for the
CPAP Battery to power the device.
PAP DC INPUT PORT

Battery Power Solutions’ 24V Power Converter was specifically designed
for use with ResMed AirSense/AirCurve 10 Series PAP devices and the
C-100 CPAP Battery. This single component connection provides a clean,
efficient conversion from 12V to 24V direct current.
SPECIFICATIONS

Input: 12V DC
Output: 24V/3.75A (maximum)
Length: 6.5 ft (connector to connector)
Weight: 0.4 lbs
24V POWER
CONVERTER
DC OUT JACK
CONNECTION INSTRUCTIONS

Insert the 24V power converter into the DC out jack of the Battery.
Dual Battery Configuration:




Insert the DC power pigtail cord that is included with the CPAP
Battery Kit into the DC out jacks of both Batteries.
Connect the 24V power converter to the female end of the DC
power pigtail cord.

Insert the 24V power converter into the DC input port of the ResMed
AirSense/AirCurve 10 Series device.

Turn on the PAP device and it should begin functioning.
NOTES

The power converter must be connected to the CPAP Battery before it
is connected to the ResMed AirSense/AirCurve 10 Series device.

ResMed’s DC/DC Converter or a sine wave power inverter may also be
used to complete the connection between the AirSense/AirCurve 10
Series PAP device and the C-100 CPAP Battery.
BATTERY POWER SOLUTIONS
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising