Startup Guide

Startup Guide
Startup Guide
The continued success of your business depends on being able to restore
your servers to its full capacity quickly. This backup solution gives you fast
local access to critical files that reduces downtime in the event of a disaster.
IDrive BMR is an onsite disk image backup/restore solution. With this,
you can perform full, incremental and manual backup of a computer
including multiple hard drives and partitions. The backed up data is saved
in the form of a single file (known as an Image) onsite. You can maintain
a ready-to-use, bare-metal restore (BMR) capability with each file-based
backup. This advanced solution lets you restore backed up data to multiple
computers at the same time.
Bare metal restore and full hard disk imaging makes you rest easy knowing
that in the event of data loss you are protected. You can restore your entire
system along with all its settings at once. No need for rearranging data,
reinstalling software or reconfiguring any system or application settings.
Before Getting Started
The following equipments are required to use IDrive BMR:
• IDrive BMR server and AC power cable (included in the package)
• Ethernet cable with RJ45 connector (not included in the package)
Physical Installation
1 Unpacking and Inspecting
Upon receiving the shipment, unbox and inspect the IDrive BMR
server and other hardware for any physical damage that may have
occurred during shipping.
Each shipment/package contains the following:
• IDrive BMR server
• Rack mounting kit
• AC power cable
• Product information guide
2 Installing into the Rack
Follow the racking guide from the below link to properly mount the
Rack mounting the server
3 Setting up IDrive BMR server
• Connect the power cable and the Ethernet cable to any of the RJ45 connectors at the back of the device to your network
• Connect a monitor to the server and press the power button at
the front panel to start the server.
• The Dashboard will be displayed automatically on the monitor
after the server is started.
• To access the web interface, perform any of the following:
• Click the Login link displayed on the top-right corner of the Dashboard.
• Browse the local IP address shown on the Dashboard from the same local network.
Note: if you are unable to view the IP address on the dashboard, press Refresh button next to the IP address to get the device IP.
• Use 'support123' as password for initial login. Ensure you change
the default password from the ‘Settings’ tab after initial login to
the web interface.
Network Settings
Following network ports are to be used for IDrive BMR server and client
For IDrive BMR server
HTTP web interface
UDP broadcast for discovery
For client devices
UDP broadcasts for discovery
Commands and image backups
What's Next?
After the initial setup, you can now Backup your machines.
Important note:
Ensure weekly inspection of your BMR appliances by logging into the admin
console, to check the backup and hard drive status of the device. Blinking green
light on the device indicates that the drives are working fine. Amber light or no
light indicates an issue with the drives.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF