BOOST® Technology
BOOST® Technology
Autoscrubbers®
BOOST® Technology – Cleans Into Corners Where Others Can’t
For years, the most productive way to clean and maintain
smooth tile or concrete floors was with a disc automatic
scrubber. Depending on the size of the scrub path, there could
be dual counter-rotating pads or brushes. Operating at 200300 rpm, and requiring an increased pad pressure, acceptable
results are achieved by a disc scrubber.
An integral part of BOOST Technology is the utilization of a
rectangular pad that provides consistent contact across the
cleaning path. Whether on a floor machine or autoscrubber, the
BOOST pad provides more contact area of the pad on the floor
surface, cleaning more uniformly and more consistently than
disc scrubbing. The rectangular shape to the BOOST scrub
head allows for the operator to clean immediately along the
edge of baseboards, as well as in corners.
Trusted. Reliable. Efficient.
• Allows chemical-free floor
finish removal
•Multi application technology cleans floors, removes floor finish,
and wet screens gym floors
•50-70% less solution consumption
•25% increase in battery run times
and 40% increase in pad life
•Available on most Clarke
autoscrubbers
M
by ulti-D
BO
O S irecti
TO
o
rbi nalS
tal c
Pad
On
eW
Con ay D i
ven rect
tio ion
nal alS
D is cru
b
cM
ach bing
ine of
s
O ne W ay DirectionalScrubbing of
O ne W ay Di
rectional
Scr
ubbi
ng of
Convent
ional
Di
sc M achi
nes
ConventionalDisc M achines
OOne
neWWay
ayDi
Di
rr
ect
ect
ii
onal
onalScr
Scrubbi
ubbi
ng
ngof
of
Convent
ii
onal
sc
nes
Convent
onalDi
Di
scMMachi
achi
nes
M ulti-DirectionalScrubbing
Mby
ulBO
ti-Di
rect
ng
O ST
Oi
ronal
bitalScr
Padubbi
Scrubber
by BO O ST O rbitalPad Scrubber
ul
Di
ect
onalScr
Scrubbi
ubbi
ng
MMul
tt
ii
-Di
rr
ect
ii
onal
ng
by
byBO
BOOOST
STOOrrbi
bi
tt
al
alPad
PadScr
Scrubber
ubber
Reduces Water & Chemical Consumption
Using BOOST® Technology, cleaning solution is introduced in front of the rectangular
scrubbing pad with Clarke’s patented Pulse Modulated Solution Control. The orbital
action contains the cleaning solution in the pad and carries it for the full length of
the pad. Compared to traditional disc scrubbers that sling water away from the pad,
BOOST’s efficient use of the cleaning solution results in water and chemical savings of
50% to 70%.
Using less water during cleaning keeps the operator working productively rather than in
the janitor’s closet emptying and refilling the scrubber tanks.
Decreases Strip and Recoat Cycles
Cleaner floors allow for more effective burnishing. Dirt left behind by traditional disc scrubbers is often burnished into the finish,
resulting in a yellowing of the finish. With more effective cleaning AND burnishing, the time between labor-intensive strip-andrecoats can be extended, which means less money spent on floor stripping, finishing, and labor.
Watch BOOST in action at:
www.youtube.com
Search: Clarke BOOST
Strip Your Floors Chemical-Free
Save the money and just use water! That’s all you need to remove floor finish. Just put on a maroon pad, fill the tank with clean water and
reduce your speed. Using only water also reduces the chance for slip and falls, leaves no fumes and keeps floors dry, safe, and ready for
recoating. Imagine the savings you will see in chemicals alone! BOOST® Technology is not only excellent for removing floor finish, but is also
great for evenly deep scrubbing floors.
Chemical-free removal of floor finish with BOOST is ideal for use in education and healthcare facilities when air quality and open
building areas are critical!
Reduces Floor Pad Consumption
Because BOOST® Technology cleans at orbits 10 times that of a conventional scrubber and
attacks dirt from multiple directions, less pad pressure is required to achieve the desired
cleaning result. With the combination of high RPM orbital action and reduced pad pressure,
the life of your floor pads is extended by up to 40%!
Just think about this. An average 40-store grocery store chain in the Midwest that spends
$30,000 in floor pads a year will now save over $12,000 per year in pad costs, just by
implementing Clarke’s BOOST® Technology cleaning method.
Increases Efficiency and Battery Runtimes
With conventional disc floor scrubbers, as much as 30% of an operator’s time during a shift is spent emptying the recovery tank and refilling
the solution tank. Since these disc scrubbers can use twice the amount of solution, more dump and fills are required during a cleaning shift.
With BOOST®, you’ll experience a 15 to 20 minute labor savings for each dump and refill that’s
eliminated. The BOOST’s unique pad shape also allows for close-edge cleaning without overspray,
virtually eliminating additional labor steps in cleaning operations.
The reduced water usage coupled with the reduced pad pressure enables the BOOST® machine to utilize
the motors and battery pack more efficiently, which translates into an increased run time of up to 25%
compared to similar disc scrubbers! By using BOOST® you can reduce the cost of battery replacement
and reduce the environmental impact of battery recycling.
Wet Screen Your Gym Floors
After you are done scrubbing and removing floor finish, use BOOST®
Technology Scrubbers to wet screen your gym floors!
Wet screening cleans and preps the gym floor surface for lasting adhesion
of a new coating. The high speed orbital action and minimal solution usage
coupled with fast and immediate solution pickup is the most productive tool
in achieving the highest quality gym floor surface.
SPECIFICATIONS
Part Number
FM40™ ST
FM40™ LX
Focus® II
Focus® II
Focus® II
Focus® II
Floor Machine Floor Machine Compact L20 Mid Size 28 Mid Size 32 MicroRider™
56105618
Cleaning Brush/
Pad Size
556105620
14 in x 20 in (35.6 cm x 50.8 cm)
Brush/Pad Speed
Brush/Pad Pressure
Focus®
Rider 28
see price book
see price book
see price book
see price book
see price book
20 in (50.8 cm)
28 in (71 cm)
32 in (81.3 cm)
28 in (71 cm)
28 in (71 cm)
3,540 RPM
3,540 RPM
2,250 RPM
2,250 RPM
2,250 RPM
2,250 RPM
2,250 RPM
90 lb w/out
weights &161 lb
w/weights
106 &164 lb
40 & 75 lb
(18 & 34 kg)
65 & 125 lb
(29.5 & 56.7 kg)
95 & 150 lb
(43 & 68 kg)
65 & 105 lb
(30 & 48 kg)
90, 120, 150 lb
(39, 54, 68 kg)
Power Source
Electric
Scrubbing Flow Rate
Manual
Your choice of wet or AGM batteries
0.1 gal/min
Pad Life
0.12 gal/min
0.12 gal/min
0 - 0.8 gal/min
0.2, 0.4, 0.6 gal/min
40% longer than disc scrubbers
Finish Removal
@ 60 ft/Minute
2200
2200
6,000
8,400
9,500
8,400
8,400
Scrubbing/Hour, ft2
6600
6600
20,000
28,000
32,000
45,500
38,500
Specifications are subject to change without notice.
*Per ISSA 540 cleaning times.
What makes BOOST® Technology
Green?
• Sustainable & recyclable
machine parts
• Replacement Squeegee Blade Kits
•Uses up to 50-70% less water
& chemicals than conventional
scrubbers
• Cleans multiple floor types, reducing
the need for additional equipment
or additional cleaning processes
• Off-aisle Wand Kit (Focus Mid Size 32,
Focus II Rider)
•AGM batteries on all autoscrubbers
(optional)
Options available on
autoscrubbers?
• Ergonomically designed machines
•Clarke® Battery Maintenance
System
•Safety features on every scrubber
and floor machine
• Hour Meter Kit
See machine product brochure for more
detailed specifications and optional features.
• Full line of BOOST® Pads
Watch BOOST in action at: www.youtube.com
Search: Clarke BOOST
©2016 Nilfisk, Inc. All rights reserved. P/N 71090A 1-16
• Chemical Mixing System Kit
9435 Winnetka Avenue North • Brooklyn Park, MN 55445
Phone: 800.253.0367 • Fax: 800.825.2753
240 Superior Boulevard • Mississauga, Ontario, Canada L5T 2L2
Phone: 800.668.8400 • Fax: 800.263.5111
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising