GRS Tools • HandWorker • Accu
P.O. Box 1153
900 Overlander Road
Emporia, KS 66801 USA
Phone: 620-343-1084 • Fax: 620-343-9640 • E-mail: glendo@glendo.com
www.glendo.com • www.grstools.com • www.accu-finish.com • www.handworker.com
ACCU-FINISH II CABINET MOUNTING PLATE ASSEMBLY
This mounting kit lets you mount the Accu-Finish Series II cabinet to a heavy steel
plate instead of bolting it to the floor.
There are five each 3/8" - 16 UNC tapped holes in the mounting plate. Four of them
are in an obvious rectangular pattern. Place the mounting plate on the floor so that
the extra (fifth) 3/8" - 16 UNC hole is towards the back. Next, place the cabinet on
the mounting plate, aligning the cabinet holes with the four rectangularly spaced
3/8" -16 UNC holes on the mounting plate. Bolt the cabinet to the mounting plate
using four 3/8" x 5/8" long hex bolts and the 3/8" flat washers.
The #10 - 32 x 1" long machine screws and #10 - 32 nuts are for leveling your
cabinet on the floor using the four tapped #10 - 32 holes in each corner of the
mounting plate. First, fully install a #10 - 32 nut on each #10 - 32 screw. Then,
insert the screws with nuts through the top of the mounting plate using the four
tapped holes in each corner. Now, adjust the depth of each screw to level your
cabinet. Finally, lock the #10-32 screws in plate using the nuts.
For any questions or comments concerning this product, please call or fax.
Thank you for your business!
Glendo Corporation
GRS Tools • HandWorker • Accu-Finish
Last Updated: Nov. 30, 2012
011-164
FRONT OF CABINET (DOOR SIDE)
MOUNTING PLATE LEVELERS
10-32 MACHINE SCREWS (4)
W/JAM NUTS
CABINET MOUNTING BOLTS
3/8-16 X 5/8” HHB (4)
W/ WASHERS
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising